Surface-Enhanced Raman Scattering Sensor on an Optical Fiber Probe Fabricated with a Femtosecond Laser

A novel fabrication method for surface-enhanced Raman scattering (SERS) sensors that used a fast femtosecond (fs) laser scanning process to etch uniform patterns and structures on the endface of a fused silica optical fiber, which is then coated with a thin layer of silver through thermal evaporation is presented. A high quality SERS signal was detected on the patterned surface using a Rhodamine 6G (Rh6G) solution. The uniform SERS sensor built on the tip of the optical fiber tip was small, light weight, and could be especially useful in remote sensing applications

Lack of Association Between DJ-1 Gene Promoter Polymorphism and the Risk of Parkinson’s Disease

Low DJ-1 protein level caused by DJ-1 gene mutation leads to autosomal recessive Parkinson’s disease (PD) due to impaired antioxidative activity. In sporadic PD patients, although mutations were rarely found, lower DJ-1 protein level was also reported. Dysregulation of DJ-1 gene expression might contribute to low DJ-1 protein level. Since the promoter is the most important element to initiate gene expression, whether polymorphisms in the DJ-1 promoter result in the dysregulation of gene expression, thus leading to low protein level and causing PD, is worth exploring. The DJ-1 promoter region was sequenced in a Chinese cohort to evaluate possible links between DJ-1 promoter polymorphisms, PD risk and clinical phenotypes. Dual-luciferase reporter assay was conducted to evaluate the influence of promoter polymorphisms on DJ-1 transcriptional activity. Related information in an existing genome-wide association studies (GWAS) database were looked up, meta-analysis of the present study and other previous reports was conducted, and expression quantitative trait loci (eQTL) analysis was performed to further explore the association. Three single nucleotide polymorphisms (SNPs) (rs17523802, rs226249, and rs35675666) and one 18 bp deletion (rs200968609) were observed in our cohort. However, there was no significant association between the four detected genetic variations and the risk of PD either in allelic or genotype model, in single-point analysis or haplotype analysis. This was supported by the meta-analysis of this study and previous reports as well as that of GWAS database PDGene. Dual luciferase reporter assay suggested these promoter polymorphisms had no influence on DJ-1 transcriptive activity, which is consistent with the eQTL analysis results using the data from GTEx database. Thus, DJ-1 promoter polymorphisms may play little role in the dysregulation of DJ-1 expression and PD susceptibility in sporadic PD

Natural Coevolution of Tumor and Immunoenvironment in Glioblastoma.

Isocitrate dehydrogenase (IDH) wild-type glioblastoma (GBM) has a dismal prognosis. A better understanding of tumor evolution holds the key to developing more effective treatment. Here we study GBM\u27s natural evolutionary trajectory by using rare multifocal samples. We sequenced 61,062 single cells from eight multifocal IDH wild-type primary GBMs and defined a natural evolution signature (NES) of the tumor. We show that the NES significantly associates with the activation of transcription factors that regulate brain development, including MYBL2 and FOSL2. Hypoxia is involved in inducing NES transition potentially via activation of the HIF1A-FOSL2 axis. High-NES tumor cells could recruit and polarize bone marrow-derived macrophages through activation of the FOSL2-ANXA1-FPR1/3 axis. These polarized macrophages can efficiently suppress T-cell activity and accelerate NES transition in tumor cells. Moreover, the polarized macrophages could upregulate CCL2 to induce tumor cell migration. SIGNIFICANCE: GBM progression could be induced by hypoxia via the HIF1A-FOSL2 axis. Tumor-derived ANXA1 is associated with recruitment and polarization of bone marrow-derived macrophages to suppress the immunoenvironment. The polarized macrophages promote tumor cell NES transition and migration. This article is highlighted in the In This Issue feature, p. 2711

Using metal nanostructures to form hydrocarbons from carbon dioxide, water and sunlight

Based on experimental results, we propose a mechanism that allows the use of metal nanostructures to synthesize hydrocarbons and carbohydrates from carbon dioxide, water and sunlight. When sunlight impinges on cobalt nanostructures in a glass chamber, its intensity is greatly enhanced around the tips of the nanostructures through surface plasmon excitations focusing effect, and it then photodissociates the water and carbon dioxide molecules through enhanced photon absorptions of ions around the tips of the nanostructures. The photodissociated molecules in excited states remain on the cobalt nanostructure surfaces and various hydrocarbons and carbohydrates then will be formed around the surfaces at temperatures much lower than 100C

