8,152 research outputs found

    Electronic and phononic Raman scattering in detwinned YBa2_2Cu3_3O6.95_{6.95} and Y0.85_{0.85}Ca0.15_{0.15}Ba2_2Cu3_3O6.95_{6.95}: s-wave admixture to the dx2−y2d_{x^2-y^2}-wave order parameter

    Full text link
    Inelastic light (Raman) scattering has been used to study electronic excitations and phonon anomalies in detwinned, slightly overdoped YBa2_2Cu3_3O6.95_{6.95} and moderately overdoped Y0.85_{0.85}Ca0.15_{0.15}Ba2_2Cu3_3O6.95_{6.95} single crystals. In both samples modifications of the electronic pair-breaking peaks when interchanging the a- and b-axis were observed. The lineshapes of several phonon modes involving plane and apical oxygen vibrations exhibit pronounced anisotropies with respect to the incident and scattered light field configurations. Based on a theoretical model that takes both electronic and phononic contributions to the Raman spectra into account, we attribute the anisotropy of the superconductivity-induced changes in the phonon lineshapes to a small s-wave admixture to the dx2−y2d_{x^2-y^2} pair wave-function. Our theory allows us to disentangle the electronic Raman signal from the phononic part and to identify corresponding interference terms. We argue that the Raman spectra are consistent with an s-wave admixture with an upper limit of 20 percent.Comment: accepted in Phys. Rev. B, 11 page

    Buoyancy Effects on Concurrent Flame Spread Over Thick PMMA

    Get PDF
    The flammability of combustible materials in a spacecraft is important for fire safety applications because the conditions in spacecraft environments differ from those on earth. Experimental testing in space is difficult and expensive. However, reducing buoyancy by decreasing ambient pressure is a possible approach to simulate on-earth the burning behavior inside spacecraft environments. The objective of this work is to determine that possibility by studying the effect of pressure on concurrent flame spread, and by comparison with microgravity data, observe up to what point low-pressure can be used to replicate flame spread characteristics observed in microgravity. Specifically, this work studies the effect of pressure and microgravity on upward/concurrent flame spread over 10 mm thick polymethyl methacrylate (PMMA) slabs. Experiments in normal gravity were conducted over pressures ranging between 100 and 40 kPa and a forced flow velocity of 200 mm/s. Microgravity experiments were conducted during NASAs Spacecraft Fire Experiment (Saffire II), on board the Cygnus spacecraft at 100 kPa with an air flow velocity of 200 mm/s. Results show that reductions of pressure slow down the flame spread over the PMMA surface approaching that in microgravity. The data is correlated in terms of a non-dimensional mixed convection analysis that describes the convective heat transferred from the flame to the solid, and the primary mechanism controlling the spread of the flame. The extrapolation of the correlation to low pressures predicts well the flame spread rate obtained in microgravity in the Saffire II experiments. Similar results were obtained by the authors with similar experiments with a thin composite cotton/fiberglass fabric (published elsewhere). Both results suggest that reduced pressure can be used to approximately replicate flame behavior of untested gravity conditions for the burning of thick and thin solids. This work could provide guidance for potential ground-based testing for fire safety design in spacecraft and space habitats

    On Simulating Concurrent Flame Spread in Reduced Gravity by Reducing Ambient Pressure

    Get PDF
    The flammability of combustible materials in spacecraft environments is of importance for fire safety applications because the environmental conditions can greatly differ from those on earth, and a fire in a spacecraft could be catastrophic. Moreover, experimental testing in spacecraft environments can be difficult and expensive, so using ground-based tests to inform microgravity tests is vital. Reducing buoyancy effects by decreasing ambient pressure is a possible approach to simulate a spacecraft environment on earth. The objective of this work is to study the effect of pressure on material flammability, and by comparison with microgravity data, determine the extent to which reducing pressure can be used to simulate reduced gravity. Specifically, this work studies the effect of pressure and microgravity on upward/concurrent flame spread rates and flame appearance of a burning thin composite fabric made of 75% cotton and 25% fiberglass (Sibal). Experiments in normal gravity were conducted using pressures ranging between 100 and 30 kPa and a forced flow velocity of 20 cm/s. Microgravity experiments were conducted during NASAs Spacecraft Fire Experiment (Saffire), on board of the Orbital Corporation Cygnus spacecraft at 100 kPa and an air flow velocity of 20 cm/s. Results show that reductions of ambient pressure slow the flame spread over the fabric. As pressure is reduced, flame intensity is also reduced. Comparison with the concurrent flame spread rates in microgravity show that similar flame spread rates are obtained at around 30 kPa. The normal gravity and microgravity data is correlated in terms of a mixed convection non-dimensional parameter that describes the heat transferred from the flame to the solid surface. The correlation provides information about the similitudes of the flame spread process in variable pressure and reduced gravity environments, providing guidance for potential on-earth testing for fire safety design in spacecraft and space habitats

