64 research outputs found
Joint optimization of transceivers with fractionally spaced equalizers
In this paper we propose a method for joint optimization of transceivers with fractionally spaced equalization (FSE). We use the effective single-input multiple-output (SIMO) model for the fractionally spaced receiver. Since the FSE is used at the receiver, the optimized precoding scheme should be changed correspondingly. Simulation shows that the proposed method demonstrates remarkable improvement for jointly optimal linear transceivers as well as transceivers with decision feedback
Fractional biorthogonal partners in channel equalization and signal interpolation
The concept of biorthogonal partners has been introduced recently by the authors. The work presented here is an extension of some of these results to the case where the upsampling and downsampling ratios are not integers but rational numbers, hence, the name fractional biorthogonal partners. The conditions for the existence of stable and of finite impulse response (FIR) fractional biorthogonal partners are derived. It is also shown that the FIR solutions (when they exist) are not unique. This property is further explored in one of the applications of fractional biorthogonal partners, namely, the fractionally spaced equalization in digital communications. The goal is to construct zero-forcing equalizers (ZFEs) that also combat the channel noise. The performance of these equalizers is assessed through computer simulations. Another application considered is the all-FIR interpolation technique with the minimum amount of oversampling required in the input signal. We also consider the extension of the least squares approximation problem to the setting of fractional biorthogonal partners
Equalization with oversampling in multiuser CDMA systems
Some of the major challenges in the design of new-generation wireless mobile systems are the suppression of multiuser interference (MUI) and inter-symbol interference (ISI) within a single user created by the multipath propagation. Both of these problems were addressed successfully in a recent design of A Mutually Orthogonal Usercode-Receiver (AMOUR) for asynchronous or quasisynchronous code division multiple access (CDMA) systems. AMOUR converts a multiuser CDMA system into parallel single-user systems regardless of the multipath and guarantees ISI mitigation, irrespective of the channel locations. However, the noise amplification at the receiver can be significant in some multipath channels. In this paper, we propose to oversample the received signal as a way of improving the performance of AMOUR systems. We design Fractionally Spaced AMOUR (FSAMOUR) receivers with integral and rational amounts of oversampling and compare their performance with the conventional method. An important point that is often overlooked in the design of zero-forcing channel equalizers is that sometimes, they are not unique. This becomes especially significant in multiuser applications where, as we will show, the nonuniqueness is practically guaranteed. We exploit this flexibility in the design of AMOUR and FSAMOUR receivers and achieve noticeable improvements in performance
Recommended from our members
Channel equalization to achieve high bit rates in discrete multitone systems
textMulticarrier modulation (MCM) techniques such as orthogonal frequency division
multiplexing (OFDM) and discrete multi-tone (DMT) modulation are attractive
for high-speed data communications due to the ease with which MCM can combat
channel dispersion. With all the benefits MCM could give, DMT modulation has an
extra ability to perform dynamic bit loading, which has the potential to exploit fully
the available bandwidth in a slowly time-varying channel. In broadband wireline
communications, DMT modulation is standardized for asymmetric digital subscribe
line (ADSL) and very-high-bit-rate digital subscriber line (VDSL) modems. ADSL
and VDSL standards are used by telephone companies to provide high speed data
service to residences and offices.
In an ADSL receiver, an equalizer is required to compensate for the channel’s
dispersion in the time domain and the channel’s distortion in the frequency domain
of the transmitted waveform. This dissertation proposes design methods for linear
equalizers to increase the bit rate of the connection. The methods are amenable
to implementation on programmable fixed-point digital signal processors, which are
employed in ADSL/VDSL transceivers.
A conventional ADSL equalizer consists of a time-domain equalizer, a fast
Fourier transform, and a frequency domain equalizer. The time domain equalizer
(TEQ) is a finite impulse response filter that when coupled with a discretized channel
produces an equivalent channel whose impulse response is shorter than that of
the discretized channel. This channel shortening is required by the ADSL standards.
