Channel Hardening-Exploiting Message Passing (CHEMP) Receiver in Large-Scale MIMO Systems

In this paper, we propose a MIMO receiver algorithm that exploits {\em channel hardening} that occurs in large MIMO channels. Channel hardening refers to the phenomenon where the off-diagonal terms of the ${\bf H}^H{\bf H}$ matrix become increasingly weaker compared to the diagonal terms as the size of the channel gain matrix ${\bf H}$ increases. Specifically, we propose a message passing detection (MPD) algorithm which works with the real-valued matched filtered received vector (whose signal term becomes ${\bf H}^T{\bf H}{\bf x}$, where ${\bf x}$ is the transmitted vector), and uses a Gaussian approximation on the off-diagonal terms of the ${\bf H}^T{\bf H}$ matrix. We also propose a simple estimation scheme which directly obtains an estimate of ${\bf H}^T{\bf H}$ (instead of an estimate of ${\bf H}$), which is used as an effective channel estimate in the MPD algorithm. We refer to this receiver as the {\em channel hardening-exploiting message passing (CHEMP)} receiver. The proposed CHEMP receiver achieves very good performance in large-scale MIMO systems (e.g., in systems with 16 to 128 uplink users and 128 base station antennas). For the considered large MIMO settings, the complexity of the proposed MPD algorithm is almost the same as or less than that of the minimum mean square error (MMSE) detection. This is because the MPD algorithm does not need a matrix inversion. It also achieves a significantly better performance compared to MMSE and other message passing detection algorithms using MMSE estimate of ${\bf H}$. We also present a convergence analysis of the proposed MPD algorithm. Further, we design optimized irregular low density parity check (LDPC) codes specific to the considered large MIMO channel and the CHEMP receiver through EXIT chart matching. The LDPC codes thus obtained achieve improved coded bit error rate performance compared to off-the-shelf irregular LDPC codes

List-Based Detection and Selection of Access Points in Cell-Free Massive MIMO Networks

This paper proposes a cell-free massive multiple-input multiple-output (CF-mMIMO) architecture with joint list-based detection with soft interference cancelation (soft-IC) and access points (APs) selection. In particular, we derive a new closed-form expression for the minimum mean-square error receive filter while taking the uplink transmit powers and APs selection into account. This is achieved by optimizing the receive combining vector by minimizing the mean square error between the detected symbol estimate and transmitted symbol, after canceling the multi-user interference (MUI). By using low-density parity check (LDPC) codes, an iterative detection and decoding (IDD) scheme based on a message passing is devised. In order to perform joint detection at the central processing unit (CPU), the access points locally estimate the channel and send their received sample data to the CPU via the front haul links. In order to enhance the system's bit error rate performance, the detected symbols are iteratively exchanged between the joint detector and the LDPC decoder in log likelihood ratio form. Furthermore, we draw insights into the derived detector as the number of IDD iterations increase. Finally, the proposed list detector is compared with existing detection techniques.Comment: 7 pages, 4 figures. arXiv admin note: text overlap with arXiv:2210.1290

Large-Scale MIMO Detection for 3GPP LTE: Algorithms and FPGA Implementations

Large-scale (or massive) multiple-input multiple-output (MIMO) is expected to be one of the key technologies in next-generation multi-user cellular systems, based on the upcoming 3GPP LTE Release 12 standard, for example. In this work, we propose - to the best of our knowledge - the first VLSI design enabling high-throughput data detection in single-carrier frequency-division multiple access (SC-FDMA)-based large-scale MIMO systems. We propose a new approximate matrix inversion algorithm relying on a Neumann series expansion, which substantially reduces the complexity of linear data detection. We analyze the associated error, and we compare its performance and complexity to those of an exact linear detector. We present corresponding VLSI architectures, which perform exact and approximate soft-output detection for large-scale MIMO systems with various antenna/user configurations. Reference implementation results for a Xilinx Virtex-7 XC7VX980T FPGA show that our designs are able to achieve more than 600 Mb/s for a 128 antenna, 8 user 3GPP LTE-based large-scale MIMO system. We finally provide a performance/complexity trade-off comparison using the presented FPGA designs, which reveals that the detector circuit of choice is determined by the ratio between BS antennas and users, as well as the desired error-rate performance.Comment: To appear in the IEEE Journal of Selected Topics in Signal Processin

