A fault detection and isolation system for cooperative manipulators

The problem of fault detection and isolation (FDI) in cooperative manipulators is addressed in this paper. Four FDI procedures are developed to deal with free-swinging joint faults, locked joint faults, incorrectly measured joint position, and incorrectly measured joint velocity. Free-swinging and locked joint faults are isolated via neural networks. For each arm, a Multilayer Perceptron (MLP) is used to reproduce the dynamics of the fault-free robot. The outputs of each MLP are compared to the actual joint velocities in order to generate a residual vector which is then classified by an RBF network. The remaining faults are isolated based on the kinematic constraints imposed on the cooperative system. Results obtained via simulations and via an actual cooperative manipulator robot are presented

7-degree-of-freedom hybrid-manipulator exoskeleton for lower-limb motion capture

Lower-limb exoskeletons are wearable robotic systems with a kinematic structure closely matching that of the human leg. In part, this technology can be used to provide clinical assessment and improved independent-walking competency for people living with the effects of stroke, spinal cord injury, Parkinson’s disease, multiple sclerosis, and sarcopenia. Individually, these demographics represent approximately: 405 thousand, 100 thousand, 67.5 thousand, 100 thousand, and 5.9 million Canadians, respectively. Key shortcomings in the current state-of-the-art are: restriction on several of the human leg’s primary joint movements, coaxial joint alignments at the exoskeleton-human interface, and exclusion of well-suited parallel manipulator components. A novel exoskeleton design is thus formulated to address these issues while maintaining large ranges of joint motion. Ultimately, a single-leg unactuated prototype is constructed for seven degree-of-freedom joint angle measurements; it achieves an extent of motion-capture accuracy comparable to a commercial inertial-based system during three levels of human mobility testing

First Annual Workshop on Space Operations Automation and Robotics (SOAR 87)

Several topics relative to automation and robotics technology are discussed. Automation of checkout, ground support, and logistics; automated software development; man-machine interfaces; neural networks; systems engineering and distributed/parallel processing architectures; and artificial intelligence/expert systems are among the topics covered

Analyzing unidentified locked-joint failures in kinematically redundant manipulators

Includes bibliographical references (page 29).Robots are frequently used for operations in hostile environments. The very nature of these environments, however, increases the likelihood of robot failures. Common failure tolerance techniques rely on effective failure detection and identification. Since a failure may not always be successfully identified, or, even if identified, may not be identified soon enough, it becomes important to consider the behavior of manipulators with unidentified failures. This work investigates the behavior of robots experiencing unidentified locked-joint failures in a general class of tasks characterized by point-to-point motion. Based on the analysis, a procedure for workspace evaluation is developed that allows for the identification of regions in the manipulator's workspace in which tasks may be completed even with such failures

Remote Sensing of Earth Resources: A literature survey with indexes (1970 - 1973 supplement). Section 1: Abstracts

Abstracts of reports, articles, and other documents introduced into the NASA scientific and technical information system between March 1970 and December 1973 are presented in the following areas: agriculture and forestry, environmental changes and cultural resources, geodesy and cartography, geology and mineral resources, oceanography and marine resources, hydrology and water management, data processing and distribution systems, instrumentation and sensors, and economic analysis

Space Simulation, 7th

Space simulation facilities and techniques are outlined that encompass thermal scale modeling, computerized simulations, reentry materials, spacecraft contamination, solar simulation, vacuum tests, and heat transfer studies