11,636 research outputs found
A gas-dynamic calculation of type 2 shock propagation through the corona
An approximate analytic theory of acoustic shock propagation in nonuniform media is used to determine the motion of a flare-generated shock wave in the corona. The shock is followed from the time it strikes the chromosphere-corona transition region (density interface) out to 5 solar radii under the assumption that the corona in this region is approximately in hydrostatic equilibrium. The strength of the shock incident on the transition region from below determines the ejection velocity of eruptive prominence material, as well as the initial velocity of the coronal shock. The calculation is applied to one well-documented case of a related flare spray, moving type 4 isolated source, and type 2 burst. It is shown that a chromospheric shock of the appropriate strength to produce the observed prominence and type 4 velocities strengthens as it moves out in the corona by an amount sufficient to account for the observed high velocity of the type 2 burst
Large-scale electric fields resulting from magnetic reconnection in the corona
The method of Forbes and Priest (2-D model) is applied to the large two-ribbon flare of July 29, 1973, for which both detailed H observations and magnetic data are available. For this flare the ribbons were long, nearly straight, and parallel to each other, and the 2-D model for the coronal field geometry may be adequate. The temporal profile E(t) is calculated and indicates that reconnection sets in at the beginning of the decay phase. From this time the electric field grows rapidly to a maximum value of about 2 V/cm within just a few minutes. Thereafter it decreases monotonically with time
Magnetic field re-arrangement after prominence eruption
It has long been known that magnetic reconnection plays a fundamental role in a variety of solar events. Although mainly invoked in flare problems, large scale loops interconnecting active regions, evolving coronal hole boundaries, the solar magnetic cycle itself, provide different evidence of phenomena which involve magnetic reconnection. A further example might be given by the magnetic field rearrangement which occurs after the eruption of a prominence. Since most often a prominence reforms after its disappearance and may be observed at about the same position it occupied before erupting, the magnetic field has to undergo a temporary disruption of relax back, via reconnection, to a configuration similar to the previous one. The above sequence of events is best observable in the case of two ribbon (2-R) flares but most probably is associated with all filament eruptions. Even if the explanation of the magnetic field rearrangement after 2-R flares in terms of reconnection is generally accepted, the lack of a 3-dimensional model capable of describing the field reconfiguration, has prevented, up to now, a thorough analysis of its topology as traced by H alpha/x ray loops. A numerical technique is presented which enables oneto predict and visualize the reconnected configuration, at any time, and therefore allows one to make a significant comparison of observations and model predictions throughout the whole process
Effect of Vinyl and Silicon Monomers on Mechanical and Degradation Properties of Bio-Degradable Jute-Biopol® Composite
Dieser Beitrag ist mit Zustimmung des Rechteinhabers aufgrund einer (DFG geförderten) Allianz- bzw. Nationallizenz frei zugänglich.This publication is with permission of the rights owner freely accessible due to an Alliance licence and a national licence (funded by the DFG, German Research Foundation) respectively.Composites of jute fabrics (Hessian cloth) and Biopol® were prepared by compression molding process. Three types of Biopol® (3-hydroxbutyrate-co-3-hydroxyvalarate) such as D300G, D400G and D600G, depending on the concentration of 3-hydroxyvalarate (3HV) in 3-hydroxbutyrate (3HB) were taken for this purpose. Mechanical properties such as tensile strength (TS), bending strength (BS), elongation at break (Eb) and impact strength (IS) of the jute-Biopol® composites were studied. It was found that the composite with D400G produced higher mechanical properties in comparison to the other two types of Biopol®. To increase mechanical properties as well as interfacial adhesion between fiber and matrix, 2-ethyl hydroxy acrylate (EHA), vinyl tri-methoxy silane (VMS) and 3-methacryloxypropyl tri-methoxy silane (MPS) were taken as coupling agents. Enhanced mechanical properties of the composites were obtained by using these coupling agents. Biopol® D400G composites showed the highest mechanical properties. Among the coupling agents EHA depicts the highest increase of mechanical properties such as tensile strength (80%), bending strength (81%), elongation at break (33%) and impact strength (130%) compared pure Biopol. SEM investigations demonstrate that the coupling agents improve the interfacial adhesion between fiber and matrix. The surface of the silanized jute was characterized by FTIR and found the deposition of silane on jute fiber was observed. Soil degradation test proved that the composite prepared with EHA treated jute exhibits better degradation properties in comparison to pure Biopol®
Cooperative dynamics in doped manganite films: phonon anomalies in the ferromagnetic state
We present optical measurements of phononic excitations in
LaCaMnO (LCMO) and LaSrMnO (LSMO)
thin films covering the full temperature range from the metallic ferromagnetic
to the insulating paramagnetic phase. All eight phonons expected for the
Rc symmetry in LSMO and 17 out of the expected 25 phonons for the Pnma
symmetry in LCMO have been determined. Close to the
ferromagnetic-to-paramagnetic transition both compounds reveal an anomalous
behavior but with different characteristics. Anomalies in the phononic spectra
are a manifestation of the coupling of lattice degrees of freedom (DOF) to
electronic DOF. Specifically, the low-frequency external group proves to be an
indicator for lattice modifications induced by electronic correlations. The
enhanced electron-phonon coupling in LCMO is responsible for Fano-like
interference effects of distinct phonon modes with electronic continuum
excitations: we observe asymmetric phonon line shapes, mode splitting and
spectral weight transfer between modes.Comment: 10 pages, 10 figure
Pitch-angle scattering in magnetostatic turbulence. I. Test-particle simulations and the validity of analytical results
Context. Spacecraft observations have motivated the need for a refined
description of the phase-space distribution function. Of particular importance
is the pitch-angle diffusion coefficient that occurs in the Fokker-Planck
transport equation. Aims. Simulations and analytical test-particle theories are
compared to verify the diffusion description of particle transport, which does
not allow for non-Markovian behavior. Methods. A Monte-Carlo simulation code
was used to trace the trajectories of test particles moving in turbulent
magnetic fields. From the ensemble average, the pitch-angle Fokker-Planck
coefficient is obtained via the mean square displacement. Results. It is shown
that, while excellent agreement with analytical theories can be obtained for
slab turbulence, considerable deviations are found for isotropic turbulence. In
addition, all Fokker-Planck coefficients tend to zero for high time values.Comment: 8 pages, 10 figures, accepted for publication in Astron. Astrophy
- …