Estimating Power Needed to Fuel Electric Paratransits in Bandung

This is the preliminary finding of a study elaborating the total energy consumption when paratransits in Bandung are altered into electric and the scenario to fulfill it. Therefore, there are lots to be done further concerning result of this initial research, of which will be discussed in another publication. In this paper calculation was done to find out the volume of power needed to fuel electric paratransits in Bandung. Steps carried out include computing total energy consumption for all paratransits, clustering stations from classified routes established by local Department of Transport, and estimating the electricity demand in every clustered station. Data used for this study was acquired from Badan Pusat Statistik Kota Bandung and PT PLN DJA APD Jawa Barat and Banten. A total demand of 61.12 MWh per month will surface to charge the total of 5,521 paratransits from 38 available routes in 15 clustered stations under the assumptions that all paratransits only make 6 return travels per day, operate 30 days per month, and use batteries with 50% State of Charge

Phase Change Material Composite Battery Module for Thermal Protection of Electric Vehicles: An Experimental Observation

A composite container for an electric vehicle (EV) battery module filled with a phase-change material (PCM) was experimentally tested at various discharge rates. The average cell temperatures at 1 C, 2 C, and 4 C discharge rates, respectively, might reach 38 °C, 50 °C, and 70 °C in the absence of any heat-absorbing material. The temperature was noticeably lower with PCM present than with a conventional battery module. For instance, at 4 C discharge rates, none of the battery cells inside the PCM-filled module were able to reach 70 °C. Unfortunately, the PCM addition also degraded the composite’s tensile qualities. Further investigations used Paraffin-20 and Caprylone since PCMs provide a notably different thermal performance due to their distinctive latent heat profiles. It was observed that a high melting temperature of the paraffin mixture, despite its slightly lower latent heat capacity compared to Caprylone, could lead to a more uniform temperature. Overall, both PCMs can be used as passive protection against any potential thermal abuses in EV battery modules, while in terms of mechanical strength, the use of a composite reinforcement material is strongly encouraged