An OFDM Signal Identification Method for Wireless Communications Systems

Distinction of OFDM signals from single carrier signals is highly important for adaptive receiver algorithms and signal identification applications. OFDM signals exhibit Gaussian characteristics in time domain and fourth order cumulants of Gaussian distributed signals vanish in contrary to the cumulants of other signals. Thus fourth order cumulants can be utilized for OFDM signal identification. In this paper, first, formulations of the estimates of the fourth order cumulants for OFDM signals are provided. Then it is shown these estimates are affected significantly from the wireless channel impairments, frequency offset, phase offset and sampling mismatch. To overcome these problems, a general chi-square constant false alarm rate Gaussianity test which employs estimates of cumulants and their covariances is adapted to the specific case of wireless OFDM signals. Estimation of the covariance matrix of the fourth order cumulants are greatly simplified peculiar to the OFDM signals. A measurement setup is developed to analyze the performance of the identification method and for comparison purposes. A parametric measurement analysis is provided depending on modulation order, signal to noise ratio, number of symbols, and degree of freedom of the underlying test. The proposed method outperforms statistical tests which are based on fixed thresholds or empirical values, while a priori information requirement and complexity of the proposed method are lower than the coherent identification techniques

Blind Estimation of OFDM System Parameters for Automatic Signal Identification

Orthogonal frequency division multiplexing (OFDM) has gained worldwide popular­ ity in broadband wireless communications recently due to its high spectral efficiency and robust performance in multipath fading channels. A growing trend of smart receivers which can support and adapt to multiple OFDM based standards auto­ matically brings the necessity of identifying different standards by estimating OFDM system parameters without a priori information. Consequently, blind estimation and identification of OFDM system parameters has received considerable research atten­ tions. Many techniques have been developed for blind estimation of various OFDM parameters, whereas estimation of the sampling frequency is often ignored. Further­ more, the estimated sampling frequency of an OFDM signal has to be very accurate for data recovery due to the high sensitivity of OFDM signals to sampling clock offset. To address the aforementioned problems, we propose a two-step cyclostation- arity based algorithm with low computational complexity to precisely estimate the sampling frequency of a received oversampled OFDM signal. With this estimated sampling frequency and oversampling ratio, other OFDM system parameters, i.e., the number of subcarriers, symbol duration and cyclic prefix (CP) length can be es­ timated based on the cyclic property from CP sequentially. In addition, modulation scheme used in the OFDM can be classified based on the higher-order statistics (HOS) of the frequency domain OFDM signal. All the proposed algorithms are verified by a lab testing system including a vec­ tor signal generator, a spectrum analyzer and a high speed digitizer. The evaluation results confirm the high precision and efficacy of the proposed algorithm in realistic scenarios

Advanced classification of OFDM and MIMO signals with enhanced second order cyclostationarity detection

With the emergence of cognitive radio and the introduction of new modulation techniques such as OFDM and MIMO, the problem of Modulation Classification (MC) becomes more challenging and complicated. In the first part of the thesis, we explore the automatic modulation classification to blindly distinguish OFDM from single carrier signals. We use the fourth order cumulants; an approach which in the past has been also applied to classify single carrier signals. A blind OFDM parameter estimation scheme was then followed, which includes the estimation of number of subcarriers, CP length, timing and frequency offset and the oversampling factor for the OFDM signal. For the second part of the thesis, we improve the statistical signal processing techniques that were used in the first part. Particularly, the second order cyclostationarity based methods have been examined and improved. Based on the fact that most of the cyclostationary communication signals has a real cyclostationary part and a complex non-cyclostaionary part, we suggest an approach that enhance the second order cyclostationarity and hence increase its probability of detection. Using such improved second-order cyclostationarity, we present an improved synchronization method based on second order cyclostationarity. With the proposed approach, it is shown that the timing estimator, is independent of the frequency offset estimator, and therefore performs better than the previously proposed class of blind synchronization methods. To negate the dependence of the blind synchronization scheme on the prior knowledge of the raised cosine pulse shaping filters, we proposed a blind roll-off factor estimator based on the second order cyclostationarity. Last, we address the MIMO classification problem, wherein we estimate the number of transmitting antennas. Here the second order cyclostationarity test has been applied in distinguishing STC from BLAST modulation

Automatic classification of digital communication signal modulations

This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel UniversityAutomatic modulation classification detects the modulation type of received communication signals. It has important applications in military scenarios to facilitate jamming, intelligence, surveillance, and threat analysis. The renewed interest from civilian scenes has been fuelled by the development of intelligent communications systems such as cognitive radio and software defined radio. More specifically, it is complementary to adaptive modulation and coding where a modulation can be deployed from a set of candidates according to the channel condition and system specification for improved spectrum efficiency and link reliability. In this research, we started by improving some existing methods for higher classification accuracy but lower complexity. Machine learning techniques such as k-nearest neighbour and support vector machine have been adopted for simplified decision making using known features. Logistic regression, genetic algorithm and genetic programming have been incorporated for improved classification performance through feature selection and combination. We have also developed a new distribution test based classifier which is tailored for modulation classification with the inspiration from Kolmogorov-Smirnov test. The proposed classifier is shown to have improved accuracy and robustness over the standard distribution test. For blind classification in imperfect channels, we developed the combination of minimum distance centroid estimator and non-parametric likelihood function for blind modulation classification without the prior knowledge on channel noise. The centroid estimator provides joint estimation of channel gain and carrier phase o set where both can be compensated in the following nonparametric likelihood function. The non-parametric likelihood function, in the meantime, provide likelihood evaluation without a specifically assumed noise model. The combination has shown to have higher robustness when different noise types are considered. To push modulation classification techniques into a more timely setting, we also developed the principle for blind classification in MIMO systems. The classification is achieved through expectation maximization channel estimation and likelihood based classification. Early results have shown bright prospect for the method while more work is needed to further optimize the method and to provide a more thorough validation.School of Engineering and Design Brunel University London, the Faculty of Engineering University of Liverpool, and the University of Liverpool Graduate Association (Hong Kong)

Channel estimation for SISO and MIMO OFDM communications systems.

