Microstructures and Strengths of Metals and Ceramics made by Photopolymerbased Rapid Prototyping

Metal and ceramic flexure specimens were fabricated using a photopolymer-based rapid prototyping technique. Photosensitive resins (inks) were produced by dispersing 50 - 55 vol% metal or ceramic powders in a photopolymer resin. Laminates 0.2" thick were built up by repeated application oflayers 3 - 10 mils thick followed by curing under a UV flood lamp with photomasks. The layered samples were thermally processed to remove the photopolymer binder and sintered to high density. Densities, microstructural characterization and flexure strengths are reported for silicon nitride, alumina, zirconia, stainless steel, and tungsten.Mechanical Engineerin

Quantum dot emission from site-controlled ngan/gan micropyramid arrays

InxGa1−xN quantum dots have been fabricated by the selective growth of GaN micropyramid arrays topped with InGaN/GaN quantum wells. The spatially, spectrally, and time-resolved emission properties of these structures were measured using cathodoluminescence hyperspectral imaging and low-temperature microphotoluminescence spectroscopy. The presence of InGaN quantum dots was confirmed directly by the observation of sharp peaks in the emission spectrum at the pyramid apices. These luminescence peaks exhibit decay lifetimes of approximately 0.5 ns, with linewidths down to 650 me

Insulating and Conducting Phases of RbC60

Optical measurements were performed on thin films of Rb$_{x}$C$_{60}$, identified by X-ray diffraction as mostly $x=1$ material. The samples were subjected to various heat treatments, including quenching and slow cooling from 400K. The dramatic increase in the transmission of the quenched samples, and the relaxation towards the transmission observed in slow cooled samples provides direct evidence for the existence of a metastable insulating phase. Slow cooling results in a phase transition between two electrically conducting phases.Comment: Minor revisions. Submitted to PRB, RevTeX 3.0 file, 2 postscript figures included, ir_dop

A Review of the fossil record of turtles of the clade Baenidae

The fossil record of the turtle clade Baenidae ranges from the Early Cretaceous (Aptian—Albian) to the Eocene. The group is present throughout North America during the Early Cretaceous, but is restricted to the western portions of the continents in the Late Cretaceous and Paleogene. No credible remains of the clade have been reported outside of North America to date. Baenids were warmadapted freshwater aquatic turtles that supported high levels of diversity at times through niche partitioning, particularly by adapting to a broad range of dietary preferences ranging from omnivorous to molluscivorous. Current phylogenies place Baenidae near the split of crown-group Testudines. Within Baenidae three more inclusive, named clades are recognized: Baenodda, Palatobaeninae and Eubaeninae. A taxonomic review of the group concludes that of 49 named taxa, 30 are nomina valida, 12 are nomina invalida and 7 are nomina dubia

Lower Hybrid Heating and Current Drive on the Alcator C-Mod Tokamak

On the Alcator C-Mod tokamak, lower hybrid current drive (LHCD) is being used to modify the current profile with the aim of obtaining advanced tokamak (AT) performance in plasmas with parameters similar to those that would be required on ITER. To date, power levels in excess of 1 MW at a frequency of 4.6 GHz have been coupled into a variety of plasmas. Experiments have established that LHCD on C-Mod behaves globally as predicted by theory. Bulk current drive efficiencies, n20IlhR/Plh ~ 0.25, inferred from magnetics and MSE are in line with theory. Quantitative comparisons between local measurements, MSE, ECE and hard x-ray bremsstrahlung, and theory/simulation using the GENRAY, TORIC-LH CQL3D and TSC-LSC codes have been performed. These comparisons have demonstrated the off-axis localization of the current drive, its magnitude and location dependence on the launched n|| spectrum, and the use of LHCD during the current ramp to save volt-seconds and delay the peaking of the current profile. Broadening of the x-ray emission profile during ICRF heating indicates that the current drive location can be controlled by the electron temperature, as expected. In addition, an alteration in the plasma toroidal rotation profile during LHCD has been observed with a significant rotation in the counter current direction. Notably, the rotation is accompanied by peaking of the density and temperature profiles on a current diffusion time scale inside of the half radius where the LH absorption is taking place

Relations between Financing and Output in the Not-for-Profit Hospital

Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/68639/2/10.1177_107755878804500204.pd

A Burkholderia pseudomallei toxin inhibits helicase activity of translation factor eIF4A

The structure of BPSL1549, a protein of unknown function from Burkholderia pseudomallei, reveals a similarity to Escherichia coli cytotoxic necrotizing factor 1. We found that BPSL1549 acted as a potent cytotoxin against eukaryotic cells and was lethal when administered to mice. Expression levels of bpsl1549 correlate with conditions expected to promote or suppress pathogenicity. BPSL1549 promotes deamidation of glutamine-339 of the translation initiation factor eIF4A, abolishing its helicase activity and inhibiting translation. We propose to name BPSL1549 Burkholderia lethal factor 1