24 research outputs found
Prediction of dynamic response of a 7-storey massive wooden building tested on a shaking table
In October 2007 a series of seismic tests were carried out on a 7-storey building made of cross laminated (XLam) wooden panels in natural scale on a shaking table E-Defence in Japan within the SOFIE project. The paper presents calculation procedure, prediction of dynamic behaviour of the tested structure excited by the earthquake record “Kobe JMA 1995” and comparison between predicted, that means calculated and measured response. Due to blind prediction approach some construction details were not known before dynamic time history response calculation. Therefore some assumptions, engineering judgment and rough static analyses were needed to define all construction parts which were in modelling approach assumed as important and could have had influence on dynamic response of the analyzed structure. The most important assumptions related to the definition of the stiffness and load bearing capacity of mechanical connections, types of anchors and their positions in each floor level, were determined on the basis of static analysis where the structure was loaded with equivalent horizontal seismic forces and then were used in dynamic analysis. A mathematical model was developed in program SAP2000 where modal and time history analyses were carried out. Comparison of calculated and measured results is described and evaluated on the basis of the model assumptions and its simplification
Activity report of COST action TU0905 working Group 1: predicting complex loads on glass structures
Although the fundamental static loads on glass structures have been addressed, the following three important aspects of loading are not fully understood and are the subject of on-going research. The probabilistic nature of combined actions such as the occurrence of combined wind and barrier loads or wind and temperture gradients shows a lack of knowledge. The internal loads the so called "climatic loads" for insulated glass units, particularly the internal pressures in curved glass units and the load sharing effects between the glass panes are currently content of international research. The time-resolved response of glass due to the dynamic loads caused by wind, blast and earthquake is a very special issue in the field of structural design of glass. All these aspects are mandatory for an accurate structural analysis of glass elements. This paper gives a short synopsis about these topics
Efficient strong motion duration of pulse‐like records for nonlinear structural analyses
Performance of Different Glass Fibre-reinforced Polymer Strengthening Schemes on Masonry Infilled RC Frames under Seismic Loading
Surface monitoring measurements of materials on environmental change conditions
Climate Change is one of the most critical global challenges of our time and the burdened cultural heritage of Europe is particularly vulnerable to be left unprotected. Climate for Culture2 project exploits the damage impact of climate change on cultural heritage at regional scale. In this paper the progress of the study with in situ measurements and investigations at cultural heritage sites throughout Europe combined with laboratory simulations is described. Cultural works of art are susceptible to deterioration with environmental changes causing imperceptibly slow but steady accumulation of damaging effects directly impacted on structural integrity. Laser holographic interference method is employed to provide remote non destructive field-wise detection of the structural differences occurred as climate responses. The first results from climate simulation of South East Europe (Crete) are presented. A full study in regards to the four climate regions of Europe is foresee n to provide values for development of a precise and integrated model of thermographic building simulations for evaluation of impact of climate change. Development of a third generation user interface software optimised portable metrology system (DHSPI II) is designed to record in custom intervals the surface of materials witnessing reactions under simulated climatic conditions both on-field and in laboratory. The climate conditions refer to real data-loggers readings representing characteristic historical building in selected climate zones. New generation impact sensors termed Glass Sensors and Free Water Sensors are employed in the monitoring procedure to cross-correlate climate data with deformation data. In this paper results from the combined methodology are additionally presented