Left-Right Asymmetry of Weak Interaction Mass of Polarized Fermions in Flight

The left-right polarization-dependent asymmetry of the weak interaction mass is investigated. Based on the Standard Model, the calculation shows that the weak interaction mass of left-handed polarized fermions is always greater than that of right-handed polarized fermions in flight with the same velocity in any inertial frame. The asymmetry of the weak interaction mass might be very important to the investigation of neutrino mass and would have an important significance for understanding the parity nonconservation in weak interactions.Comment: 8 pages, 2 figures, corrected calculatio

Solvent drag measurement of transcellular and basolateral membrane NaCl reflection coefficient in kidney proximal tubule.

The NaCl reflection coefficient in proximal tubule has important implications for the mechanisms of near isosmotic volume reabsorption. A new fluorescence method was developed and applied to measure the transepithelial (sigma NaClTE) and basolateral membrane (sigma NaClcl) NaCl reflection coefficients in the isolated proximal straight tubule from rabbit kidney. For sigma NaClTE measurement, tubules were perfused with buffers containing 0 Cl, the Cl-sensitive fluorescent indicator 6-methoxy-N-[3-sulfopropyl] quinolinium and a Cl-insensitive indicator fluorescein sulfonate, and bathed in buffers of differing cryoscopic osmolalities containing NaCl. The transepithelial Cl gradient along the length of the tubule was measured in the steady state by a quantitative ratio imaging technique. A mathematical model based on the Kedem-Katchalsky equations was developed to calculate the axial profile of [Cl] from tubule geometry, lumen flow, water (Pf) and NaCl (PNaCl) permeabilities, and sigma NaClTE. A fit of experimental results to the model gave PNaCl = (2.25 +/- 0.2) x 10(-5) cm/s and sigma NaClTE = 0.98 +/- 0.03 at 23 degrees C. For measurement of sigma NaClbl, tubule cells were loaded with SPQ in the absence of Cl. NaCl solvent drag was measured from the time course of NaCl influx in response to rapid (less than 1 s) Cl addition to the bath solution. With bath-to-cell cryoscopic osmotic gradients of 0, -60, and +30 mosmol, initial Cl influx was 1.23, 1.10, and 1.25 mM/s; a fit to a mathematical model gave sigma NaClbl = 0.97 +/- 0.04. These results indicate absence of NaCl solvent drag in rabbit proximal tubule. The implications of these findings for water and NaCl movement in proximal tubule are evaluated

Superconducting properties of Gd-Ba-Cu-O single grains processed from a new, Ba-rich precursor compound

Gd-Ba-Cu-O (GdBCO) single grains have been previously melt-processed successfully in air using a generic Mg-Nd-Ba-Cu-O (Mg-NdBCO) seed crystal. Previous research has revealed that the addition of a small amount of BaO2 to the precursor powders prior to melt processing can suppress the formation of Gd/Ba solid solution, and lead to a significant improvement in superconducting properties of the single grains. Research into the effects of a higher Ba content on single grain growth, however, has been limited by the relatively small grain size in the earlier studies. This has been addressed by developing Ba-rich precursor compounds Gd-163 and Gd-143, fabricated specifically to enable the presence of greater concentrations of Ba during the melt process. In this study, we propose a new processing route for the fabrication of high performance GdBCO single grain bulk superconductors in air by enriching the precursor powder with these new Ba rich compounds. The influence of the addition of the new compounds on the microstructures and superconducting properties of GdBCO single grains is reported

Magnesium and magnesium alloys as degradable metallic biomaterials

Drawbacks associated with permanent metallic implants lead to the search for degradable metallic biomaterials. Magnesium has been considered as it is essential to bodies and has a high biodegradation potential. For magnesium and its alloys to be used as biodegradable implant materials, their degradation rates should be consistent with the rate of healing of the affected tissue, and the release of the degradation products should be within the body's acceptable absorption levels. Conventional magnesium degrades rapidly, which is undesirable. In this study, biodegradation behaviours of high purity magnesium and commercial purity magnesium alloy AZ31 in both static and dynamic Hank's solution have been systematically investigated. The results show that magnesium purification and selective alloying are effective approaches to reduce the degradation rate of magnesium. In the static condition, the corrosion products accumulate on the materials surface as a protective layer, which results in a lower degradation rate than the dynamic condition. Anodised coating can significantly further reduce the degradation rate of magnesium. This study indicates that magnesium can be used as degradable implant materials as long as the degradation is controlled at a low rate. Magnesium purification, selective alloying and anodised coating are three effective approaches to reduce the rate of degradation