493 research outputs found
Performance enhancement for LTE and beyond systems
A thesis submitted to the University of Bedfordshire, in partial fulfilment of the requirements for the degree of Doctor of PhilosophyWireless communication systems have undergone fast development in recent years. Based on GSM/EDGE and UMTS/HSPA, the 3rd Generation Partnership Project (3GPP) specified the Long Term Evolution (LTE) standard to cope with rapidly increasing demands, including capacity, coverage, and data rate. To achieve this goal, several key techniques have been adopted by LTE, such as Multiple-Input and Multiple-Output (MIMO), Orthogonal Frequency-Division Multiplexing (OFDM), and heterogeneous network (HetNet). However, there are some inherent drawbacks regarding these techniques. Direct conversion architecture is adopted to provide a simple, low cost transmitter solution. The problem of I/Q imbalance arises due to the imperfection of circuit components; the orthogonality of OFDM is vulnerable to carrier frequency offset (CFO) and sampling frequency offset (SFO). The doubly selective channel can also severely deteriorate the receiver performance. In addition, the deployment of Heterogeneous Network (HetNet), which permits the co-existence of macro and pico cells, incurs inter-cell interference for cell edge users. The impact of these factors then results in significant degradation in relation to system performance.
This dissertation aims to investigate the key techniques which can be used to mitigate the above problems. First, I/Q imbalance for the wideband transmitter is studied and a self-IQ-demodulation based compensation scheme for frequencydependent (FD) I/Q imbalance is proposed. This combats the FD I/Q imbalance by using the internal diode of the transmitter and a specially designed test signal without any external calibration instruments or internal low-IF feedback path. The instrument test results show that the proposed scheme can enhance signal quality by 10 dB in terms of image rejection ratio (IRR).
In addition to the I/Q imbalance, the system suffers from CFO, SFO and frequency-time selective channel. To mitigate this, a hybrid optimum OFDM receiver with decision feedback equalizer (DFE) to cope with the CFO, SFO and doubly selective channel. The algorithm firstly estimates the CFO and channel frequency response (CFR) in the coarse estimation, with the help of hybrid classical timing and frequency synchronization algorithms. Afterwards, a pilot-aided polynomial interpolation channel estimation, combined with a low complexity DFE scheme, based on minimum mean squared error (MMSE) criteria, is developed to alleviate the impact of the residual SFO, CFO, and Doppler effect.
A subspace-based signal-to-noise ratio (SNR) estimation algorithm is proposed to estimate the SNR in the doubly selective channel. This provides prior knowledge for MMSE-DFE and automatic modulation and coding (AMC). Simulation results show that this proposed estimation algorithm significantly improves the system performance. In order to speed up algorithm verification process, an FPGA based co-simulation is developed.
Inter-cell interference caused by the co-existence of macro and pico cells has a big impact on system performance. Although an almost blank subframe (ABS) is proposed to mitigate this problem, the residual control signal in the ABS still inevitably causes interference. Hence, a cell-specific reference signal (CRS) interference cancellation algorithm, utilizing the information in the ABS, is proposed. First, the timing and carrier frequency offset of the interference signal is compensated by utilizing the cross-correlation properties of the synchronization signal. Afterwards, the reference signal is generated locally and channel response is estimated by making use of channel statistics. Then, the interference signal is reconstructed based on the previous estimate of the channel, timing and carrier frequency offset. The interference is mitigated by subtracting the estimation of the interference signal and LLR puncturing. The block error rate (BLER) performance of the signal is notably improved by this algorithm, according to the simulation results of different channel scenarios.
The proposed techniques provide low cost, low complexity solutions for LTE and beyond systems. The simulation and measurements show good overall system performance can be achieved
Non-linear echo cancellation - a Bayesian approach
Echo cancellation literature is reviewed, then a Bayesian model is introduced and it is shown how how it can be used to model and fit nonlinear channels. An algorithm for cancellation of echo over a nonlinear channel is developed and tested. It is shown that this nonlinear algorithm converges for both linear and nonlinear channels and is superior to linear echo cancellation for canceling an echo through a nonlinear echo-path channel
Recommended from our members
Array Architectures and Physical Layer Design for Millimeter-Wave Communications Beyond 5G
Ever increasing demands in mobile data rates have resulted in exploration of millimeter-wave (mmW) frequencies for the next generation (5G) wireless networks. Communications at mmW frequencies is presented with two keys challenges. Firstly, high propagation loss requires base stations (BSs) and user equipment (UEs) to use a large number of antennas and narrow beams to close the link with sufficient received signal power. Consequently, communications using narrow beams create a new challenge in channel estimation and link establishment based on fine angular probing. Current mmW system use analog phased arrays that can probe only one angle at the time which results in high latency during link establishment and channel tracking. It is desirable to design low latency beam training by exploring both physical layer designs and array architectures that could replace current 5G approaches and pave the way to the communications for frequency bands in higher mmW band and sub-THz region where larger antenna arrays and communications bandwidth can be exploited. To this end, we propose a novel signal processing techniques exploiting unique properties of mmW channel, and show both theoretically, in simulation and experiments its advantages over conventional approaches. Secondly, we explore different array architecture design and analyze their trade-offs between spectral efficiency and power consumption and area. For comprehensive comparison, we have developed a methodology for optimal design of system parameters for different array architecture candidates based on the spectral efficiency target, and use these parameters to estimate the array area and power consumption based on the circuits reported in the literature. We show that the hybrid analog and digital architectures have severe scalability concerns in radio frequency signal distribution with increased array size and spatial multiplexing levels, while the fully-digital array architectures have the best performance and power/area trade-offs.The developed approaches are based on a cross-disciplinary research that combines innovation in model based signal processing, machine learning, and radio hardware. This work is the first to apply compressive sensing (CS), a signal processing tool that exploits sparsity of mmW channel model, to accelerate beam training of mmW cellular system. The algorithm is designed to address practical issues including the requirement of cell discovery and synchronization that involves estimation of angular channel together with carrier frequency offset and timing offsets. We have analyzed the algorithm performance in the 5G compliant simulation and showed that an order of magnitude saving is achieved in initial access latency for the desired channel estimation accuracy. Moreover, we are the first to develop and implement a neural network assisted compressive beam alignment to deal with hardware impairments in mmW radios. We have used 60GHz mmW testbed to perform experiments and show that neural networks approach enhances alignment rate compared to CS. To further accelerate beam training, we proposed a novel frequency selective probing beams using the true-time-delay (TTD) analog array architecture. Our approach utilizes different subcarriers to scan different directions, and achieves a single-shot beam alignment, the fastest approach reported to date. Our comprehensive analysis of different array architectures and exploration of emerging architectures enabled us to develop an order of magnitude faster and energy efficient approaches for initial access and channel estimation in mmW systems
- …