104 research outputs found
Multimedia congestion control: circuit breakers for unicast RTP sessions
The Real-time Transport Protocol (RTP) is widely used in telephony, video conferencing, and telepresence applications. Such applications are often run on best-effort UDP/IP networks. If congestion control is not implemented in these applications, then network congestion can lead to uncontrolled packet loss and a resulting deterioration of the user's multimedia experience. The congestion control algorithm acts as a safety measure by stopping RTP flows from using excessive resources and protecting the network from overload. At the time of this writing, however, while there are several proprietary solutions, there is no standard algorithm for congestion control of interactive RTP flows. This document does not propose a congestion control algorithm. It instead defines a minimal set of RTP circuit breakers: conditions under which an RTP sender needs to stop transmitting media data to protect the network from excessive congestion. It is expected that, in the absence of long-lived excessive congestion, RTP applications running on best-effort IP networks will be able to operate without triggering these circuit breakers. To avoid triggering the RTP circuit breaker, any Standards Track congestion control algorithms defined for RTP will need to operate within the envelope set by these RTP circuit breaker algorithms
System Support for Bandwidth Management and Content Adaptation in Internet Applications
This paper describes the implementation and evaluation of an operating system
module, the Congestion Manager (CM), which provides integrated network flow
management and exports a convenient programming interface that allows
applications to be notified of, and adapt to, changing network conditions. We
describe the API by which applications interface with the CM, and the
architectural considerations that factored into the design. To evaluate the
architecture and API, we describe our implementations of TCP; a streaming
layered audio/video application; and an interactive audio application using the
CM, and show that they achieve adaptive behavior without incurring much
end-system overhead. All flows including TCP benefit from the sharing of
congestion information, and applications are able to incorporate new
functionality such as congestion control and adaptive behavior.Comment: 14 pages, appeared in OSDI 200
Network emulation focusing on QoS-Oriented satellite communication
This chapter proposes network emulation basics and a complete case study of QoS-oriented Satellite Communication
Reducing Internet Latency : A Survey of Techniques and their Merit
Bob Briscoe, Anna Brunstrom, Andreas Petlund, David Hayes, David Ros, Ing-Jyh Tsang, Stein Gjessing, Gorry Fairhurst, Carsten Griwodz, Michael WelzlPeer reviewedPreprin
Recommended from our members
Measurement-Driven Algorithm and System Design for Wireless and Datacenter Networks
The growing number of mobile devices and data-intensive applications pose unique challenges for wireless access networks as well as datacenter networks that enable modern cloud-based services. With the enormous increase in volume and complexity of traffic from applications such as video streaming and cloud computing, the interconnection networks have become a major performance bottleneck. In this thesis, we study algorithms and architectures spanning several layers of the networking protocol stack that enable and accelerate novel applications and that are easily deployable and scalable. The design of these algorithms and architectures is motivated by measurements and observations in real world or experimental testbeds.
In the first part of this thesis, we address the challenge of wireless content delivery in crowded areas. We present the AMuSe system, whose objective is to enable scalable and adaptive WiFi multicast. AMuSe is based on accurate receiver feedback and incurs a small control overhead. This feedback information can be used by the multicast sender to optimize multicast service quality, e.g., by dynamically adjusting transmission bitrate. Specifically, we develop an algorithm for dynamic selection of a subset of the multicast receivers as feedback nodes which periodically send information about the channel quality to the multicast sender. Further, we describe the Multicast Dynamic Rate Adaptation (MuDRA) algorithm that utilizes AMuSe's feedback to optimally tune the physical layer multicast rate. MuDRA balances fast adaptation to channel conditions and stability, which is essential for multimedia applications.
We implemented the AMuSe system on the ORBIT testbed and evaluated its performance in large groups with approximately 200 WiFi nodes. Our extensive experiments demonstrate that AMuSe can provide accurate feedback in a dense multicast environment. It outperforms several alternatives even in the case of external interference and changing network conditions. Further, our experimental evaluation of MuDRA on the ORBIT testbed shows that MuDRA outperforms other schemes and supports high throughput multicast flows to hundreds of nodes while meeting quality requirements. As an example application, MuDRA can support multiple high quality video streams, where 90% of the nodes report excellent or very good video quality.
