35,325 research outputs found
Comment on "Mass and K Lambda coupling of N*(1535)"
It is argued in [1] that when the strong coupling to the K Lambda channel is
considered, Breit-Wigner mass of the lightest orbital excitation of the nucleon
N(1535) shifts to a lower value. The new value turned out to be smaller than
the mass of the lightest radial excitation N(1440), which effectively solved
the long-standing problem of conventional constituent quark models. In this
Comment we show that it is not the Breit-Wigner mass of N(1535) that is
decreased, but its bare mass.
[1] B. C. Liu and B. S. Zou, Phys. Rev. Lett. 96, 042002 (2006).Comment: 3 pages, comment on "Mass and K Lambda coupling of N*(1535)", B. C.
Liu and B. S. Zou, Phys. Rev. Lett. 96, 042002 (2006
Dynamical formation of stable irregular transients in discontinuous map systems
Stable chaos refers to the long irregular transients, with a negative largest
Lyapunov exponent, which is usually observed in certain high-dimensional
dynamical systems. The mechanism underlying this phenomenon has not been well
studied so far. In this paper, we investigate the dynamical formation of stable
irregular transients in coupled discontinuous map systems. Interestingly, it is
found that the transient dynamics has a hidden pattern in the phase space: it
repeatedly approaches a basin boundary and then jumps from the bundary to a
remote region in the phase space. This pattern can be clearly visualized by
measuring the distance sequences between the trajectory and the basin boundary.
The dynamical formation of stable chaos originates from the intersection points
of the discontinuous boundaries and their images. We carry out numerical
experiments to verify this mechanism.Comment: 5 pages, 5 figure
Reply to "Comment on 'Semiquantum-key distribution using less than four quantum states' "
Recently Boyer and Mor pointed out the first conclusion of Lemma 1 in our
original paper is not correct, and therefore, the proof of Theorem 5 based on
Lemma 1 is wrong. Furthermore, they gave a direct proof for Theorem 5 and
affirmed the conclusions in our original paper. In this reply, we admit the
first conclusion of Lemma 1 is not correct, but we need to point out the second
conclusion of Lemma 1 is correct. Accordingly, all the proofs for Lemma 2,
Lemma 3, and Theorems 3--6 are only based on the the second conclusion of Lemma
1 and therefore are correct.Comment: 1 pag
Recommended from our members
The effect of water absorption on the dielectric properties of epoxy nanocomposites
In this research, the influence of water absorption on the dielectric properties of epoxy resin and epoxy micro-composites and nano-composites filled with silica has been studied. Nanocomposites were found to absorb significantly more water than unfilled epoxy. However, the microcomposite absorbed less water than unfilled epoxy: corresponding to reduced proportion of the epoxy in this composite. The glass transition temperatures of all the samples were measured by both differential scanning calorimetry and dielectric spectroscopy. The Tg decreased as the water absorption increased and, in all cases, corresponded to a drop of approximately 20K as the humidity was increased from 0% to 100%. This implied that for all the samples, the amount of water in the resin component of the composites was almost identical. It was concluded that the extra water found in the nanocomposites was located around the surface of the nanoparticles. This was confirmed by measuring the water uptake, and the swelling and density change, as a function of humidity as water was absorbed. The water shell model, originally proposed by Lewis and developed by Tanaka, has been further developed to explain low frequency dielectric spectroscopy results in which percolation of charge carriers through overlapping water shells was shown to occur. This has been discussed in terms of a percolation model. At 100% relative humidity, water is believed to surround the nanoparticles to a depth of approximately 5 monolayers. A second layer of water is proposed that is dispersed by sufficiently concentrated to be conductive; this may extend for approximately 25 nm. If all the water had existed in a single layer surrounding a nanoparticle, this layer would have been approximately 3 to 4 nm thick at 100%. This "characteristic thickness" of water surrounding a given size of nanoparticle appeared to be independent of the concentration of nanoparticles but approximately proportional to water uptake. Filler particles that have surfaces that are functionalized to be hydrophobic considerably reduce the amount of water absorbed in nanocomposites under the same conditions of humidity. Comments are made on the possible effect on electrical aging
Recommended from our members
A "water shell" model for the dielectric properties of hydrated silica-filled epoxy nano-composites
The electrical properties of epoxy resin have been studied as a function of hydration. The epoxy was studied in an un-filled state, filled with 40 µm SiO2 particles, and filled with 50 nm SiO2 particles. The relative humidity was controlled by saturated salt solutions at ambient temperatures from 298-353 K. Measurements were made using dielectric spectroscopy over the frequency range 10-3-105 Hz. The hydration isotherm (i.e. the mass uptake of water) was established by measuring the mass as a function of relative humidity (RH). It was found that the nanocomposites absorb up to 60% more water than the unfilled and micro-filled epoxies. Dielectric spectroscopy shows different conduction and quasi-DC behaviours at very low frequencies (<10-2 Hz) with activation energies dependent on the hydration and temperature. These observations have led to the development of a “water shell” model to explain this phenomenon
Recommended from our members
The Influence of Water on Dielectric Behavior of Silica-filled Epoxy Nano-composites and Percolation Phenomenon
The dielectric properties of epoxy resin were studied as a function of hydration by dielectric spectroscopy. The dielectric spectroscopy measurements show different conduction and quasi-DC behaviors at very low frequencies (<10-2 Hz) with activation energies dependent on the hydration. These observations lead to the development of a model in which a “water shell” is formed around the nano-particles. The multiple shell model, originally proposed by Lewis and developed by Tanaka, has been further developed to explain low frequency dielectric spectroscopy results in which percolation of charge carriers through overlapping water shells was shown to occur. At 100% relative humidity, water is believed to surround the nanoparticles to a depth of approximately 10 monolayers as the first layer. A second layer of water is proposed that is dispersed by sufficiently concentrated to be conductive. If all the water had existed in a single layer surrounding a nanoparticle, this layer would have been approximately 5 nm thick at 100% RH. Filler particles that have surfaces that are functionalized to be hydrophobic considerably reduce the amount of water absorbed in nanocomposites under the same conditions of humidity. PEA results show that the wetted epoxy specimens have a higher threshold field of space charge accumulation than such dry specimens since water enhances charge decay
- …