Applying XP Ideas Formally: The Story Card and Extreme X-Machines

By gathering requirements on story cards extreme programming (XP) makes requirements collection easy. However it is less clear how the story cards are translated into a �finished product. We propose that a formal specification method based on X-Machines can be used to direct this transition. Extreme X-Machines �t in to the XP method well, without large overheads in design and maintenance. We also investigate how such machines adapt to change in the story cards and propose how this could be further enhanced

Combined VHF Dopplar radar and airborne (CV-990) measurements of atmospheric winds on the mesoscale

Hourly measurements of wind speed and direction obtained using two wind profiling Doppler radars during two prolonged jet stream occurrences over western Pennsylvania were analyzed. In particular, the time-variant characteristics of derived shear profiles were examined. To prevent a potential loss of structural detail and retain statistical significance, data from both radars were stratified into categories based on the location data from the Penn State radar were also compared to data from Pittsburgh radiosondes. Profiler data dropouts were studied in an attempt to determine possible reasons for the apparently reduced performance of profiling radars operating beneath a jet stream. Temperature profiles for the radar site were obtained using an interpolated temperature and dewpoint temperature sounding procedure developed at Penn State. The combination of measured wind and interpolated temperature profiles allowed Richardson number profiles to be generated for the profiler sounding volume. Both Richardson number and wind shear statistics were then examined along with pilot reports of turbulence in the vicinity of the profiler

An evaluation of errors observed in the measurement of low wind velocities

Measurements of low wind velocities (the absolute value of V sub H is approx. equal to 6 m/s) with a VHF wind profiler can be difficult if ground clutter or other biases in the system dominate in altering the position of the perceived peak in the calculated power spectrum. A variety of methods for ground clutter suppression are used in profiler systems today (Cornish, 1983). An editing method called zero suppression takes the spectral value of selectable number of points (N) on each side of 0 velocity (one point on either side, in this study) and sets them equal to the mean value of the points exterior to the specified N points on either side of 0. Analysis done with the PSU VHF(1) radar, shows that this zero-suppression method can systematically bias horizontal wings V sub H below 6 m/s. With the zero suppression, an artificial increase in absolute wind velocities occurs when the spectral peaks fall within the plus or minus N points of the FFT (personal communication, Strauch, 1985). It was also established that the method artificially decreases the absolute wind velocities inferred from spectral peaks that are outside but near the suppressed region. Comparisons of wind profiles observed with and without zero suppression are given. The range of the biased velocities extends to about plus or minus 6 m/s. Biases have been deduced to be as much as 2 m/s, but more commonly they are on the order of 1.0 m/s

The Life of a Vortex Knot

The idea that the knottedness (hydrodynamic Helicity) of a fluid flow is conserved has a long history in fluid mechanics. The quintessential example of a knotted flow is a knotted vortex filament, however, owing to experimental difficulties, it has not been possible until recently to directly generate knotted vortices in real fluids. Using 3D printed hydrofoils and high-speed laser scanning tomography, we generate vortex knots and links and measure their subsequent evolution. In both cases, we find that the vortices deform and stretch until a series of vortex reconnections occurs, eventually resulting several disjoint vortex rings. This article accompanies a fluid dynamics video entered into the Gallery of Fluid Motion at the 66th Annual Meeting of the APS Division of Fluid Dynamics.Comment: Videos are included; this submission is part of the DFD Gallery of Fluid Motio

Comparison of FFP predictions with measurements of a low-frequency signal propagated in the atmosphere

An experimental study of low-frequency propagation over a distance of 770 m was previously reported (J. Acoust. Soc. Am. Suppl. 1 86, S120 (1989)). For that study, sound speed profiles were reconstructed entirely from surface-layer micrometeorological data. When the acoustic data were compared with theoretical predictions from a fast field program (FFP), it was found that the FFP underpredicted sound levels measured in a shadow zone. Here, the effect on the predictions of including meteorological data for heights greater than the surface layer, i.e., wind profiles measured by a Doppler sodar, is discussed. Vertical structure of turbulence is simulated by stochastically perturbing the mean profiles, and the agreement between the acoustic data and FFP predictions is improved

