3,466 research outputs found
Stable superconducting magnet
Operation of a superconducting magnet is considered. A method is described for; (1) obtaining a relatively high current in a superconducting magnet positioned in a bath of a gas refrigerant; (2) operating a superconducting magnet at a relatively high current level without training; and (3) operating a superconducting magnet containing a plurality of turns of a niobium zirconium wire at a relatively high current level without training
Permit Trading and Credit Trading: A Comparison of Cap-Based and Rate-Based Emissions Trading under Perfect and Imperfect Competition
This paper compares emissions trading based on a cap on total emissions (permit trading) and on relative standards per unit of output (credit trading). Two types of market structure are considered: perfect competition and Cournot oligopoly. The e?ect of combining the two schemes is also discussed. We ?nd that output and abatement costs are higher under credit trading. Combining the two schemes may give an increase in welfare. With perfect competition, permit trading always leads to higher welfare than credit trading. With imperfect competition, credit trading may out perform permit trading. Environmental policy can lead to both entry and exit of ?rms. Entry and exit have a profound impact on the performance of the schemes, especially under imperfect competition. We ?nd that it may be impossible to implement certain levels of total industry emissions. Under credit trading several levels of the relative standard can achieve the same total level of emissions.emissions trading, entry and exit, permit allocation, tradable performance standards
Repulsive force support system feasibility study
A new concept in magnetic levitation and control is introduced for levitation above a plane. A set of five vertical solenoid magnets mounted flush below the plane supports and controls the model in five degrees of freedom. The compact system of levitation coils is contained in a space 2.4 m (96 in) diameter by 1 m (40 in) deep with the top of the levitation system 0.9 m (36 in) below the center line of the suspended model. The levitated model has a permanent magnet core held in position by the five parallel superconductive solenoids symmetrically located in a circle. The control and positioning system continuously corrects for model position in five dimensions using computer current pulses superimposed on the levitation coil base currents. The conceptual designs include: superconductive and Nd-Fe-B permanent magnet model cores and levitation solenoids of either superconductive, cryoresistive, or room temperature windings
Magnetic suspension and balance system advanced study
An improved compact design for a superconducting magnetic suspension and balance system for an 8 ft. x 8 ft. transonic wind tunnel is developed. The original design of an MSBS in NASA Cr-3802 utilized 14 external superconductive coils and a superconductive solenoid in the airplane test model suspended in a wind tunnel. The improvements are in the following areas: test model solenoid options, dynamic force limits on the model, magnet cooling options, structure and cryogenic designs, power supply specifications, and cost and performance evaluations. The improvements are: MSBS cost reduction of 28%, weight; reduction of 43%, magnet system ampere-meter reduction of 38%, helium liquifier capacity reduction by 33%, magnet system stored energy reduction by 55%, AC loss to liquid helium reduced by 76%, system power supply reduced by 68%, test coil pole strength increased by 19%, wing magnetization increased by 40%, and control frequency limit increased by 200% from 10 Hz to 30 Hz. The improvements are due to: magnetic holmium coil forms in the test model, better rare earth permanent magnets in the wings, fiberglass-epoxy structure replacing stainless steel, better coil configuration, and new saddle roll coil design
Rupture of the arterial wall causes deflection in pressure time course during ex vivo balloon angioplasty
A relation between restenosis and arterial lesions resulting from balloon angioplasty has been suggested in literature. Nevertheless, it is unclear to what extent angioplasty-induced arterial wall lesions contribute to the occurrence of restenosis. One problem is that arterial ruptures cannot be detected during balloon inflation. This study describes a method to detect ruptures in the arterial wall, based on deflections observable in the development of the balloonpressure. We performed ex vivo angioplasty with constant strain rate on 28 human femoral artery segments, showing deflections in 21 cases. In 20 cases wall rupture was confirmed histologically. From seven cases not showing deflections, four showed intact wall at microscopy. These figures result in a selectivity of the proposed method of 87 ± 7% and a predictive value of the positive test of 95 ± 5%. We conclude that this method can enhance detection of arterial rupture during ex vivo angioplasty and may become important clinically
Magnetic suspension and balance system study
A compact design for a superconducting magnetic suspension and balance system is developed for a 8 ft. x 8 ft. transonic wind tunnel. The main features of the design are: a compact superconducting solenoid in the suspended airplane model; permanent magnet wings; one common liquid helium dewar for all superconducting coils; efficient new race track coils for roll torques; use of established 11 kA cryostable AC conductor; acceptable AC losses during 10 Hz control even with all steel structure; and a 560 liter/hour helium liquefier. Considerable design simplicity, reduced magnet weights, and reduced heat leak results from using one common dewar which eliminates most heavy steel structure between coils and the suspended model. Operational availability is thought to approach 100% for such magnet systems. The weight and cost of the magnet system is approximately one-third that of previous less compact designs
Single fibre action potentials in skeletal muscle related to recording distances
Single muscle fibre action potentials (SFAPs) are considered to be functions of a bioelectrical source and electrical conductivity parameters of the medium. In most model studies SFAPs are computed as a convolution of the bioelectrical source with a transfer function. Calculated peak-to-peak amplitudes of SFAPs decrease with increasing recording distances. In this paper an experimental validation of model results is presented. Experiments were carried out on the m. extensor digitorum longus (EDL) of the rat. Using a method including fluorescent labelling of the active fibre, the distance between the active fibre and the recording electrode was derived. With another method, the decline of the peak-to-peak amplitude of SFAPs detected along a multi-electrode was obtained. With both experimental methods, in general peak-to-peak amplitudes of SFAPs decreased with increasing recording distances, as was found in model results with present volume conduction theory. However, this behaviour was not found in all experiments. The rate of decline of the peak-to-peak amplitudes with recording distance was always less than in models
- …