Preliminary design and cost of a 1-megawatt solar-pumped iodide laser space-to-space transmission station

A preliminary conceptual design of a space-based solar pumped iodide laser emitting 1 megawatt of laser power for space-to-space power transmission is described. A near parabolic solar collector focuses sunlight onto the t-C4F9I (perfluoro-t butyl iodide) lasant within a transverse flow optical cavity. Using waste heat, a thermal system was designed to supply compressor and auxiliary power. System components were designed with weight and cost estimates assigned. Although cost is very approximate, the cost comparison of individual system components leads to valuable insights for future research. In particular, it was found that laser efficiency was not a dominant cost or weight factor, the dominant factor being the laser cavity and laser transmission optics. The manufacturing cost was approx. two thirds of the total cost with transportation to orbit the remainder. The flowing nonrenewable lasant comprised 20% of the total life cycle cost of the system and thus was not a major cost factor. The station mass was 92,000 kg without lasant, requiring approx. four shuttle flights to low Earth orbit where an orbital transfer vehicle will transport it to the final altitude of 6378 km

Comparison of electrically driven lasers for space power transmission

High-power lasers in space could provide power for a variety of future missions such as spacecraft electric power requirements and laser propulsion. This study investigates four electrically pumped laser systems, all scaled to 1-MW laser output, that could provide power to spacecraft. The four laser systems are krypton fluoride, copper vapor, laser diode array, and carbon dioxide. Each system was powered by a large solar photovoltaic array which, in turn, provided power for the appropriate laser power conditioning subsystem. Each system was block-diagrammed, and the power and efficiency were found for each subsystem block component. The copper vapor system had the lowest system efficiency (6 percent). The CO2 laser was found to be the most readily scalable but has the disadvantage of long laser wavelength

Efficient solar cells by space processing

Thin films of electron beam evaporated silicon were deposited on molybdenum, tantalum, tungsten and molybdenum disilicide under ultrahigh vacuum conditions. Mass spectra from a quadrapole residual gas analyzer were used to determine the partial pressure of 13 residual gases during each processing step. Surface contamination and interdiffusion were monitored by in situ Auger electron spectrometry. The presence of phosphorus in the silicon was responsible for attaining elevated temperatures with silicide formations. Heteroepitaxial silicon growth was sensitive to the presence of oxygen during deposition, the rate and length of deposition as well as the substrate orientation

Scanning Tunneling Spectroscopy and Vortex Imaging in the Iron-Pnictide Superconductor BaFe1.8_{1.8}Co0.2_{0.2}As2_2

We present an atomic resolution scanning tunneling spectroscopy study of superconducting BaFe$_{1.8}$Co$_{0.2}$As$_2$ single crystals in magnetic fields up to $9 \text{Tesla}$. At zero field, a single gap with coherence peaks at $\overline{\Delta}=6.25 \text{meV}$ is observed in the density of states. At $9 \text{T}$ and $6 \text{T}$, we image a disordered vortex lattice, consistent with isotropic, single flux quantum vortices. Vortex locations are uncorrelated with strong scattering surface impurities, demonstrating bulk pinning. The vortex-induced sub-gap density of states fits an exponential decay from the vortex center, from which we extract a coherence length $\xi=27.6\pm 2.9 \text{\AA}$, corresponding to an upper critical field $H_{c2}=43 \text{T}$.Comment: 4 pages, 4 figure

Sampling Time Effects for Persistence and Survival in Step Structural Fluctuations

The effects of sampling rate and total measurement time have been determined for single-point measurements of step fluctuations within the context of first-passage properties. Time dependent STM has been used to evaluate step fluctuations on Ag(111) films grown on mica as a function of temperature (300-410 K), on screw dislocations on the facets of Pb crystallites at 320K, and on Al-terminated Si(111) over the temperature range 770K - 970K. Although the fundamental time constant for step fluctuations on Ag and Al/Si varies by orders of magnitude over the temperature ranges of measurement, no dependence of the persistence amplitude on temperature is observed. Instead, the persistence probability is found to scale directly with t/Dt where Dt is the time interval used for sampling. Survival probabilities show a more complex scaling dependence which includes both the sampling interval and the total measurement time tm. Scaling with t/Dt occurs only when Dt/tm is a constant. We show that this observation is equivalent to theoretical predictions that the survival probability will scale as Dt/L^z, where L is the effective length of a step. This implies that the survival probability for large systems, when measured with fixed values of tm or Dt should also show little or no temperature dependence.Comment: 27 pages, 10 figure

Evidence for high levels of vertical transmission in Toxoplasma gondii

Toxoplasma gondii is a highly ubiquitous and prevalent parasite. Despite the cat being the only definitive host, it is found in almost all geographical areas and warm blooded animals. Three routes of transmission are recognised: ingestion of oocysts shed by the cat, carnivory and congenital transmission. In natural populations, it is difficult to establish the relative importance of these routes. This paper reviews recent work in our laboratory which suggests that congenital transmission may be much more important than previously thought. Using PCR detection of the parasite, studies in sheep show that congenital transmission may occur in as many as 66% of pregnancies. Furthermore, in families of sheep on the same farm, exposed to the same sources of oocysts, significant divergent prevalences of Toxoplasma infection and abortion are found between different families. The data suggest that breeding from infected ewes increases the risk of subsequent abortion and infection in lambs. Congenital transmission rates in a natural population of mice were found to be 75%. Interestingly, congenital transmission rates in humans were measured at 19.8%. The results presented in these studies differ from those of other published studies and suggest that vertical transmission may be much more important than previously thought

Practice pointer: Using the new UK-WHO growth charts

The new UK growth charts for children aged 0-4 years (designed using data from the new WHO standards) describe the optimal pattern of growth for all children, rather than the prevailing pattern in the UK (as with previous charts). The new charts are suitable for all ethnic groups and set breast feeding as the norm. UK children match the new charts well for length and height, but after age 6 months fewer children will be below the 2nd centile for weight or show weight faltering, and more will be above the 98th centile. The new charts look different: they have a separate preterm section, no lines between 0 and 2 weeks, and the 50th percentile is no longer emphasised. The charts give clear instructions on gestational correction, and there is a new chart for infants born before 32 weeks’ gestation. The instructions advise on when and how to measure and when a measurement or growth pattern is outside the normal range. The charts include a “look-up” tool for determining the body mass index centile from height and weight centiles without calculation and aid for predicting adult height. The charts and supporting educational materials can be downloaded from www.growthcharts.rcpch.ac.u