Inter-cell Interference Management Technique for Multi-Cell LTE-A Network

In modern cellular system such as LTE Advanced (LTE-A), frequency reuse scheme is targeted to be applied to fulfill the requirement of high capacity broadband access and high spectrum efficiency. But this kind of frequency planning may lead to the worse inter-cell interference (ICI) level experienced especially by a user located at the cell edge. Soft Frequency Reuse (SFR) is considered as an effective way to mitigate inter-cell interference and maintain capacity. We propose a power division SFR, known as multi level SFR technique to minimize ICI in a designed LTE-A network for sub-urban environment. Service area of LTE-A network was first developed to deploy particular number of eNB by using LTE network planning tools in the frequency of 1800 MHz with the use of SISO (Single Input Single Output) antennas. Coverage dimensioning and propagation consideration determine LTE-A parameters which were used in the simulation. Monte carlo simulation is executed to examine the performance of SFR for LTE-A downlink transmission to address different power ratio and traffic loads problem. Both performance of cell edge users and overall cell performance are evaluated in terms of CINR, BLER, and throughput. Performance with SFR is also compared with the classical frequency reuse one and three

Interference model and evaluation in LTE networks

International audienceThe purpose of this paper is to evaluate the impact of frequency parameter settings while evaluating interference model in LTE (Long Term Evolution); the work is applied on a network. We develop and validate the interference model based on SINR which is used by 3GPP (3rd Group Partnership Project) to estimate the quality of signal received by UE (User Equipment) and issued from eNB (enhanced Node Base). For this aim, two frequency schemes have been compared: the frequency reuse 1 scheme whereby the whole available bandwidth is used in each cell/sector and the frequency reuse 3 scheme in which the entire bandwidth is divided into 3 non-overlapping groups and assigned to 3 co-site sectors within each cell

Wireless Cellular Networks

When aiming for achieving high spectral efficiency in wireless cellular networks, cochannel interference (CCI) becomes the dominant performancelimiting factor. This article provides a survey of CCI mitigation techniques, where both active and passive approaches are discussed in the context of both open- and closed-loop designs.More explicitly, we considered both the family of flexible frequency-reuse (FFR)-aided and dynamic channel allocation (DCA)-aided interference avoidance techniques as well as smart antenna-aided interference mitigation techniques, which may be classified as active approach

Millimeter Wave Cellular Networks: A MAC Layer Perspective

The millimeter wave (mmWave) frequency band is seen as a key enabler of multi-gigabit wireless access in future cellular networks. In order to overcome the propagation challenges, mmWave systems use a large number of antenna elements both at the base station and at the user equipment, which lead to high directivity gains, fully-directional communications, and possible noise-limited operations. The fundamental differences between mmWave networks and traditional ones challenge the classical design constraints, objectives, and available degrees of freedom. This paper addresses the implications that highly directional communication has on the design of an efficient medium access control (MAC) layer. The paper discusses key MAC layer issues, such as synchronization, random access, handover, channelization, interference management, scheduling, and association. The paper provides an integrated view on MAC layer issues for cellular networks, identifies new challenges and tradeoffs, and provides novel insights and solution approaches.Comment: 21 pages, 9 figures, 2 tables, to appear in IEEE Transactions on Communication

Interference model and antenna parameters setting effects on 4G-LTE networks coverage

International audienceThe currently emerging Long Term Evolution 4G-LTE cellular networks are based on new technique of transmission called the Orthogonal Frequency Division Multiple Access (OFDMA). This paper shows the interest of robust approach due to the uncertainty of traffic distribution. First, we develop and validate the interference model based on SINR metric for the deployment of the LTE network, and then we use greedy algorithms to show how frequency and tilt parameter settings can impact the coverage performance metric. Two frequency schemes have been compared to validate our model: the frequency reuse 1 scheme whereby the whole available bandwidth is used in each cell/sector and the frequency reuse 3 scheme in which the entire bandwidth is divided into 3 non-overlapping groups and assigned to 3 co-site sectors within each cell

Separation Framework: An Enabler for Cooperative and D2D Communication for Future 5G Networks

Soaring capacity and coverage demands dictate that future cellular networks need to soon migrate towards ultra-dense networks. However, network densification comes with a host of challenges that include compromised energy efficiency, complex interference management, cumbersome mobility management, burdensome signaling overheads and higher backhaul costs. Interestingly, most of the problems, that beleaguer network densification, stem from legacy networks' one common feature i.e., tight coupling between the control and data planes regardless of their degree of heterogeneity and cell density. Consequently, in wake of 5G, control and data planes separation architecture (SARC) has recently been conceived as a promising paradigm that has potential to address most of aforementioned challenges. In this article, we review various proposals that have been presented in literature so far to enable SARC. More specifically, we analyze how and to what degree various SARC proposals address the four main challenges in network densification namely: energy efficiency, system level capacity maximization, interference management and mobility management. We then focus on two salient features of future cellular networks that have not yet been adapted in legacy networks at wide scale and thus remain a hallmark of 5G, i.e., coordinated multipoint (CoMP), and device-to-device (D2D) communications. After providing necessary background on CoMP and D2D, we analyze how SARC can particularly act as a major enabler for CoMP and D2D in context of 5G. This article thus serves as both a tutorial as well as an up to date survey on SARC, CoMP and D2D. Most importantly, the article provides an extensive outlook of challenges and opportunities that lie at the crossroads of these three mutually entangled emerging technologies.Comment: 28 pages, 11 figures, IEEE Communications Surveys & Tutorials 201

Studies on 6-sector-site deployment in downlink LTE

Mobile data traffic is expected to increase massively in the following years. Consequently, service operators are induced to increase the capacity of their networks continually to attract more subscribers and maximize their revenues. At the same time, they want to minimize operational costs and capital expenditures. Among the alternatives that aim to increase the network capacity, higher order sectorization, and in particular a six sectorized configuration, is nowadays attracting a lot of attention for LTE macro-cell deployments since a higher number of sectors per site results in improved site capacity and coverage. A six sectorized configuration is attractive for both roll-out phase and growth phase of the network. In the roll-out phase, the radio access network is planned with 6-sector sites instead of 3-sector sites with the advantage that less sites are needed for the same capacity and coverage requirements. In the growth phase, the six sectorized configuration can be used to upgrade existing 3-sector sites where the traffic grows beyond the current sites' capabilities. Therefore, no additional expensive and time consuming contracts need to be signed for the locations of the new sites, while the existing sites are used more efficiently. However, although potentially a 6-sector site can offer a double capacity than a 3-sector site, several factors prevent the capacity from growing proportionately to the number of sectors. Consequently, there is an uncertainty on whether the capacity gain is high enough to justify the extra costs of the additional equipment and, more specifically, whether the 6-sector-site deployment is more economically attractive than a 3-sector-site deployment. The aim of this report is to solve this uncertainty. First, we present the main factors that affect the capacity gain. Next, we quantify the impact of these factors on the capacity gain in downlink LTE with the use of a system level simulator. Finally, we use the results of the simulation study as inputs for an economic study to access the reasons for a possible deployment of 6-sector sites instead of 3-sector sites for LTE