Multi-tap Digital Canceller for Full-Duplex Applications

We identify phase noise as a bottleneck for the performance of digital self-interference cancellers that utilize a single auxiliary receiver---single-tap digital cancellers---and operate in multipath propagation environments. Our analysis demonstrates that the degradation due to phase noise is caused by a mismatch between the analog delay of the auxiliary receiver and the different delays of the multipath components of the self-interference signal. We propose a novel multi-tap digital self-interference canceller architecture that is based on multiple auxiliary receivers and a customized Normalized-Least-Mean-Squared (NLMS) filtering for self-interference regeneration. Our simulation results demonstrate that our proposed architecture is more robust to phase noise impairments and can in some cases achieve 10~dB larger self-interference cancellation than the single-tap architecture.Comment: SPAWC 201

Full Duplex CMOS Transceiver with On-Chip Self-Interference Cancelation

abstract: The demand for the higher data rate in the wireless telecommunication is increasing rapidly. Providing higher data rate in cellular telecommunication systems is limited because of the limited physical resources such as telecommunication frequency channels. Besides, interference with the other users and self-interference signal in the receiver are the other challenges in increasing the bandwidth of the wireless telecommunication system. Full duplex wireless communication transmits and receives at the same time and the same frequency which was assumed impossible in the conventional wireless communication systems. Full duplex wireless communication, compared to the conventional wireless communication, doubles the channel efficiency and bandwidth. In addition, full duplex wireless communication system simplifies the reusing of the radio resources in small cells to eliminate the backhaul problem and simplifies the management of the spectrum. Finally, the full duplex telecommunication system reduces the costs of future wireless communication systems. The main challenge in the full duplex wireless is the self-interference signal at the receiver which is very large compared to the receiver noise floor and it degrades the receiver performance significantly. In this dissertation, different techniques for the antenna interface and self-interference cancellation are proposed for the wireless full duplex transceiver. These techniques are designed and implemented on CMOS technology. The measurement results show that the full duplex wireless is possible for the short range and cellular wireless communication systems.Dissertation/ThesisDoctoral Dissertation Engineering 201

Measuring the Phase Variation of a DOCSIS 3.1 Full Duplex Channel

Including a Full Duplex option into DOCSIS introduces several problems. One of the more troublesome issues is the presence of a strong self interference signal that leaks from the transmit side to the receive side of a cable node. This self interference is caused by echoes in the channel that translate the forward travelling transmit signals into a reverse travelling signal, as well as, by leakage from the hybrid coupler used to couple the upstream and downstream signals. To suppress this self interference an echo canceller is implemented to remove the unwanted interference from the received signal. Unfortunately with the high rates of data transmission used in modern day CATV networks the echo canceller needs tremendous precision. A major concern in the implementation of Full Duplex into DOCSIS is if the channels used are even very slightly time varying. The echos in such channels change with time and can be difficult for the echo canceller to track. Changes in the response of the channel cause the echo profile of the network to shift and the echo canceler to re-adapt to the new channel response. The issue with this changing response is that it is possible for the channel to change faster than the echo canceller can adapt, resulting in the interference becoming unacceptably high. Since the channel is a physical network of coaxial cables often exposed to the environment, its propagation properties can be affected by wind swaying pole mounted cables, or by rapid heating from the sun, or sudden shifts in the load of the network. With information on how the physical properties of the cable changes, the engineers designing the echo canceller can know how fast the canceller must adapt to changes and also have a better measure of how reliable its echo cancellation will be. In this thesis the stability of the echo profile of the channel is measured. It is shown that the property of the channel with the greatest potential to rapidly change and cause noise after echo cancellation is the phase response of the channel. Due to this, the approach of this thesis is to measure the fluctuations in the phase of the channel response of a CATV network constructed in the lab. To measure the fluctuations in the phase response of the channel, a PLL (Phase Locked Loop) based circuit is designed and built on an FPGA (Field Programmable Gate Array) and connected to a model of a simple CATV network. The PLL circuit used to measure the phase fluctuations of the channel is designed to be able to measure changes occurring faster than 0.1 Hz and with a power higher than $10^{-7} \: V^2$. The circuit is able to capture data from the channel over a period of 90 seconds. Using this phase variation measurement circuit a series of experiments were performed on a model CATV DOCSIS network. It was found that many physical disturbances to the network had the effect of rapidly shifting the phase response of the network. Heating the cables in the network was found to shift the phase response upwards of $20000\:\mu$radians. Flexing the cables in the network was found to have a peak phase variation of $8000\: \mu$radians with similar effects found from walking over cables. Overall, it was clear that physical effects on the network had the propensity to rapidly shift the network response. Any echo canceller that is designed in the future will have to consider these effects when reporting the cancellation that it is able to achieve