    Ion observations from geosynchronous orbit as a proxy for ion cyclotron wave growth during storm times

    Get PDF
    [1] There is still much to be understood about the processes contributing to relativistic electron enhancements and losses in the radiation belts. Wave particle interactions with both whistler and electromagnetic ion cyclotron (EMIC) waves may precipitate or accelerate these electrons. This study examines the relation between EMIC waves and resulting relativistic electron flux levels after geomagnetic storms. A proxy for enhanced EMIC waves is developed using Los Alamos National Laboratory Magnetospheric Plasma Analyzer plasma data from geosynchronous orbit in conjunction with linear theory. In a statistical study using superposed epoch analysis, it is found that for storms resulting in net relativistic electron losses, there is a greater occurrence of enhanced EMIC waves. This is consistent with the hypothesis that EMIC waves are a primary mechanism for the scattering of relativistic electrons and thus cause losses of such particles from the magnetosphere

    Early differential diagnosis of ankylosing spondylitis among patients with low back pain in primary care

    Get PDF

    The Distance to the Coma Cluster from Surface Brightness Fluctuations

    Full text link
    We report on the first determination of the distance to the Coma Cluster based on surface brightness fluctuation (SBF) measurements obtained from Hubble Space Telescope WFPC2 observations of the bright E0 galaxy NGC 4881 in the Coma Cluster and ground-based observations of the standard E1 galaxy NGC 3379 in the Leo-I group. Relative distances based on the I-band fluctuation magnitude, I(SBF), are strongly dependent on metallicity and age of the stellar population. However, the radial changes in the stellar populations of the two giant ellipticals, NGC 3379 and NGC 4881, are well described by published Mg_2 gradients, and the ground-based measurements of I(SBF) at several radial points in NGC 3379 are used to calibrate I(SBF) in terms of the Mg_2 index. The distance to NGC 3379, assumed to be identical to the average SBF distance of the Leo-I group, is combined with the new SBF measurements of NGC 4881 to obtain a Coma Cluster distance of 102+-14 Mpc. Combining this distance with the cosmic recession velocity of Coma (7186+-428 km/s), we find the Hubble constant to be H_0 = 71+-11 km/s/Mpc.Comment: 12 pages, LaTex, includes aaspp4.sty and 3 eps figures. To appear in ApJ Letter

    A short-term in vitro test for tumour sensitivity to adriamycin based on flow cytometric DNA analysis.

    Get PDF
    A new method to test the sensitivity of tumour cells to chemotherapy is presented. Tumour cells were incubated in vitro on agar, and drug-induced cell cycle perturbation was monitored by flow cytometric DNA analysis. In the present study the method was applied to monitor the effect of adriamycin on an adriamycin-sensitive Ehrlich ascites tumour and two adriamycin-resistant tumours. Adriamycin caused a dose-related accumulation of tumour cells in the G2 + M phase in the sensitive tumour. Drug concentrations greater than or equal to 100-fold higher were required to induce similar changes in the resistant tumours. The dose level causing maximum accumulation in the G2 + M phase is suggested as a parameter for quantifying the sensitivity. The results indicate that the method can be extended to sensitivity testing of human tumours

    Efficient qubit detection using alkali earth metal ions and a double STIRAP process

    Full text link
    We present a scheme for robust and efficient projection measurement of a qubit consisting of the two magnetic sublevels in the electronic ground state of alkali earth metal ions. The scheme is based on two stimulated Raman adiabatic passages (STIRAP) involving four partially coherent laser fields. We show how the efficiency depends on experimentally relevant parameters: Rabi frequencies, pulse widths, laser linewidths, one- and two-photon detunings, residual laser power, laser polarization and ion motion.Comment: 14 pages, 15 figure
    • …
    corecore