660 research outputs found
Effect of nanosize BaZrO3 inclusions on vortex parameters in YBaCuO
We report on the field dependence of the microwave complex resistivity data
in YBaCuO/BaZrO films grown by PLD at various BaZrO
content. The data, analyzed within a recently developed general framework for
the mixed-state microwave response of superconductors, yield the field
dependence of the fluxon parameters such as the vortex viscosity and the
pinning constant. We find that pinning undergoes a change of regime when the
BaZrO content in the target increases from 2.5 mol.% to 5 mol.%.
Simultaneously, the vortex viscosity becomes an increasing function of the
applied magnetic field. We propose a scenario in which flux lines are pinned as
bundles, and a crossover from dilute point pins to dense c-axis correlated
defects takes place between 2.5 and 5 mol.% in the BZO concentration. Our data
are inconsistent with vortices occupying mainly the BaZrO sites at low
fields, and suggest instead that vortices occupy both BaZrO sites and
interstitials in the YBaCuO matrix, even at low fields.Comment: Presented at EUCAS 2009, to be published in J. Phys.:Conf. Serie
Strong Reduction of the Field-Dependent Microwave Surface Resistance in YBCO with BaZrO_3 Inclusions
We present measurements of the magnetic field dependent microwave surface
resistance in laser-ablated YBaCuO films on SrTiO
substrates. BaZrO crystallites were included in the films using composite
targets containing BaZrO inclusions with mean grain size smaller than 1
m. X-ray diffraction showed single epitaxial relationship between
BaZrO and YBaCuO. The effective surface resistance was
measured at 47.7 GHz for 6090 K and 00.8 T. The magnetic
field had a very different effect on pristine YBaCuO and
YBaCuO/BaZrO, while for 0 only a reduction of
in the YBaCuO/BaZrO film was observed,
consistent with dc measurements. At low enough , in moderate fields
YBaCuO/BaZrO exhibited an intrinsic thin film
resistance lower than the pure film. The results clearly indicate that
BaZrO inclusions determine a strong reduction of the field-dependent
surface resistance. From the analysis of the data in the framework of simple
models for the microwave surface impedance in the mixed state we argue that
BaZrO inclusions determine very steep pinning potentials.Comment: LaTeX, 6 pages, 4 figures, uses jpconf.cls and jpconf11.clo class
files, talk given at EUCAS 2007, submitted to J. Phys.: Conf. Serie
Directional pinning and anisotropy in YBa2Cu3O7-x with BaZrO3 nanorods: intrinsic and nanorods-induced anisotropy
We present a study of the anisotropic vortex parameters as obtained from
measurements of the microwave complex resistivity in the vortex state with a
tilted applied magnetic field in YBa2Cu3O7-x thin films with BaZrO3 nanorods.
We present the angular dependence of the vortex viscosity , the pinning
constant k_p and the upper limit for the creep factor \chi_M. We show that the
directional effect of the nanorods is absent in \eta, which is dictated by the
mass anisotropy \gamma. By contrast, pinning-mediated properties are strongly
affected by the nanorods. It is significant that the pinning and creep affected
by the nanorods is detectable also at our very high operating frequency, which
implies very short-range displacements of the vortices from their equilibrium
position.Comment: Proceedings of VORTEX VIII Conference, to be published in Physica
Reduction of the field-dependent microwave surface resistance in YBa_2Cu_3O_7 with sub-micrometric BaZrO_3 inclusions as a function of BaZrO_3 concentration
In order to study the vortex pinning determined by artificially introduced
pinning centers in the small-vortex displacement regime, we measured the
microwave surface impedance at 47.7 GHz in the mixed state of
YBaCuO thin films, where sub-micrometric BaZrO
particles have been incorporated. As a function of the BaZrO content, we
observe that the absolute losses slightly decrease up to a BaZrO content of
5%, and then increase. We found that the magnetic-field-induced losses behave
differently, in that they are not monotonic with increasing BaZrO
concentration: at small concentration (2.5%) the field-induced losses increase,
but large reduction of the losses themselves, by factors up to 3, is observed
upon further increasing the BaZrO concentration in the target up to 7%.
