7,368 research outputs found
Aging and response properties in the parking-lot model
An adsorption-desorption (or parking-lot) model can reproduce qualitatively
the densification kinetics and other features of a weakly vibrated granular
material. Here we study the the two-time correlation and response functions of
the model and demonstrate that their behavior is consistent with recently
observed memory effects in granular materials. Although the densification
kinetics and hysteresis are robust properties, we show that the aging behavior
of the adsorption-desorption model is different from other models of granular
compaction. We propose an experimental test to distinguish the possible aging
behaviors.Comment: 9 pages, 7 figures, to appear in Eur. Phys. Jour.
Wall-Enhanced Convection in Vibrofluidized Granular Systems
An event-driven molecular dynamics simulation of inelastic hard spheres
contained in a cylinder and subject to strong vibration reproduces accurately
experimental results[1] for a system of vibrofluidized glass beads. In
particular, we are able to obtain the velocity field and the density and
temperature profiles observed experimentally. In addition, we show that the
appearance of convection rolls is strongly influenced by the value of the
sidewall-particle restitution coefficient. Suggestions for observing more
complex convection patterns are proposed.Comment: 4 pages, 6 figure
A simple method for estimating minimum autorotative descent rate of single rotor helicopters
Flight test results of minimum autorotative descent rate are compared with calculations based on the minimum power required for steady level flight. Empirical correction factors are derived that account for differences in energy dissipation between these two flight conditions. A method is also presented for estimating the minimum power coefficient for level flight for any helicopter for use in the empirical estimation procedure of autorotative descent rate
Optimizing the Throughput of Particulate Streams Subject to Blocking
Filtration, flow in narrow channels and traffic flow are examples of
processes subject to blocking when the channel conveying the particles becomes
too crowded. If the blockage is temporary, which means that after a finite time
the channel is flushed and reopened, one expects to observe a maximum
throughput for a finite intensity of entering particles. We investigate this
phenomenon by introducing a queueing theory inspired, circular Markov model.
Particles enter a channel with intensity and exit at a rate . If
particles are present at the same time in the channel, the system becomes
blocked and no more particles can enter until the blockage is cleared after an
exponentially distributed time with rate . We obtain an exact expression
for the steady state throughput (including the exiting blocked particles) for
all values of . For we show that the throughput assumes a maximum
value for finite if . The time-dependent throughput
either monotonically approaches the steady state value, or reaches a maximum
value at finite time. We demonstrate that, in the steady state, this model can
be mapped to a previously introduced non-Markovian model with fixed transit and
blockage times.
We also examine an irreversible, non-Markovian blockage process with constant
transit time exposed to an entering flux of fixed intensity for a finite time
and we show that the first and second moments of the number of exiting
particles are maximized for a finite intensity.Comment: 20 pages, 13 figure
A failure effects simulation of a low authority flight control augmentation system on a UH-1H helicopter
A two-pilot moving base simulator experiment was conducted to assess the effects of servo failures of a flight control system on the transient dynamics of a Bell UH-1H helicopter. The flight control hardware considered was part of the V/STOLAND system built with control authorities of from 20-40%. Servo hardover and oscillatory failures were simulated in each control axis. Measurements were made to determine the adequacy of the failure monitoring system time delay and the servo center and lock time constant, the pilot reaction times, and the altitude and attitude excursions of the helicopter at hover and 60 knots. Safe recoveries were made from all failures under VFR conditions. Pilot reaction times were from 0.5 to 0.75 sec. Reduction of monitor delay times below these values resulted in significantly reduced excursion envelopes. A subsequent flight test was conducted on a UH-1H helicopter with the V/STOLAND system installed. Series servo hardovers were introduced in hover and at 60 knots straight and level. Data from these tests are included for comparison
From Car Parking to Protein Adsorption: An Overview of Sequential Adsorption Processes
The adsorption or adhesion of large particles (proteins, colloids, cells,
>...) at the liquid-solid interface plays an important role in many diverse
applications. Despite the apparent complexity of the process, two features are
particularly important: 1) the adsorption is often irreversible on experimental
time scales and 2) the adsorption rate is limited by geometric blockage from
previously adsorbed particles. A coarse-grained description that encompasses
these two properties is provided by sequential adsorption models whose simplest
example is the random sequential adsorption (RSA) process. In this article, we
review the theoretical formalism and tools that allow the systematic study of
kinetic and structural aspects of these sequential adsorption models. We also
show how the reference RSA model may be generalized to account for a variety of
experimental features including particle anisotropy, polydispersity, bulk
diffusive transport, gravitational effects, surface-induced conformational and
orientational change, desorption, and multilayer formation. In all cases, the
significant theoretical results are presented and their accuracy (compared to
computer simulation) and applicability (compared to experiment) are discussed.Comment: 51 pages, 18 Figures, to appear in a special volume entitled
"Adhesion of Submicron Particles on Solid Surfaces" of Colloids and Surfaces
A, guest-edited by V. Privman.to appear in a special volume entitle
Landing approach evaluation of an integrated CRT display for general aviation aircraft
A flight director adaptable to general aviation aircraft was evaluated for the landing approach task in a twin turbojet business aircraft. The flight director combined aircraft heading, pitch and roll atitude, and ILS (Instrument Landing System) signals into a single picture on a small cathode ray tube (CRT) to give the pilot an integrated picture of the aircraft situation. The display is unique in that it presents the information on a CRT and gives quasi-command signals to the pilot. The particular display investigated was a preproduction version of the Kaiser Model FP-50 flight director. Approaches made with visual references only, with a conventional ILS displacement instrument, and with the CRT display were compared in terms of tracking performance and pilot workload. Tracking performance of three research pilots using the CRT display was superior to that using the conventional ILS instrument and comparable to that under VFR conditions. Pilot workload (based on pilot comments) was not clearly decreased
- …