1,043 research outputs found
Magneto-elastic coupling in La(Fe, Mn, Si)<sub>13</sub>H<i>y</i> within the Bean-Rodbell model
First order magnetic phase transition materials present a large magnetocaloric effect around the transition temperature, where these materials usually undergo a large volume or structural change. This may lead to some challenges for applications, as the material may break apart during field change, due to high internal stresses. A promising magnetocaloric material is La(Fe, Mn, Si)13Hy, where the transition temperature can be controlled through the Mn amount. In this work we use XRD measurements to evaluate the temperature dependence of the unit cell volume with a varying Mn amount. The system is modelled using the Bean-Rodbell model, which is based on the assumption that the spin-lattice coupling depends linearly on the unit cell volume. This coupling is defined by the model parameter η, where for η > 1 the material undergoes a first order transition and for η ≤ 1 a second order transition. We superimpose a Gaussian distribution of the transition temperature with a standard deviation
σ
T
0
, in order to model the chemical inhomogeneity. Good agreement is obtained between measurements and model with values of η ∼ 1.8 and σ(T0) = 1.0 K
Comparing superconducting and permanent magnets for magnetic refrigeration
We compare the cost of a high temperature superconducting (SC) tape-based solenoid with a permanent magnet (PM) Halbach cylinder for magnetic refrigeration. Assuming a five liter active magnetic regenerator volume, the price of each type of magnet is determined as a function of aspect ratio of the regenerator and desired internal magnetic field. It is shown that to produce a 1 T internal field in the regenerator a permanent magnet of hundreds of kilograms is needed or an area of superconducting tape of tens of square meters. The cost of cooling the SC solenoid is shown to be a small fraction of the cost of the SC tape. Assuming a cost of the SC tape of 6000 /kg, the superconducting solenoid is shown to be a factor of 0.3-3 times more expensive than the permanent magnet, for a desired field from 0.5-1.75 T and the geometrical aspect ratio of the regenerator. This factor decreases for increasing field strength, indicating that the superconducting solenoid could be suitable for high field, large cooling power applications
Strain development during the phase transition of La(Fe,Mn,Si)<sub>13</sub>H<i><sub>z </sub></i>
High performance magnetocaloric perovskites for magnetic refrigeration
et al.We have applied mixed valance manganite perovskites as magnetocaloric materials in a magnetic refrigeration device. Relying on exact control of the composition and a technique to process the materials into single adjoined pieces, we have observed temperature spans above 9 K with two materials. Reasonable correspondence is found between experiments and a 2D numerical model, using the measured magnetocaloric properties of the two materials as input. © 2012 American Institute of Physics.The authors would like to acknowledge the support of the Programme Commission on Energy and Environment (EnMi) (Contract No. 2104-06-0032) which is part of the Danish Council for Strategic Research.Peer Reviewe
The La(Fe,Mn,Si)13 Hz magnetic phase transition under pressure (Phys. Status Solidi RRL 8/2017)
Socio-demographic characteristics of adults with self-reported ADHD symptoms in a Danishpopulation of 12,415 blood donors
Strategies to develop a prophylaxis for the prevention of HPA-1a immunization and fetal and neonatal alloimmune thrombocytopenia
- …