An analysis of I/O efficient order-statistic-based techniques for noise power estimation in the HRMS sky survey's operational system

Noise power estimation in the High-Resolution Microwave Survey (HRMS) sky survey element is considered as an example of a constant false alarm rate (CFAR) signal detection problem. Order-statistic-based noise power estimators for CFAR detection are considered in terms of required estimator accuracy and estimator dynamic range. By limiting the dynamic range of the value to be estimated, the performance of an order-statistic estimator can be achieved by simpler techniques requiring only a single pass of the data. Simple threshold-and-count techniques are examined, and it is shown how several parallel threshold-and-count estimation devices can be used to expand the dynamic range to meet HRMS system requirements with minimal hardware complexity. An input/output (I/O) efficient limited-precision order-statistic estimator with wide but limited dynamic range is also examined

Multiquark Hadrons

A number of candidate multiquark hadrons, i.e., particle resonances with substructures that are more complex than the quark-antiquark mesons and three-quark baryons that are prescribed in the textbooks, have recently been observed. In this talk I present: some recent preliminary BESIII results on the near-threshold behavior of sigma(e+e- --> Lambda Lambda-bar) that may or may not be related to multiquark mesons in the light- and strange-quark sectors; results from Belle and LHCb on the electrically charged, charmoniumlike Z(4430)^+ --> pi^+ psi ' resonance that necessarily has a four-quark substructure; and the recent LHCb discovery of the P_c(4380) and P_c(4450) hidden-charm resonances seen as a complex structure in the J/psi p invariant mass distribution for Lambda_b --> K^-J/psi p decays and necessarily have a five-quark substructure and are, therefore, prominent candidates for pentaquark baryons.Comment: 12 pages, 9 figures, summary of a talk presented at the 12th Conference on Hypernuclear and Strange Particle Physics (HYP2015), September 7-12, 2015 Sendai, JAPAN. To appear in the JPS Conference proceeding

Large-scale aeroacoustic research feasibility and conceptual design of test-section inserts for the Ames 80- by 120-foot wind tunnel

An engineering feasibility study was made of aeroacoustic inserts designed for large-scale acoustic research on aircraft models in the 80 by 120 foot Wind Tunnel at NASA Ames Research Center. The advantages and disadvantages of likely designs were analyzed. Results indicate that the required maximum airspeed leads to the design of a particular insert. Using goals of 200, 150, and 100 knots airspeed, the analysis indicated a 30 x 60 ft open-jet test section, a 40 x 80 ft open jet test section, and a 70 x 100 ft closed test section with enhanced wall lining, respectively. The open-jet inserts would be composed of a nozzle, collector, diffuser, and acoutic wedges incorporated in the existing 80 x 120 test section. The closed test section would be composed of approximately 5 ft acoustic wedges covered by a porous plate attached to the test section walls of the existing 80 x 120. All designs would require a double row of acoustic vanes between the test section and fan drive to attenuate fan noise and, in the case of the open-jet designs, to control flow separation at the diffuser downstream end. The inserts would allow virtually anechoic acoustic studies of large helicopter models, jets, and V/STOL aircraft models in simulated flight. Model scale studies would be necessary to optimize the aerodynamic and acoustic performance of any of the designs. In all designs studied, the existing structure would have to be reinforced. Successful development of acoustically transparent walls, though not strictly necessary to the project, would lead to a porous-wall test section that could be substituted for any of the open-jet designs, and thereby eliminate many aerodynamic and acoustic problems characteristic of open-jet shear layers. The larger size of the facility would make installation and removal of the insert components difficult. Consequently, scheduling of the existing 80 x 120 aerodynamic test section and scheduling of the open-jet test section would likely be made on an annual or longer basis. The enhanced wall-lining insert would likely be permanent. Although the modifications are technically feasible, the economic practicality of the project was not evaluated

The construction and operation of a water tunnel in application to flow visualization studies of an oscillating airfoil

The water tunnel which was constructed at the NASA Ames Research Center is described along with the flow field adjacent to an oscillating airfoil. The design and operational procedures of the tunnel are described in detail. Hydrogen bubble and thymol blue techniques are used to visualize the flow field. Results of the flow visualizations are presented in a series of still pictures and a high speed movie. These results show that time stall is more complicated than simple shedding from the leading edge or the trailing edge, particularly at relatively low frequency oscillations comparable to those of a helicopter blade. Therefore, any successful theory for predicting the stall loads on the helicopter blades must treat an irregular separated region rather than a discrete vortex passing over each blade surface