TRANSMISSION PERFORMANCE OPTIMIZATION IN FIBER-WIRELESS ACCESS NETWORKS USING MACHINE LEARNING TECHNIQUES

The objective of this dissertation is to enhance the transmission performance in the fiber-wireless access network through mitigating the vital system limitations of both analog radio over fiber (A-RoF) and digital radio over fiber (D-RoF), with machine learning techniques being systematically implemented. The first thrust is improving the spectral efficiency for the optical transmission in the D-RoF to support the delivery of the massive number of bits from digitized radio signals. Advanced digital modulation schemes like PAM8, discrete multi-tone (DMT), and probabilistic shaping are investigated and implemented, while they may introduce severe nonlinear impairments on the low-cost optical intensity-modulation-direct-detection (IMDD) based D-RoF link with a limited dynamic range. An efficient deep neural network (DNN) equalizer/decoder to mitigate the nonlinear degradation is therefore designed and experimentally verified. Besides, we design a neural network based digital predistortion (DPD) to mitigate the nonlinear impairments from the whole link, which can be integrated into a transmitter with more processing resources and power than a receiver in an access network. Another thrust is to proactively mitigate the complex interferences in radio access networks (RANs). The composition of signals from different licensed systems and unlicensed transmitters creates an unprecedently complex interference environment that cannot be solved by conventional pre-defined network planning. In response to the challenges, a proactive interference avoidance scheme using reinforcement learning is proposed and experimentally verified in a mmWave-over-fiber platform. Except for the external sources, the interference may arise internally from a local transmitter as the self-interference (SI) that occupies the same time and frequency block as the signal of interest (SOI). Different from the conventional subtraction-based SI cancellation scheme, we design an efficient dual-inputs DNN (DI-DNN) based canceller which simultaneously cancels the SI and recovers the SOI.Ph.D

Itsehäiriön analoginen RF-kumoaminen

In this thesis a novel RF-canceler for full-duplex operation is presented, designed and implemented. The canceler is built for the full-duplex research group which is currently collaborating with Intel labs. The original design is from Intel. Two revision of cancelers were built and measured. The obtained results prove the canceler design to be effective and it is self-adaptive. The obtained cancellation in self-adaptive mode is order of 30 dB when using 20 MHz wide signal. This design fares well against other designs presented in academia

Full-duplex wireless communications: challenges, solutions and future research directions

The family of conventional half-duplex (HD) wireless systems relied on transmitting and receiving in different time-slots or frequency sub-bands. Hence the wireless research community aspires to conceive full-duplex (FD) operation for supporting concurrent transmission and reception in a single time/frequency channel, which would improve the attainable spectral efficiency by a factor of two. The main challenge encountered in implementing an FD wireless device is the large power difference between the self-interference (SI) imposed by the device’s own transmissions and the signal of interest received from a remote source. In this survey, we present a comprehensive list of the potential FD techniques and highlight their pros and cons. We classify the SI cancellation techniques into three categories, namely passive suppression, analog cancellation and digital cancellation, with the advantages and disadvantages of each technique compared. Specifically, we analyse the main impairments (e.g. phase noise, power amplifier nonlinearity as well as in-phase and quadrature-phase (I/Q) imbalance, etc.) that degrading the SI cancellation. We then discuss the FD based Media Access Control (MAC)-layer protocol design for the sake of addressing some of the critical issues, such as the problem of hidden terminals, the resultant end-to-end delay and the high packet loss ratio (PLR) due to network congestion. After elaborating on a variety of physical/MAC-layer techniques, we discuss potential solutions conceived for meeting the challenges imposed by the aforementioned techniques. Furthermore, we also discuss a range of critical issues related to the implementation, performance enhancement and optimization of FD systems, including important topics such as hybrid FD/HD scheme, optimal relay selection and optimal power allocation, etc. Finally, a variety of new directions and open problems associated with FD technology are pointed out. Our hope is that this treatise will stimulate future research efforts in the emerging field of FD communication

Full-Duplex Wireless for 6G: Progress Brings New Opportunities and Challenges

The use of in-band full-duplex (FD) enables nodes to simultaneously transmit and receive on the same frequency band, which challenges the traditional assumption in wireless network design. The full-duplex capability enhances spectral efficiency and decreases latency, which are two key drivers pushing the performance expectations of next-generation mobile networks. In less than ten years, in-band FD has advanced from being demonstrated in research labs to being implemented in standards and products, presenting new opportunities to utilize its foundational concepts. Some of the most significant opportunities include using FD to enable wireless networks to sense the physical environment, integrate sensing and communication applications, develop integrated access and backhaul solutions, and work with smart signal propagation environments powered by reconfigurable intelligent surfaces. However, these new opportunities also come with new challenges for large-scale commercial deployment of FD technology, such as managing self-interference, combating cross-link interference in multi-cell networks, and coexistence of dynamic time division duplex, subband FD and FD networks.Comment: 21 pages, 15 figures, accepted to an IEEE Journa