Using measurements of both surface resistance and surface reactance we estimate
vortex pinning-related parameters. We find that BaZrO inclusions introduce
deep and steep pinning wells. In particular, the minimum height of the energy
barrier for single vortices is raised. At larger BaZrO content (5% and 7%)
the phenomenon is at its maximum, but it is unclear whether it shows a
saturation or not, thus leaving room for further improvements.Comment: 7 pages, 7 figure
Strong reduction of field-dependent microwave surface resistance in YBaCuO with sub-micrometric BaZrO inclusions
We observe a strong reduction of the field induced thin film surface
resistance measured at high microwave frequency (47.7 GHz) in
YBaCuO thin films grown on SrTiO substrates, as a
consequence of the introduction of sub-micrometric BaZrO particles. The
field increase of the surface resistance is smaller by a factor of 3 in
the film with BaZrO inclusions, while the zero-field properties are not
much affected. Combining surface resistance and surface reactance data we
conclude (a) that BaZrO inclusions determine very deep and steep pinning
wells and (b) that the pinning changes nature with respect to the pure film.Comment: RevTeX; 4 pages, 3 figures; submitted to Applied Physics Letter
Anisotropy and directional pinning in YBaCuO with BaZrO3 nanorods
Measurements of anisotropic transport properties (dc and high-frequency
regime) of driven vortex matter in YBaCuO with elongated
strong-pinning sites (c-axis aligned, self-assembled BaZrO nanorods) are
used to demonstrate that the effective-mass angular scaling takes place only in
intrinsic physical quantities (flux-flow resistivity), and not in
pinning-related Labusch parameter and critical currents. Comparison of the
dynamics at different time scales shows evidence for a transition of the vortex
matter toward a Mott phase, driven by the presence of nanorods. The strong
pinning in dc arises partially from a dynamic effect.Comment: 4 pages, 4 figures. Accepted for publication on Applied Physics
Letters. With respect to v1: changed title, slightly shortene
Microwave properties of DyBa_2Cu_3O_(7-x) monodomains and related compounds in magnetic fields
We present a microwave characterization of a DyBaCuO
single domain, grown by the top-seeded melt-textured technique. We report the
(a,b) plane field-induced surface resistance, , at 48.3 GHz,
measured by means of a cylindrical metal cavity in the end-wall-replacement
configuration. Changes in the cavity quality factor Q against the applied
magnetic field yield at fixed temperatures. The temperature
range [70 K ; T_c] was explored. The magnetic field 0.8 T was
applied along the c axis. The field dependence of does not
exhibit the steep, step-like increase at low fields typical of weak-links. This
result indicates the single-domain character of the sample under investigation.
exhibits a nearly square-root dependence on H, as expected for
fluxon motion. From the analysis of the data in terms of motion of Abrikosov
vortices we estimate the temperature dependences of the London penetration
depth and the vortex viscosity , and their zero-temperature
values 165 nm and 3 10 Nsm, which are
found in excellent agreement with reported data in YBaCuO
single crystals. Comparison of microwave properties with those of related
samples indicate the need for reporting data as a function of T/T_c in order to
obtain universal laws.Comment: 6 pages, 4 figures, LaTeX, submitted to Journal of Applied Physic
Microwave properties of Nb/PdNi/Nb trilayers. Observation of flux flow in excess of Bardeen-Stephen theory
We combine wideband (1-20 GHz) Corbino disk and dielectric resonator (8.2
GHz) techniques to study the microwave properties in Nb/PdNi/Nb trilayers,
grown by UHV dc magnetron sputtering, composed by Nb layers of nominal
thickness =15 nm, and a ferromagnetic PdNi layer of thickness = 1, 2,
8 and 9 nm. We focus on the vortex state. Magnetic fields up to were
applied. The microwave resistivity at fixed increases with ,
eventually exceeding the Bardeen Stephen flux flow value.Comment: 6 pages. Submitted to Journal of Superconductivity and Novel
Magnetis
- …