Femtosecond laser irradiation-induced infrared absorption on silicon surfaces

The near-infrared (NIR) absorption below band gap energy of crystalline silicon is significantly increased after the silicon is irradiated with femtosecond laser pulses at a simple experimental condition. The absorption increase in the NIR range primarily depends on the femtosecond laser pulse energy, pulse number, and pulse duration. The Raman spectroscopy analysis shows that after the laser irradiation, the silicon surface consists of silicon nanostructure and amorphous silicon. The femtosecond laser irradiation leads to the formation of a composite of nanocrystalline, amorphous, and the crystal silicon substrate surface with microstructures. The composite has an optical absorption enhancement at visible wavelengths as well as at NIR wavelength. The composite may be useful for an NIR detector, for example, for gas sensing because of its large surface area

Nonlinear optical properties of gold with intense femtosecond laser excitations above the damage threshold

The nonlinear optical properties of gold thin films have been studied under the irradiation of destructive laser pluses. The transmissivity and the reflectivity of a 100-nm-thick gold film are measured with femtosecond laser irradiations up to 106 J/m2 fluence, which is much higher than the damage threshold of gold. The nonlinearity is calculated with Fresnel loss equations. The real part of the complex refractive index is calculated to have a peak at ∼10 kJ/m2, which is close to the damage threshold. The complex third-order nonlinear susceptibility χ3 is estimated to be (4.95 − 2.02i) × 10−21 m2/V2, which agrees with the trend in previous reports that it decreases as the pulse duration decreases. This nonlinearity is further studied with a plasmon-photon exchange (PPE) model, where laser induced plasmons and absorbed photons are strongly correlated. The result of the simulation with the PPE model is in good agreement with the experimental transmissivity above the damage threshold. The model predicted an interaction time between photons and plasmons to be about 500 fs. This model is found to be essential in understanding such nonlinear optical processes under both extremely high and conventionally low laser irradiations

Femtosecond Laser-Induced Thermal Transport in Silicon with Liquid Cooling Bath

Nanostructured regular patterns on silicon surface are made by using femtosecond laser irradiations. This is a novel method that can modify the surface morphology of any large material in an easy, fast, and low-cost way. We irradiate a solid surface with a 400-nm double frequency beam from an 800-nm femtosecond laser, while the solid surface is submerged in a liquid or exposed in air. From the study of multiple-pulses and single-pulse irradiations on silicon, we find the morphologies of nanospikes and capillary waves to follow the same distribution and periodicity. Thermal transport near the solid surface plays an important role in the formation of patterns; a simulation was done to fully understand the mechanism of the pattern formation in single pulse irradiation. The theoretical models include a femtosecond laser pulse function, a two-temperature model (2-T model), and an estimation of interface thermal coupling. The evolution of lattice temperature over time will be calculated first without liquid cooling and then with liquid cooling, which has not been well considered in previous theoretical papers. The lifetime of the capillary wave is found to be longer than the solidification time of the molten silicon only when water cooling is introduced. This allows the capillary wave to be frozen and leaves interesting concentric rings on the silicon surface. The regular nanospikes generated on the silicon surface result from the overlapping capillary waves

Investigation of the Effect of Electrode Surface Roughness on Spark Ignition

Lean-burn engines are important due to their ability to reduce emissions, increase fuel efficiency, and mitigate engine knock. In this study, the surface roughness of spark plug electrodes is investigated as a potential avenue to extend the lean flammability limit of natural gas. A nano-/micro-morphology modification is applied on surface of the spark plug electrode to increase its surface roughness. High-speed Z-type Schlieren visualization is used to investigate the effect of the electrode surface roughness on the spark ignition process in a premixed methane-air charge at different lean equivalence ratios. In order to observe the onset of ignition and flame kernel behavior, experiments were conducted in an optically accessible constant volume combustion chamber at ambient pressures and temperatures. The results indicate that the lean flammability limit of spark-ignited methane can be lowered by modulating the surface roughness of the spark plug electrode

Electroplating Cobalt Films on Silicon Nanostructures for Sensing Molecules

In this study, we electroplated Co and Cu on nano-spiked silicon substrates that were treated with femtosecond laser irradiations. With energy-dispersive X-ray (EDX) analysis by a scanning electron microscope (SEM), it was found that both Co and Cu are primarily coated on the spike surfaces without changing the morphology of the nanospikes. We also found that nanoscale bridges were formed, connecting the Co-coated silicon spikes. The formation of these bridges was studied and optimized through a series of time-controlled electroplating and oxidizing processes. The bridges are related to the oxidation of Co in the air. When it is irradiated with visible light, this special structure has shown a capability of interactions with carbon monoxide and carbon dioxide molecules. The electroplated cobalt may be used for gas sensors