Improved dynamic cutting force model in peripheral milling - Part 2 : experimental verification and prediction

“The original publication is available at www.springerlink.com”. Copyright Springer. DOI: 10.1007/s00170-003-1797-5 [Full text of this article is not available in the UHRA]Cutting trials reveal that a measure of cutter run-out is always unavoidable in peripheral milling. This paper improves and extends the dynamic cutting force model of peripheral milling based on the theoretical analytical model presented in Part I [1], by taking into account the influence of the cutter run-out on the undeformed chip thickness. A set of slot milling tests with a single-fluted helical end-mill was carried out at different feed rates, while the 3D cutting force coefficients were calibrated using the averaged cutting forces. The measured and predicted cutting forces were compared using the experimentally identified force coefficients. The results indicate that the model provides a good prediction when the feed rate is limited to a specified interval, and the recorded cutting force curves give a different trend compared to other published results [8]. Subsequently, a series of peripheral milling tests with different helical end-mill were performed at different cutting parameters to validate the proposed dynamic cutting force model, and the cutting conditions were simulated and compared with the experimental results. The result demonstrates that only when the vibration between the cutter and workpiece is faint, the predicted and measured cutting forces are in good agreement.Peer reviewe

Improved dynamic cutting force model in ball-end milling. Part 1: theoretical modelling and experimental calibration

An accurate cutting force model of ball-end milling is essential for precision prediction and compensation of tool deflection that dominantly determines the dimensional accuracy of the machined surface. This paper presents an improved theoretical dynamic cutting force model for ball-end milling. The three-dimensional instantaneous cutting forces acting on a single flute of a helical ball-end mill are integrated from the differential cutting force components on sliced elements of the flute along the cutter-axis direction. The size effect of undeformed chip thickness and the influence of the effective rake angle are considered in the formulation of the differential cutting forces based on the theory of oblique cutting. A set of half immersion slot milling tests is performed with a one-tooth solid carbide helical ball-end mill for the calibration of the cutting force coefficients. The recorded dynamic cutting forces are averaged to fit the theoretical model and yield the cutting force coefficients. The measured and simulated dynamic cutting forces are compared using the experimental calibrated cutting force coefficients, and there is a reasonable agreement. A further experimental verification of the dynamic cutting force model will be presented in a follow-up paper