A 249-Mpixel/s HEVC Video-Decoder Chip for 4K Ultra-HD Applications

High Efficiency Video Coding, the latest video standard, uses larger and variable-sized coding units and longer interpolation filters than [H.264 over AVC] to better exploit redundancy in video signals. These algorithmic techniques enable a 50% decrease in bitrate at the cost of computational complexity, external memory bandwidth, and, for ASIC implementations, on-chip SRAM of the video codec. This paper describes architectural optimizations for an HEVC video decoder chip. The chip uses a two-stage subpipelining scheme to reduce on-chip SRAM by 56 kbytes-a 32% reduction. A high-throughput read-only cache combined with DRAM-latency-aware memory mapping reduces DRAM bandwidth by 67%. The chip is built for HEVC Working Draft 4 Low Complexity configuration and occupies 1.77 mm[superscript 2] in 40-nm CMOS. It performs 4K Ultra HD 30-fps video decoding at 200 MHz while consuming 1.19 [nJ over pixel] of normalized system power.Texas Instruments Incorporate

Decoder Hardware Architecture for HEVC

This chapter provides an overview of the design challenges faced in the implementation of hardware HEVC decoders. These challenges can be attributed to the larger and diverse coding block sizes and transform sizes, the larger interpolation filter for motion compensation, the increased number of steps in intra prediction and the introduction of a new in-loop filter. Several solutions to address these implementation challenges are discussed. As a reference, results for an HEVC decoder test chip are also presented.Texas Instruments Incorporate

A 249Mpixel/s HEVC video-decoder chip for Quad Full HD applications

The latest video coding standard High Efficiency Video Coding (HEVC) provides 50% improvement in coding efficiency compared to H.264/AVC, to meet the rising demand for video streaming, better video quality and higher resolutions. The coding gain is achieved using more complex tools such as larger and variable-size coding units (CU) in a hierarchical structure, larger transforms and longer interpolation filters. This paper presents an integrated circuit which supports Quad Full HD (QFHD, 3840×2160) video decoding for the HEVC draft standard. It addresses new design challenges for HEVC (“H.265”) with three primary contributions: 1) a system pipelining scheme which adapts to the variable-size largest coding unit (LCU) and provides a two-stage sub-pipeline for memory optimization; 2) unified processing engines to address the hierarchical coding structure and many prediction and transform block sizes in area-efficient ways; 3) a motion compensation (MC) cache which reduces DRAM bandwidth for the LCU and meets the high throughput requirements which are due to the long filters.Texas Instruments Incorporate

Low energy HEVC video compression hardware designs

Joint collaborative team on video coding (JCT-VC) recently developed a new international video compression standard called High Efficiency Video Coding (HEVC). HEVC has 37% better compression efficiency than H.264 which is the current state-of-the-art video compression standard. HEVC achieves this video compression efficiency by significantly increasing the computational complexity. Therefore, in this thesis, we propose novel computational complexity and energy reduction techniques for intra prediction algorithm used in HEVC video encoder and decoder. We quantified the computation reductions achieved by these techniques using HEVC HM reference software encoder. We designed efficient hardware architectures for these video compression algorithms used in HEVC. We also designed a reconfigurable sub-pixel interpolation hardware for both HEVC encoder and decoder. We implemented these hardware architectures in Verilog HDL. We mapped the Verilog RTL codes to a Xilinx Virtex 6 FPGA and estimated their power consumptions on this FPGA using Xilinx XPower Analyzer tool. The proposed techniques significantly reduced the energy consumptions of these FPGA implementations in some cases with no PSNR loss and in some cases with very small PSNR loss

Low energy video processing and compression hardware designs

Digital video processing and compression algorithms are used in many commercial products such as mobile devices, unmanned aerial vehicles, and autonomous cars. Increasing resolution of videos used in these commercial products increased computational complexities of digital video processing and compression algorithms. Therefore, it is necessary to reduce computational complexities of digital video processing and compression algorithms, and energy consumptions of digital video processing and compression hardware without reducing visual quality. In this thesis, we propose a novel adaptive 2D digital image processing algorithm for 2D median filter, Gaussian blur and image sharpening. We designed low energy 2D median filter, Gaussian blur and image sharpening hardware using the proposed algorithm. We propose approximate HEVC intra prediction and HEVC fractional interpolation algorithms. We designed low energy approximate HEVC intra prediction and HEVC fractional interpolation hardware. We also propose several HEVC fractional interpolation hardware architectures. We propose novel computational complexity and energy reduction techniques for HEVC DCT and inverse DCT/DST. We designed high performance and low energy hardware for HEVC DCT and inverse DCT/DST including the proposed techniques. VII We quantified computation reductions achieved and video quality loss caused by the proposed algorithms and techniques. We implemented the proposed hardware architectures in Verilog HDL. We mapped the Verilog RTL codes to Xilinx Virtex 6 and Xilinx ZYNQ FPGAs, and estimated their power consumptions using Xilinx XPower Analyzer tool. The proposed algorithms and techniques significantly reduced the power and energy consumptions of these FPGA implementations in some cases with no PSNR loss and in some cases with very small PSNR loss

An energy-aware system-on-chip architecture for intra prediction in HEVC standard

High resolution 4K and 8K are becoming the more used in video applications. Those resolutions are well supported in the new HEVC standard. Thus, embedded solutions such as development of dedicated ystems-On-Chips (SOC) to accelerate video processing on one chip instead of only software solutions are commendable. This paper proposes a novel parallel and high efficient hardware accelerator for the intra prediction block. This accelerator achieves a high-speed treatment due to pipelined processing units and parallel shaped architecture. The complexity of memory access is also reduced thanks to the proposed design with less increased power consumption. The implementation was performed on the 7 Series FPGA 28 nm technology resources on Zynq-7000 and results show, that the proposed architecture takes 16520 LUTs and can reach 143.65 MHz as a maximum frequency and it is able to support the throughput of 3840×2160 sequence at 90 frames per second

Low energy HEVC and VVC video compression hardware

Video compression standards compress a digital video by reducing and removing redundancy in the digital video using computationally complex algorithms. As spatial and temporal resolutions of videos increase, compression efficiencies of video compression algorithms are also increasing. However, increased compression efficiency comes with increased computational complexity. Therefore, it is necessary to reduce computational complexities of video compression algorithms without reducing their visual quality in order to reduce area and energy consumption of their hardware implementations. In this thesis, we propose a novel technique for reducing amount of computations performed by HEVC intra prediction algorithm. We designed low energy, reconfigurable HEVC intra prediction hardware using the proposed technique. We also designed a low energy FPGA implementation of HEVC intra prediction algorithm using the proposed technique and DSP blocks. We propose a reconfigurable VVC intra prediction hardware architecture. We also propose an efficient VVC intra prediction hardware architecture using DSP blocks. We designed low energy VVC fractional interpolation hardware. We propose a novel approximate absolute difference technique. We designed low energy approximate absolute difference hardware using the proposed technique. We propose a novel approximate constant multiplication technique. We designed approximate constant multiplication hardware using the proposed technique. We quantified computation reductions achieved by the proposed techniques and video quality loss caused by the proposed approximation techniques. The proposed approximate absolute difference technique and approximate constant multiplication technique cause very small PSNR loss. The other proposed techniques cause no PSNR loss. We implemented the proposed hardware architectures in Verilog HDL. We mapped the Verilog RTL codes to Xilinx Virtex 6 or Xilinx Virtex 7 FPGAs and estimated their power consumptions using Xilinx XPower Analyzer tool. The proposed techniques significantly reduced power and energy consumptions of these FPGA implementation