Signal and System Design for Wireless Power Transfer : Prototype, Experiment and Validation

A new line of research on communications and signals design for Wireless Power Transfer (WPT) has recently emerged in the communication literature. Promising signal strategies to maximize the power transfer efficiency of WPT rely on (energy) beamforming, waveform, modulation and transmit diversity, and a combination thereof. To a great extent, the study of those strategies has so far been limited to theoretical performance analysis. In this paper, we study the real over-the-air performance of all the aforementioned signal strategies for WPT. To that end, we have designed, prototyped and experimented an innovative radiative WPT architecture based on Software-Defined Radio (SDR) that can operate in open-loop and closed-loop (with channel acquisition at the transmitter) modes. The prototype consists of three important blocks, namely the channel estimator, the signal generator, and the energy harvester. The experiments have been conducted in a variety of deployments, including frequency flat and frequency selective channels, under static and mobility conditions. Experiments highlight that a channeladaptive WPT architecture based on joint beamforming and waveform design offers significant performance improvements in harvested DC power over conventional single-antenna/multiantenna continuous wave systems. The experimental results fully validate the observations predicted from the theoretical signal designs and confirm the crucial and beneficial role played by the energy harvester nonlinearity.Comment: Accepted to IEEE Transactions on Wireless Communication

Performance analysis of power-splitting relaying protocol in SWIPT based cooperative NOMA systems

This paper investigates a relay assisted simultaneous wireless information and power transfer (SWIPT) for downlink in cellular systems. Cooperative non-orthogonal multiple access (C-NOMA) is employed along with power splitting protocol to enable both energy harvesting (EH) and information processing (IP). A downlink model consists of a base station (BS) and two users is considered, in which the near user (NU) is selected as a relay to forward the received signal from the BS to the far user (FU). Maximum ratio combining is then employed at the FU to combine both the signals received from the BS and NU. Closed form expressions of outage probability, throughput, ergodic rate and energy efficiency (EE) are firstly derived for the SWIPT based C-NOMA considering both scenarios of with and without direct link between the BS and FU. The impacts of EH time, EH efficiency, power-splitting ratio, source data rate and distance between different nodes on the performance are then investigated. The simulation results show that the C-NOMA with direct link achieves an outperformed performance over C-NOMA without direct link. Moreover, the performance of C-NOMA with direct link is also higher than that for OMA. Specifically, (1) the outage probability for C-NOMA in both direct and relaying link cases is always lower than that for OMA. (2) the outage probability, throughput and ergodic rate vary according to β, (3) the EE of both users can obtain in SNR range of from -10 to 5 dB and it decreases linearly as SNR increases. Numerical results are provided to verify the findings

Simultaneous wireless information and power transfer in full-duplex communication systems

As wireless devices are mostly constrained by their inability to operate independently infinitely away from centralised power sources, radio frequency (RF) energy harvesting (EH) has been identified as a promising technique for future wireless devices. For this reason, this thesis introduces a novelty in RF EH full-duplex (FD) wireless communication systems. Specifically, this thesis investigate the potentials of simultaneous wireless information and power transfer (SWIPT) in FD communication systems. This thesis firstly focuses on optimal transmit strategies, rate maximization and power minimizing approach for SWIPT in FD systems. Using the rate-split method, difference of convex programming, semi-definite programming technique and one-dimensional search, we reformulate complex optimization problems to yield problem formulations that can be efficiently solved, thus we develop rate maximization algorithm for SWIPT in a point-to-point FD system, SWIPT in FD multiple-input multiple-output (MIMO) two-way relay system and power minimization approach for SWIPT in a multiuser MIMO FD system. This thesis also presents research work carried out with the aim of maximising the secrecy sum-rate for SWIPT in FD systems. In this context, we employ the use of an amplify and forward (AF) relay to inject artificial noise (AN) in order to confuse the eavesdropper. Thus, we address the optimal joint design of the beamforming matrix and AN covariance matrix at the relay, and the transmit power at the sources. Comprehensively, we present extensive theoretical and computer simulations to corroborate the need for joint optimization

Statistical Performance Evaluation for Energy Harvesting Communications based on Large Deviation Theorem

Energy harvesting (EH) is a promising technology for enhancing a network’s quality of service (QoS). EH-based communication systems are studied by tackling the challenges of energy-outage probability and energy conditioning. These issues motivate this research to develop new solutions for increasing the lifetime of device batteries by leveraging renewable energy sources available in the surrounding environment, for instance, from solar and radio-frequency (RF) energy through harvesting. This dissertation studies an energy outage problem and user QoS requirements for energy harvesting communications. In the first part of this dissertation, the performance of an energy harvesting communication link is analysed by allowing a certain level of energy-outage. In EH systems, energy consumed from the battery depends on the QoS required by the end user and on the channel state information. At the same time, the energy arrival to the battery depends on the strength of the power source, solar in this case, and is independent of the fading channel conditions and the required QoS. Due to the independence between the energy arrival into the battery and the energy consumed from there, it is challenging to estimate the exact status of the available energy in the battery. An energy outage is experienced when there is no further energy for the system to utilise for data transmission. In this part, a thorough study was carried out to analyse the required energy harvesting (EH) rate for satisfying the QoS requirements when a level of energy-outage is allowed in a point-to-point EH-based communication system equipped with a finite-sized battery. Furthermore, an expression relating the rate of the incoming energy with the fading channel conditions and the minimum required QoS of the system was provided to analyse the performance of the EH-based communication system under energy constraints. Finally, numerical results confirm the proposed mechanism’s analytical findings and correctness. In the second part of this dissertation, the performance of point-to-point communications is investigated in which the source node can harvest and store energy from RF signals and then use the harvested energy to communicate with its end destination. The continuous availability of RF energy has proved advantageous as a wireless power source to support low-power devices, making RF-based energy harvesting an alternative and viable solution for powering next-generation wireless networks, particularly for Internet-of-Things (IoT) applications. Specifically, the point-to-point RF-based energy-harvesting communication is considered, where the transmitter, which can be an IoT sensor, implements a time-switching protocol between the energy harvesting and the information transfer, and we focus on analysing the system performance while aiming to guarantee the required QoS of the end user subject to system constraint energy outage. The time-switching circuit at the source node allows the latter to switch between harvesting energy from a distant RF energy source and transmitting data to its target destination using the scavenged energy. Using a duality principle between the physical energy queue and a proposed virtual energy queue and assuming that a certain level of energy outage can be tolerated in the communication process, the system performance was evaluated with a novel analytical framework that leverages tools for the large deviation principle. In the third and last part of this dissertation, an empirical study of the RF-EH model is presented for ensuring the QoS constraints during an energy-outage for Simultaneous Wireless Information and Power Transfer (SWIPT) network. We consider a relay network over a Rayleigh fading channel where the relay lacks a permanent power source. Thus, we obtain energy from wireless energy harvesting (EH) of the source’s signals to maintain operation. This process is performed using a time-switching protocol at the relay for enhancing the quality of service (QoS) in SWIPT networks. A numerical approach is incorporated to evaluate the performance of the proposed RF-EH model in terms of different evaluation parameters such as time-switching protocol, transmit power and outage. The assumptions of the large deviation principle are satisfied using a proposed virtual energy queuing model, which is then used for the performance analysis. We established a closed-form expression for the system’s probability of experiencing an energy outage and the energy consumed by the relay battery