Thesis (Ph.D.)-University of KwaZulu-Natal, Durban, 2010.Telecommunications in the current information age is increasingly relying on the wireless link. This is because wireless communication has made possible a variety of services ranging from voice to data and now to multimedia. Consequently, demand for new wireless capacity is growing rapidly at a very alarming rate. In a bid to cope with challenges of increasing demand for higher data rate, better quality of service, and higher network capacity, there is a migration from Single Input Single Output (SISO) antenna technology to a more promising Multiple Input Multiple Output (MIMO) antenna technology. On the other hand, Orthogonal Frequency Division Multiplexing (OFDM) technique has emerged as a very popular multi-carrier modulation technique to combat the problems associated with physical properties of the wireless channels such as multipath fading, dispersion, and interference. The combination of MIMO technology with OFDM techniques, known as MIMO-OFDM Systems, is considered as a promising solution to enhance the data rate of future broadband wireless communication Systems. This thesis addresses a major area of challenge to both SISO-OFDM and MIMO-OFDM Systems; estimation of accurate channel state information (CSI) in order to make possible coherent detection of the transmitted signal at the receiver end of the system. Hence, the first novel contribution of this thesis is the development of a low complexity adaptive algorithm that is robust against both slow and fast fading channel scenarios, in comparison with other algorithms employed in literature, to implement soft iterative channel estimator for turbo equalizer-based receiver for single antenna communication Systems. Subsequently, a Fast Data Projection Method (FDPM) subspace tracking algorithm is adapted to derive Channel Impulse Response Estimator for implementation of Decision Directed Channel Estimation (DDCE) for Single Input Single Output - Orthogonal Frequency Division Multiplexing (SISO-OFDM) Systems. This is implemented in the context of a more realistic Fractionally Spaced-Channel Impulse Response (FS-CIR) channel model, as against the channel characterized by a Sample Spaced-Channel Impulse Response (SS)-CIR widely assumed by other authors. In addition, a fast convergence Variable Step Size Normalized Least Mean Square (VSSNLMS)-based predictor, with low computational complexity in comparison with others in literatures, is derived for the implementation of the CIR predictor module of the DDCE scheme. A novel iterative receiver structure for the FDPM-based Decision Directed Channel Estimation scheme is also designed for SISO-OFDM Systems. The iterative idea is based on Turbo iterative principle. It is shown that improvement in the performance can be achieved with the iterative DDCE scheme for OFDM system in comparison with the non iterative scheme. Lastly, an iterative receiver structure for FDPM-based DDCE scheme earlier designed for SISO OFDM is extended to MIMO-OFDM Systems. In addition, Variable Step Size Normalized Least Mean Square (VSSNLMS)-based channel transfer function estimator is derived in the context of MIMO Channel for the implementation of the CTF estimator module of the iterative Decision Directed Channel Estimation scheme for MIMO-OFDM Systems in place of linear minimum mean square error (MMSE) criterion. The VSSNLMS-based channel transfer function estimator is found to show improved MSE performance of about -4 MSE (dB) at SNR of 5dB in comparison with linear MMSE-based channel transfer function estimator

A Novel Graph Neural Network-based Framework for Automatic Modulation Classification in Mobile Environments

Automatic modulation classification (AMC) refers to a signal processing procedure through which the modulation type and order of an observed signal are identified without any prior information about the communications setup. AMC has been recognized as one of the essential measures in various communications research fields such as intelligent modem design, spectrum sensing and management, and threat detection. The research literature in AMC is limited to accounting only for the noise that affects the received signal, which makes their models applicable for stationary environments. However, a more practical and real-world application of AMC can be found in mobile environments where a higher number of distorting effects is present. Hence, in this dissertation, we have developed a solution in which the distorting effects of mobile environments, e.g., multipath, Doppler shift, frequency, phase and timing offset, do not influence the process of identifying the modulation type and order classification. This solution has two major parts: recording an emulated dataset in mobile environments with real-world parameters (MIMOSigRef-SD), and developing an efficient feature-based AMC classifier. The latter itself includes two modules: feature extraction and classification. The feature extraction module runs upon a dynamic spatio-temporal graph convolutional neural network architecture, which tackles the challenges of statistical pattern recognition of received samples and assignment of constellation points. After organizing the feature space in the classification module, a support vector machine is adopted to be trained and perform classification operation. The designed robust feature extraction modules enable the developed solution to outperform other state-of-the-art AMC platforms in terms of classification accuracy and efficiency, which is an important factor for real-world implementations. We validated the performance of our developed solution in a prototyping and field-testing process in environments similar to MIMOSigRef-SD. Therefore, taking all aspects into consideration, our developed solution is deemed to be more practical and feasible for implementation in the next generations of communication systems. Advisor: Hamid R. Sharif-Kashan