Network ST radar and related measurements at Pennsylvania State University

Mesoscale meteorological measurements, analysis and prediction are some of the principal areas of research in the Department of Meteorology at Penn State. In anticipation of a staged turn-on of the three systems during the Summer and Fall of 1984, the nonconstruction-related efforts have focused on the software development necessary to allow essentially immediate use of network data. A 16-bit microcomputer has been programmed to serve as the network controller, communications interface and, at least for real-time purposes, the operational display system. Insofar as possible we have in this task built upon our substantial accumulated experience in working with the processing and display of Doppler sodar system signals. Once the radar-derived wind and turbulence profiles are communicated to the various interconnected Departmental computers they become just one component of a comprehensive data base which can be applied to a diverse set of ongoing basic and operational research programs

Interpretation of combined wind profiler and aircraft-measured tropospheric winds and clear air turbulence

In the first experiment, it was found that wind profilers are far better suited for the detailed examination of jet stream structure than are weather balloons. The combination of good vertical resolution with not previously obtained temporal resolution reveals structural details not seen before. Development of probability-derived shear values appears possible. A good correlation between pilot reports of turbulence and wind shear was found. In the second experiment, hourly measurements of wind speed and direction obtained using two wind profiling Doppler radars during two prolonged jet stream occurrences over western Pennsylvania were analyzed. In particular, the time-variant characteristics of derived shear profiles were examined. Profiler data dropouts were studied in an attempt to determine possible reasons for the apparently reduced performance of profiling radar operating beneath a jet stream. Richardson number and wind shear statistics were examined along with pilot reports of turbulence in the vicinity of the profiler

Study on utilization of advanced composites in fuselage structures of large transports

The potential for utilizing advanced composites in fuselage structures of large transports was assessed. Six fuselage design concepts were selected and evaluated in terms of structural performance, weight, and manufacturing development and costs. Two concepts were selected that merit further consideration for composite fuselage application. These concepts are: (1) a full depth honeycomb design with no stringers, and (2) an I section stringer stiffened laminate skin design. Weight reductions due to applying composites to the fuselages of commercial and military transports were calculated. The benefits of applying composites to a fleet of military transports were determined. Significant technology issues pertinent to composite fuselage structures were identified and evaluated. Program plans for resolving the technology issues were developed

Mesoscale variability of free tropospheric humidity near San Nicolas Island during FIRE

Humidity variability at the top of the marine boundary layer (MBL) and in the free troposphere was examined using a variety of measurements taken on and around San Nicolas Island (SNI) during the FIRE IFO in July, 1987. Doppler wind profiler reflectivity recorded at two minute time resolution has provided the most continuous record and detail of small scale humidity fluctuations. Rawinsonde data were available from both an island site and the research vessel Point Sur. The information extractable from these sources is somewhat limited due to the frequency of launches (3 to 4/day at SNI and 6/day on the Point Sur). Some additional data were available from instrumented aircraft although scheduling flights in the neighborhood of the island was difficult due to restrictions on the air space. Other relevant data were collected at SNI near the radar and rawinsonde launch sites. A continuous record of cloud base altitude was logged by a ceilometer. Doppler acoustic sounder (sodar) reflectivity data provided a good record of inversion height. The sodar also monitored turbulent temperature fluctuations in the MBL. A small ground station recorded hourly averages of solar irradiance and downward longwave irradiance. The analysis in progress of the various data sets for two adjacent two day periods from 11 July to 14 July is described. The earlier period was chosen because the marine inversion was unusually high and there was increased frequency of rawinsonde launches at SNI. The later period was chosen because of the significant descent with time of an elevated inversion indicated by the radar data. Throughout the four day period, but especially in the first half, the turbulent humidity structure calculated from Doppler radar reflectivity shows excellent agreement with humidity profiles evaluated from rawinsonde data