Next, we specifically focus on ensuring high Quality of Experience (QoE) for video streaming over WiFi multicast. We formulate the problem of joint adaptation of multicast transmission rate and video rate for ensuring high video QoE as a utility maximization problem and propose an online control algorithm called DYVR which is based on Lyapunov optimization techniques. We evaluated the performance of DYVR through analysis, simulations, and experiments using a testbed composed of Android devices and o the shelf APs. Our evaluation shows that DYVR can ensure high video rates while guaranteeing a low but acceptable number of segment losses, buffer underflows, and video rate switches.
We leverage the lessons learnt from AMuSe for WiFi to address the performance issues with LTE evolved Multimedia Broadcast/Multicast Service (eMBMS). We present the Dynamic Monitoring (DyMo) system which provides low-overhead and real-time feedback about eMBMS performance. DyMo employs eMBMS for broadcasting instructions which indicate the reporting rates as a function of the observed Quality of Service (QoS) for each UE. This simple feedback mechanism collects very limited QoS reports which can be used for network optimization. We evaluated the performance of DyMo analytically and via simulations. DyMo infers the optimal eMBMS settings with extremely low overhead, while meeting strict QoS requirements under different UE mobility patterns and presence of network component failures.
In the second part of the thesis, we study datacenter networks which are key enablers of the end-user applications such as video streaming and storage. Datacenter applications such as distributed file systems, one-to-many virtual machine migrations, and large-scale data processing involve bulk multicast flows. We propose a hardware and software system for enabling physical layer optical multicast in datacenter networks using passive optical splitters. We built a prototype and developed a simulation environment to evaluate the performance of the system for bulk multicasting. Our evaluation shows that the optical multicast architecture can achieve higher throughput and lower latency than IP multicast and peer-to-peer multicast schemes with lower switching energy consumption.
Finally, we study the problem of congestion control in datacenter networks. Quantized Congestion Control (QCN), a switch-supported standard, utilizes direct multi-bit feedback from the network for hardware rate limiting. Although QCN has been shown to be fast-reacting and effective, being a Layer-2 technology limits its adoption in IP-routed Layer 3 datacenters. We address several design challenges to overcome QCN feedback's Layer- 2 limitation and use it to design window-based congestion control (QCN-CC) and load balancing (QCN-LB) schemes. Our extensive simulations, based on real world workloads, demonstrate the advantages of explicit, multi-bit congestion feedback, especially in a typical environment where intra-datacenter traffic with short Round Trip Times (RTT: tens of s) run in conjunction with web-facing traffic with long RTTs (tens of milliseconds)
Quality of service and resource management in IP and wireless networks
A common theme in the publications included in this thesis is the quality of service and resource management in IP and wireless networks. This thesis presents novel algorithms and implementations for admission control in IP and IEEE 802.16e networks, active queue management in EGPRS, WCDMA, and IEEE 802.16e networks, and scheduling in IEEE 802.16e networks. The performance of different algorithms and mechanisms is compared with the prior art through extensive ns-2 simulations.
We show that similar active queue management mechanisms, such as TTLRED, can be successfully used to reduce the downlink delay (and in some cases even improve the TCP goodput) in different bottlenecks of IP, EGPRS, WCDMA, and IEEE 802.16e access networks. Moreover, almost identical connection admission control algorithms can be applied both in IP access networks and at IEEE 802.16e base stations. In the former case, one just has to first gather the link load information from the IP routers.
We also note that DiffServ can be used to avoid costly overprovisioning of the backhaul in IEEE 802.16e networks. We present a simple mapping between IEEE 802.16e data delivery services and DiffServ traffic classes, and we propose that IEEE 802.16e base stations should take the backhaul traffic load into account in their admission control decisions.
Moreover, different IEEE 802.16e base station scheduling algorithms and uplink channel access mechanisms are studied. In the former study, we show that proportional fair scheduling offers superior spectral efficiency when compared to deficit round-robin, though in some cases at the cost of increased delay. Additionally, we introduce a variant of deficit round-robin (WDRR), where the quantum value depends on the modulation and coding scheme.
We also show that there are several ways to implement ertPS in an efficient manner, so that during the silence periods of a VoIP call no uplink slots are granted. The problem here, however, is how to implement the resumption after the silence period while introducing as little delay as possible
- …