605 research outputs found
Efficient DSP and Circuit Architectures for Massive MIMO: State-of-the-Art and Future Directions
Massive MIMO is a compelling wireless access concept that relies on the use
of an excess number of base-station antennas, relative to the number of active
terminals. This technology is a main component of 5G New Radio (NR) and
addresses all important requirements of future wireless standards: a great
capacity increase, the support of many simultaneous users, and improvement in
energy efficiency. Massive MIMO requires the simultaneous processing of signals
from many antenna chains, and computational operations on large matrices. The
complexity of the digital processing has been viewed as a fundamental obstacle
to the feasibility of Massive MIMO in the past. Recent advances on
system-algorithm-hardware co-design have led to extremely energy-efficient
implementations. These exploit opportunities in deeply-scaled silicon
technologies and perform partly distributed processing to cope with the
bottlenecks encountered in the interconnection of many signals. For example,
prototype ASIC implementations have demonstrated zero-forcing precoding in real
time at a 55 mW power consumption (20 MHz bandwidth, 128 antennas, multiplexing
of 8 terminals). Coarse and even error-prone digital processing in the antenna
paths permits a reduction of consumption with a factor of 2 to 5. This article
summarizes the fundamental technical contributions to efficient digital signal
processing for Massive MIMO. The opportunities and constraints on operating on
low-complexity RF and analog hardware chains are clarified. It illustrates how
terminals can benefit from improved energy efficiency. The status of technology
and real-life prototypes discussed. Open challenges and directions for future
research are suggested.Comment: submitted to IEEE transactions on signal processin
Adaptive Differential Feedback in Time-Varying Multiuser MIMO Channels
In the context of a time-varying multiuser multiple-input-multiple-output
(MIMO) system, we design recursive least squares based adaptive predictors and
differential quantizers to minimize the sum mean squared error of the overall
system. Using the fact that the scalar entries of the left singular matrix of a
Gaussian MIMO channel becomes almost Gaussian distributed even for a small
number of transmit antennas, we perform adaptive differential quantization of
the relevant singular matrix entries. Compared to the algorithms in the
existing differential feedback literature, our proposed quantizer provides
three advantages: first, the controller parameters are flexible enough to adapt
themselves to different vehicle speeds; second, the model is backward adaptive
i.e., the base station and receiver can agree upon the predictor and variance
estimator coefficients without explicit exchange of the parameters; third, it
can accurately model the system even when the correlation between two
successive channel samples becomes as low as 0.05. Our simulation results show
that our proposed method can reduce the required feedback by several kilobits
per second for vehicle speeds up to 20 km/h (channel tracker) and 10 km/h
(singular vector tracker). The proposed system also outperforms a fixed
quantizer, with same feedback overhead, in terms of bit error rate up to 30
km/h.Comment: IEEE 22nd International Conference on Personal, Indoor and Mobile
Radio Communications (2011
Scaling up MIMO: Opportunities and Challenges with Very Large Arrays
This paper surveys recent advances in the area of very large MIMO systems.
With very large MIMO, we think of systems that use antenna arrays with an
order of magnitude more elements than in systems being built today, say a
hundred antennas or more. Very large MIMO entails an unprecedented number of
antennas simultaneously serving a much smaller number of terminals. The
disparity in number emerges as a desirable operating condition and a practical
one as well. The number of terminals that can be simultaneously served is
limited, not by the number of antennas, but rather by our inability to acquire
channel-state information for an unlimited number of terminals. Larger numbers
of terminals can always be accommodated by combining very large MIMO technology
with conventional time- and frequency-division multiplexing via OFDM. Very
large MIMO arrays is a new research field both in communication theory,
propagation, and electronics and represents a paradigm shift in the way of
thinking both with regards to theory, systems and implementation. The ultimate
vision of very large MIMO systems is that the antenna array would consist of
small active antenna units, plugged into an (optical) fieldbus.Comment: Accepted for publication in the IEEE Signal Processing Magazine,
October 201
WiMax - a critical view of the technology and its economics
University of the Witwatersrand
Faculty of Engineering and the Built Environment
School of Information and Electrical EngineeringMobile Broadband is now more of a necessity than a luxury, especially amongst the younger generation, irrespective of where they live. Mobile WiMax and LTE, the latest and fastest Mobile Broadband technologies, mark significant improvements over 3G networks because they use IP (Internet Protocol) end-to-end. To end-users, this means faster network speeds, better quality services, and increased coverage area. To the Network Operators, this means simplified network architectures, efficient use of resources, and improved security. In this report, the different issues and challenges related to deploying Mobile WiMax (802.16e or 802.16m) in rural South Africa, were identifed and explored. In this project, Atoll, SONAR, and Touch Point analysis tools were used to determine which Mobile Broadband technology is economically and technically suited for rural South Africa. It was found that LTE yields superior performance results than WiMax, which in turn yields superior performance results to all other existing 3G technologies. However it will take time for LTE to reach rural areas therefore WiMax can be considered as a solution to extend Broadband services to rural South Africa and thus assist in bridging the digital divide. Recommendations on how best to deploy Mobile WiMax are made based on observations made from the experimental work.MT201
End-to-End Simulation of 5G mmWave Networks
Due to its potential for multi-gigabit and low latency wireless links,
millimeter wave (mmWave) technology is expected to play a central role in 5th
generation cellular systems. While there has been considerable progress in
understanding the mmWave physical layer, innovations will be required at all
layers of the protocol stack, in both the access and the core network.
Discrete-event network simulation is essential for end-to-end, cross-layer
research and development. This paper provides a tutorial on a recently
developed full-stack mmWave module integrated into the widely used open-source
ns--3 simulator. The module includes a number of detailed statistical channel
models as well as the ability to incorporate real measurements or ray-tracing
data. The Physical (PHY) and Medium Access Control (MAC) layers are modular and
highly customizable, making it easy to integrate algorithms or compare
Orthogonal Frequency Division Multiplexing (OFDM) numerologies, for example.
The module is interfaced with the core network of the ns--3 Long Term Evolution
(LTE) module for full-stack simulations of end-to-end connectivity, and
advanced architectural features, such as dual-connectivity, are also available.
To facilitate the understanding of the module, and verify its correct
functioning, we provide several examples that show the performance of the
custom mmWave stack as well as custom congestion control algorithms designed
specifically for efficient utilization of the mmWave channel.Comment: 25 pages, 16 figures, submitted to IEEE Communications Surveys and
Tutorials (revised Jan. 2018
- …