Spectral Efficiency of MIMO Millimeter-Wave Links with Single-Carrier Modulation for 5G Networks

Future wireless networks will extensively rely upon bandwidths centered on carrier frequencies larger than 10GHz. Indeed, recent research has shown that, despite the large path-loss, millimeter wave (mmWave) frequencies can be successfully exploited to transmit very large data-rates over short distances to slowly moving users. Due to hardware complexity and cost constraints, single-carrier modulation schemes, as opposed to the popular multi-carrier schemes, are being considered for use at mmWave frequencies. This paper presents preliminary studies on the achievable spectral efficiency on a wireless MIMO link operating at mmWave in a typical 5G scenario. Two different single-carrier modem schemes are considered, i.e. a traditional modulation scheme with linear equalization at the receiver, and a single-carrier modulation with cyclic prefix, frequency-domain equalization and FFT-based processing at the receiver. Our results show that the former achieves a larger spectral efficiency than the latter. Results also confirm that the spectral efficiency increases with the dimension of the antenna array, as well as that performance gets severely degraded when the link length exceeds 100 meters and the transmit power falls below 0dBW. Nonetheless, mmWave appear to be very suited for providing very large data-rates over short distances.Comment: 8 pages, 8 figures, to appear in Proc. 20th International ITG Workshop on Smart Antennas (WSA2016

Single-Carrier Modulation versus OFDM for Millimeter-Wave Wireless MIMO

This paper presents results on the achievable spectral efficiency and on the energy efficiency for a wireless multiple-input-multiple-output (MIMO) link operating at millimeter wave frequencies (mmWave) in a typical 5G scenario. Two different single-carrier modem schemes are considered, i.e., a traditional modulation scheme with linear equalization at the receiver, and a single-carrier modulation with cyclic prefix, frequency-domain equalization and FFT-based processing at the receiver; these two schemes are compared with a conventional MIMO-OFDM transceiver structure. Our analysis jointly takes into account the peculiar characteristics of MIMO channels at mmWave frequencies, the use of hybrid (analog-digital) pre-coding and post-coding beamformers, the finite cardinality of the modulation structure, and the non-linear behavior of the transmitter power amplifiers. Our results show that the best performance is achieved by single-carrier modulation with time-domain equalization, which exhibits the smallest loss due to the non-linear distortion, and whose performance can be further improved by using advanced equalization schemes. Results also confirm that performance gets severely degraded when the link length exceeds 90-100 meters and the transmit power falls below 0 dBW.Comment: accepted for publication on IEEE Transactions on Communication

Feasibility of Using Bandwidth Efficient Modulation to Upgrade the CMS Tracker Readout Optical Links

Plans to upgrade the LHC after approximately 10 years of operation are currently being considered at CERN. A tenfold increase in luminosity delivered to the experiments is envisaged in the so-called Super LHC (SLHC). This will undoubtedly give rise to significantly larger data volumes from the detectors, requiring faster data readout. The possibility of upgrading the CMS Tracker analog readout optical links using a bandwidth efficient digital modulation scheme for deployment in the SLHC has been extensively explored at CERN. Previous theoretical and experimental studies determined the achievable data rate using a system based on Quadrature Amplitude Modulation (QAM) to be ~3-4Gbit/s (assuming no error correction is used and for an error rate of ~10-9). In this note we attempt to quantify the feasibility of such an upgrade in terms of hardware implementation complexity, applicability to the high energy physics (HEP) environment, technological feasibility and R&D effort required.Comment: CERN CMS Note. 16 pages, 10 figure

Frequency Spreading Equalization in Multicarrier Massive MIMO

Application of filter bank multicarrier (FBMC) as an effective method for signaling over massive MIMO channels has been recently proposed. This paper further expands the application of FBMC to massive MIMO by applying frequency spreading equalization (FSE) to these channels. FSE allows us to achieve a more accurate equalization. Hence, higher number of bits per symbol can be transmitted and the bandwidth of each subcarrier can be widened. Widening the bandwidth of each subcarrier leads to (i) higher bandwidth efficiency; (ii) lower complexity; (iii) lower sensitivity to carrier frequency offset (CFO); (iv) reduced peak-to-average power ratio (PAPR); and (iv) reduced latency. All these appealing advantages have a direct impact on the digital as well as analog circuitry that is needed for the system implementation. In this paper, we develop the mathematical formulation of the minimum mean square error (MMSE) FSE for massive MIMO systems. This analysis guides us to decide on the number of subcarriers that will be sufficient for practical channel models.Comment: Accepted in IEEE ICC 2015 - Workshop on 5G & Beyond - Enabling Technologies and Application

Analysis and Performance Comparison of DVB-T and DTMB Systems for Terrestrial Digital TV

Orthogonal frequency-division multiplexing (OFDM) is the most popular transmission technology in digital terrestrial broadcasting (DTTB), adopted by many DTTB standards. In this paper, the bit error rate (BER) performance of two DTTB systems, namely cyclic prefix OFDM (CP-OFDM) based DVB-T and time domain synchronous OFDM (TDS-OFDM) based DTMB, is evaluated in different channel conditions. Spectrum utilization and power efficiency are also discussed to demonstrate the transmission overhead of both systems. Simulation results show that the performances of the two systems are much close. Given the same ratio of guard interval (GI), the DVB-T outperforms DTMB in terms of signal to noise ratio (SNR) in Gaussian and Ricean channels, while DTMB behaves better performance in Rayleigh channel in higher code rates and higher orders of constellation thanks to its efficient channel coding and interleaving scheme

Coherent Optical DFT-Spread OFDM

We consider application of the discrete Fourier transform-spread orthogonal frequency-division multiplexing (DFT-spread OFDM) technique to high-speed fiber optic communications. The DFT-spread OFDM is a form of single-carrier technique that possesses almost all advantages of the multicarrier OFDM technique (such as high spectral efficiency, flexible bandwidth allocation, low sampling rate and low-complexity equalization). In particular, we consider the optical DFT-spread OFDM system with polarization division multiplexing (PDM) that employs a tone-by-tone linear minimum mean square error (MMSE) equalizer. We show that such a system offers a much lower peak-to-average power ratio (PAPR) performance as well as better bit error rate (BER) performance compared with the optical OFDM system that employs amplitude clipping.Comment: This idea was originally submitted at Nov. 28th, 2009. After many times of rejection and resubmission, it was finally accepted by the journal of Advances in Optical Technologie