Long-Period Building Response to Earthquakes in the San Francisco Bay Area

This article reports a study of modeled, long-period building responses to ground-motion simulations of earthquakes in the San Francisco Bay Area. The earthquakes include the 1989 magnitude 6.9 Loma Prieta earthquake, a magnitude 7.8 simulation of the 1906 San Francisco earthquake, and two hypothetical magnitude 7.8 northern San Andreas fault earthquakes with hypocenters north and south of San Francisco. We use the simulated ground motions to excite nonlinear models of 20-story, steel, welded moment-resisting frame (MRF) buildings. We consider MRF buildings designed with two different strengths and modeled with either ductile or brittle welds. Using peak interstory drift ratio (IDR) as a performance measure, the stiffer, higher strength building models outperform the equivalent more flexible, lower strength designs. The hypothetical magnitude 7.8 earthquake with hypocenter north of San Francisco produces the most severe ground motions. In this simulation, the responses of the more flexible, lower strength building model with brittle welds exceed an IDR of 2.5% (that is, threaten life safety) on 54% of the urban area, compared to 4.6% of the urban area for the stiffer, higher strength building with ductile welds. We also use the simulated ground motions to predict the maximum isolator displacement of base-isolated buildings with linear, single-degree-of-freedom (SDOF) models. For two existing 3-sec isolator systems near San Francisco, the design maximum displacement is 0.5 m, and our simulations predict isolator displacements for this type of system in excess of 0.5 m in many urban areas. This article demonstrates that a large, 1906-like earthquake could cause significant damage to long-period buildings in the San Francisco Bay Area

Mesoscopic dynamical differences from quantum state preparation in a Bose-Hubbard trimer

Conventional wisdom is that quantum effects will tend to disappear as the number of quanta in a system increases, and the evolution of a system will become closer to that described by mean field classical equations. In this letter we combine newly developed experimental techniques to propose and analyse an experiment using a Bose-Hubbard trimer where the opposite is the case. We find that differences in the preparation of a centrally evacuated trimer can lead to readily observable differences in the subsequent dynamics which increase with system size. Importantly, these differences can be detected by the simple measurements of atomic number.Comment: 5 pages, 4 figures, theor

A bimodal search strategy for SETI

The search strategy and resultant observational plan which was developed to carry out a comprehensive Search for Extraterrestrial Intelligence (SETI) over that portion of the electromagnetic spectrum known as the terrestrial microwave window is described. The limiting sensitivity achieved was parameterized and calculated for Deep Space Network antennas as well as several radio astronomy observatories. A brief description of the instrumentation to be employed in the search and the classes of signals to be looked for is given. One observational goal is to survey the entire sky over a wide range of frequency to a relatively constant flux level. This survey ensures that all potential life sites are observed to some limiting equivalent isotropic radiated power depending upon their distance. A second goal is to survey a set of potential transmission sites selected a priori to be especially promising, achieving very high sensitivity over a smaller range of frequency

Gas Exchange And Leaf Anatomy Of Andropogon Gerardii Ecotypes Over A Climatic Gradient Of The Great Plains

The phenotype of two Andropogon gerardii subspecies, big bluestem and sand bluestem, varies broadly throughout the Great Plains of North America, giving rise to ecotypes within the species. This study sought to discriminate between genetic and environmental variation of big bluestem and sand bluestem by examining gas exchange and leaf anatomy in common gardens across a climatic gradient of the Great Plains. Thirteen populations of big bluestem and one population of sand bluestem, constituting five ecotypes, were planted in community plots and a single plant plots in a common garden at each of four sites ranging from western Kansas to southern Illinois. Photosynthesis, stomatal conductance, intercellular CO2, transpiration, and intrinsic water use efficiency were measured three times in the 2010 growing season. In addition, leaf thickness, midrib thickness, bulliform cells, interveinal distance, and vein size were assessed by light microscopy. Abundant phenotypic variation exists among ecotypes within community plots. At all planting sites, big bluestem ecotypes from xeric environments had higher photosynthesis, stomatal conductance, and transpiration compared to mesic ecotypes. Single plant plots also had abundant phenotypic variation; ecotypes native to xeric environments also had higher photosynthesis, stomatal conductance, and transpiration, but differences were more distinct. In addition, sand bluestem, which was only planted in single plant plots, had similar photosynthesis, stomatal conductance, and transpiration to the big bluestem ecotype native to the most xeric environment. Sand bluestem also had higher water use efficiency and lower intercellular CO2 than any big bluestem ecotype. Leaf anatomy assessments indicated xeric ecotypes of A. gerardii had thicker leaves and fewer bulliform cells. Environmental variation was as important as genetic variation for gas exchange and leaf anatomy in both community and single plant plots. Compared to xeric sites, mesic sites had higher photosynthesis, stomatal conductance, and water use efficiency and lower intercellular CO2 and transpiration in community and single plant plots. Leaves from mesic sites also had thicker midribs, larger veins, and a greater proportion of bulliform cells. Ecotypes of A. gerardii across the Great Plains are adapted to water availability. Drought-adapted ecotypes of A. gerardii were shorter in stature and had smaller, thicker, narrower leaves, which reduced the evaporative surface area of these plants. Evidently, A. gerardii controls water loss by reducing evaporative surface area more than it does by increasing the proportion of bulliform cells. This allows drought-adapted ecotypes to have higher photosynthetic rates, stomatal conductances, and transpiration rates in both mesic and xeric environments compared to ecotypes native to mesic environments. This study brings to light potential responses of big bluestem ecotypes to climate change. This study also indicates the phenotypic variation among big bluestem could prove useful in the restoration of native prairies