Massive Access in Media Modulation Based Massive Machine-Type Communications

The massive machine-type communications (mMTC) paradigm based on media modulation in conjunction with massive MIMO base stations (BSs) is emerging as a viable solution to support the massive connectivity for the future Internet-of-Things, in which the inherent massive access at the BSs poses significant challenges for device activity and data detection (DADD). This paper considers the DADD problem for both uncoded and coded media modulation based mMTC with a slotted access frame structure, where the device activity remains unchanged within one frame. Specifically, due to the slotted access frame structure and the adopted media modulated symbols, the access signals exhibit a doubly structured sparsity in both the time domain and the modulation domain. Inspired by this, a doubly structured approximate message passing (DS-AMP) algorithm is proposed for reliable DADD in the uncoded case. Also, we derive the state evolution of the DS-AMP algorithm to theoretically characterize its performance. As for the coded case, we develop a bit-interleaved coded media modulation scheme and propose an iterative DS-AMP (IDS-AMP) algorithm based on successive inference cancellation (SIC), where the signal components associated with the detected active devices are successively subtracted to improve the data decoding performance. In addition, the channel estimation problem for media modulation based mMTC is discussed and an efficient data-aided channel state information (CSI) update strategy is developed to reduce the training overhead in block fading channels. Finally, simulation results and computational complexity analysis verify the superiority of the proposed algorithms in both uncoded and coded cases. Also, our results verify the validity of the proposed data-aided CSI update strategy.Comment: Accepted by IEEE Transactions on Wireless Communications. The codes and some other materials about this work may be available at https://gaozhen16.github.i

Review of Recent Trends

This work was partially supported by the European Regional Development Fund (FEDER), through the Regional Operational Programme of Centre (CENTRO 2020) of the Portugal 2020 framework, through projects SOCA (CENTRO-01-0145-FEDER-000010) and ORCIP (CENTRO-01-0145-FEDER-022141). Fernando P. Guiomar acknowledges a fellowship from “la Caixa” Foundation (ID100010434), code LCF/BQ/PR20/11770015. Houda Harkat acknowledges the financial support of the Programmatic Financing of the CTS R&D Unit (UIDP/00066/2020).MIMO-OFDM is a key technology and a strong candidate for 5G telecommunication systems. In the literature, there is no convenient survey study that rounds up all the necessary points to be investigated concerning such systems. The current deeper review paper inspects and interprets the state of the art and addresses several research axes related to MIMO-OFDM systems. Two topics have received special attention: MIMO waveforms and MIMO-OFDM channel estimation. The existing MIMO hardware and software innovations, in addition to the MIMO-OFDM equalization techniques, are discussed concisely. In the literature, only a few authors have discussed the MIMO channel estimation and modeling problems for a variety of MIMO systems. However, to the best of our knowledge, there has been until now no review paper specifically discussing the recent works concerning channel estimation and the equalization process for MIMO-OFDM systems. Hence, the current work focuses on analyzing the recently used algorithms in the field, which could be a rich reference for researchers. Moreover, some research perspectives are identified.publishersversionpublishe

A tutorial on the characterisation and modelling of low layer functional splits for flexible radio access networks in 5G and beyond

The centralization of baseband (BB) functions in a radio access network (RAN) towards data processing centres is receiving increasing interest as it enables the exploitation of resource pooling and statistical multiplexing gains among multiple cells, facilitates the introduction of collaborative techniques for different functions (e.g., interference coordination), and more efficiently handles the complex requirements of advanced features of the fifth generation (5G) new radio (NR) physical layer, such as the use of massive multiple input multiple output (MIMO). However, deciding the functional split (i.e., which BB functions are kept close to the radio units and which BB functions are centralized) embraces a trade-off between the centralization benefits and the fronthaul costs for carrying data between distributed antennas and data processing centres. Substantial research efforts have been made in standardization fora, research projects and studies to resolve this trade-off, which becomes more complicated when the choice of functional splits is dynamically achieved depending on the current conditions in the RAN. This paper presents a comprehensive tutorial on the characterisation, modelling and assessment of functional splits in a flexible RAN to establish a solid basis for the future development of algorithmic solutions of dynamic functional split optimisation in 5G and beyond systems. First, the paper explores the functional split approaches considered by different industrial fora, analysing their equivalences and differences in terminology. Second, the paper presents a harmonized analysis of the different BB functions at the physical layer and associated algorithmic solutions presented in the literature, assessing both the computational complexity and the associated performance. Based on this analysis, the paper presents a model for assessing the computational requirements and fronthaul bandwidth requirements of different functional splits. Last, the model is used to derive illustrative results that identify the major trade-offs that arise when selecting a functional split and the key elements that impact the requirements.This work has been partially funded by Huawei Technologies. Work by X. Gelabert and B. Klaiqi is partially funded by the European Union's Horizon Europe research and innovation programme (HORIZON-MSCA-2021-DN-0) under the Marie Skłodowska-Curie grant agreement No 101073265. Work by J. Perez-Romero and O. Sallent is also partially funded by the Smart Networks and Services Joint Undertaking (SNS JU) under the European Union’s Horizon Europe research and innovation programme under Grant Agreements No. 101096034 (VERGE project) and No. 101097083 (BeGREEN project) and by the Spanish Ministry of Science and Innovation MCIN/AEI/10.13039/501100011033 under ARTIST project (ref. PID2020-115104RB-I00). This last project has also funded the work by D. Campoy.Peer ReviewedPostprint (author's final draft

Variational channel estimation with tempering: An artificial intelligence algorithm for wireless intelligent networks

This article belongs to the Special Issue Trends on Edge Computing and Artificial Intelligence for Next Generation Sensor Network