In this dissertation, I first propose a linear phase TEQ design that exploits symmetry
in existing eigen-filter approaches such as minimum mean square error(MMSE),
maximum shortening signal to noise ratio (MSSNR) and minimum intersymbol interference
(Min-ISI) equalizers. TEQs with symmetric coefficients can reach the
same performance as non-symmetric ones with much lower training complexity.
Second, I improve Min-ISI design. I reformulate the cost function to make
long TEQs design feasible. I remove the dependency of transmission delay in order
to reduce the complexity associated with delay optimization. The quantized
weighting is introduced to further lower the complexity. I also propose an iterative
optimization procedure of Min-ISI that completely avoids Cholesky decomposition
hence is better suited for a fixed-point implementation.
Finally I propose a dual-path TEQ structure, which designs a standard singleFIR
TEQ to achieve good bit rate over the entire transmission bandwidth, and
designs another FIR TEQ to improve the bit rate over a subset of subcarriers. Dualpath
TEQ can be viewed as a special case of a complex valued filter bank structure
that delivers the best bit rate of existing DMT equalizers. However, dual-path
TEQ provides a very good tradeoff between achievable bit rate vs. implementation
complexity on a programmable digital signal processor.Electrical and Computer Engineerin
Doctor of Philosophy
dissertationThe demand for high speed communication has been increasing in the past two decades. Multicarrier communication technology has been suggested to address this demand. Orthogonal frequency-division multiplexing (OFDM) is the most widely used multicarrier technique. However, OFDM has a number of disadvantages in time-varying channels, multiple access, and cognitive radios. On the other hand, filterbank multicarrier (FBMC) communication has been suggested as an alternative to OFDM that can overcome the disadvantages of OFDM. In this dissertation, we investigate the application of filtered multitone (FMT), a subset of FBMC modulation methods, to slow fading and fast fading channels. We investigate the FMT transmitter and receiver in continuous and discrete time domains. An efficient implementation of FMT systems is derived and the conditions for perfect reconstruction in an FBMC communication system are presented. We derive equations for FMT in slow fading channels that allow evaluation of FMT when applied to mobile wireless communication systems. We consider using fractionally spaced per tone channel equalizers with different number of taps. The numerical results are presented to investigate the performance of these equalizers. The numerical results show that single-tap equalizers suffice for typical wireless channels. The equalizer design study is advanced by introducing adaptive equalizers which use channel estimation. We derive equations for a minimum mean square error (MMSE) channel estimator and improve the channel estimation by considering the finite duration of channel impulse response. The results of optimum equalizers (when channel is known perfectly) are compared with those of the adaptive equalizers, and it is found that a loss of 1 dB or less incurs. We also introduce a new form of FMT which is specially designed to handle doubly dispersive channels. This method is called FMT-dd (FMT for doubly dispersive channels). The proposed FMT-dd is applied to two common methods of data symbol orientation in the time-frequency space grid; namely, rectangular and hexagonal lattices. The performance of these methods along with OFDM and the conventional FMT are compared and a significant improvement in performance is observed. The FMT-dd design is applied to real-world underwater acoustic (UWA) communication channels. The experimental results from an at-sea experiment (ACOMM10) show that this new design provides a significant gain over OFDM. The feasibility of implementing a MIMO system for multicarrier UWA communication channels is studied through computer simulations. Our study emphasizes the bandwidth efficiency of multicarrier MIMO communications .We show that the value of MIMO to UWA communication is very limited
Estimation and detection techniques for doubly-selective channels in wireless communications
A fundamental problem in communications is the estimation of the channel.
The signal transmitted through a communications channel undergoes distortions
so that it is often received in an unrecognizable form at the receiver.
The receiver must expend significant signal processing effort in order to be
able to decode the transmit signal from this received signal. This signal processing
requires knowledge of how the channel distorts the transmit signal,
i.e. channel knowledge. To maintain a reliable link, the channel must be
estimated and tracked by the receiver.
The estimation of the channel at the receiver often proceeds by transmission
of a signal called the 'pilot' which is known a priori to the receiver.
The receiver forms its estimate of the transmitted signal based on how this
known signal is distorted by the channel, i.e. it estimates the channel from
the received signal and the pilot. This design of the pilot is a function of the
modulation, the type of training and the channel. [Continues.
- …