8,890 research outputs found
Deformation and fracture of thin sheet aluminum-lithium alloys: The effect of cryogenic temperatures
The objective is to characterize the fracture behavior and to define the fracture mechanisms for new Al-Li-Cu alloys, with emphasis on the role of indium additions and cryogenic temperatures. Three alloys were investigated in rolled product form: 2090 baseline and 2090 + indium produced by Reynolds Metals, and commercial AA 2090-T81 produced by Alcoa. The experimental 2090 + In alloy exhibited increases in hardness and ultimate strength, but no change in tensile yield strength, compared to the baseline 2090 composition in the unstretched T6 condition. The reason for this behavior is not understood. Based on hardness and preliminary Kahn Tear fracture experiments, a nominally peak-aged condition was employed for detailed fracture studies. Crack initiation and growth fracture toughness were examined as a function of stress state and microstructure using J(delta a) methods applied to precracked compact tension specimens in the LT orientation. To date, J(delta a) experiments have been limited to 23 C. Alcoa 2090-T81 exhibited the highest toughness regardless of stress state. Fracture was accompanied by extensive delamination associated with high angle grain boundaries normal to the fatigue precrack surface and progressed microscopically by a transgranular shear mechanism. In contrast the two peak-aged Reynolds alloys had lower toughness and fracture was intersubgranular without substantial delamination. The influences of cryogenic temperature, microstructure, boundary precipitate structure, and deformation mode in governing the competing fracture mechanisms will be determined in future experiments. Results contribute to the development of predictive micromechanical models for fracture modes in Al-Li alloys, and to fracture resistant materials
Superplastic forming of Al-Li alloys for lightweight, low-cost structures
Superplastic forming of advanced aluminum alloys is being evaluated as an approach for fabricating low-cost, light-weight, cryogenic propellant tanks. Built-up structure concepts (with inherent reduced scrap rate) are under investigation to offset the additional raw material expenses incurred by using aluminum lithium alloys. This approach to fabrication offers the potential for significant improvements in both structural efficiency and overall manufacturing costs. Superplasticity is the ability of specially processed material to sustain very large forming strains without failure at elevated temperatures under controlled deformation conditions. It was demonstrated that superplastic forming technology can be used to fabricate complex structural components in a single operation and increase structural efficiency by as much as 60 percent compared to conventional configurations in skin-stiffened structures. Details involved in the application of this technology to commercial grade superplastic aluminum lithium material are presented. Included are identification of optimum forming parameters, development of forming procedures, and assessment of final part quality in terms of cavitation volume and thickness variation
So you want to run an experiment, now what? Some Simple Rules of Thumb for Optimal Experimental Design
Experimental economics represents a strong growth industry. In the past several decades the method has expanded beyond intellectual curiosity, now meriting consideration alongside the other more traditional empirical approaches used in economics. Accompanying this growth is an influx of new experimenters who are in need of straightforward direction to make their designs more powerful. This study provides several simple rules of thumb that researchers can apply to improve the efficiency of their experimental designs. We buttress these points by including empirical examples from the literature.
Validation of a new spectrometer for noninvasive measurement of cardiac output
Acetylene is a blood-soluble gas and for many years its uptake rate during rebreathing tests has been used to calculate the flow rate of blood through the lungs (normally equal to cardiac output) as well as the volume of lung tissue. A new, portable, noninvasive instrument for cardiac output determination using the acetylene uptake method is described. The analyzer relies on nondispersive IR absorption spectroscopy as its principle of operation and is configured for extractive (side-stream) sampling. The instrument affords exceptionally fast (30 ms, 10%–90%, 90%–10%, at 500 mL min–1 flow rates), interference-free, simultaneous measurement of acetylene, sulfur hexafluoride (an insoluble reference gas used in the cardiac output calculation), and carbon dioxide (to determine alveolar ventilation), with good (typically ±2% full-scale) signal-to-noise ratios. Comparison tests with a mass spectrometer using serially diluted calibration gas samples gave excellent (R2>0.99) correlation for all three gases, validating the IR system's linearity and accuracy. A similar level of agreement between the devices also was observed during human subject C2H2 uptake tests (at rest and under incremental levels of exercise), with the instruments sampling a common extracted gas stream. Cardiac output measurements by both instruments were statistically equivalent from rest to 90% of maximal oxygen consumption; the physiological validity of the measurements was confirmed by the expected linear relationship between cardiac output and oxygen consumption, with both the slope and intercept in the published range. These results indicate that the portable, low-cost, rugged prototype analyzer discussed here is suitable for measuring cardiac output noninvasively in a point-of-care setting
Simulation at Dryden Flight Research Facility from 1957 to 1982
The Dryden Flight Research Facility has been a leader in developing simulation as an integral part of flight test research. The history of that effort is reviewed, starting in 1957 and continuing to the present time. The contributions of the major program activities conducted at Dryden during this 25-year period to the development of a simulation philosophy and capability is explained
Ionic Capillary Evaporation in Weakly Charged Nanopores
Using a variational field theory, we show that an electrolyte confined to a
neutral cylindrical nanopore traversing a low dielectric membrane exhibits a
first-order ionic liquid-vapor pseudo-phase-transition from an
ionic-penetration "liquid" phase to an ionic-exclusion "vapor" phase,
controlled by nanopore-modified ionic correlations and dielectric repulsion.
For weakly charged nanopores, this pseudotransition survives and may shed light
on the mechanism behind the rapid switching of nanopore conductivity observed
in experiments.Comment: This version is accepted for publication in PR
Searching for Dark Matter Annihilation in the Smith High-Velocity Cloud
Recent observations suggest that some high-velocity clouds may be confined by
massive dark matter halos. In particular, the proximity and proposed dark
matter content of the Smith Cloud make it a tempting target for the indirect
detection of dark matter annihilation. We argue that the Smith Cloud may be a
better target than some Milky Way dwarf spheroidal satellite galaxies and use
gamma-ray observations from the Fermi Large Area Telescope to search for a dark
matter annihilation signal. No significant gamma-ray excess is found coincident
with the Smith Cloud, and we set strong limits on the dark matter annihilation
cross section assuming a spatially-extended dark matter profile consistent with
dynamical modeling of the Smith Cloud. Notably, these limits exclude the
canonical thermal relic cross section () for dark matter masses GeV annihilating via the or channels for certain assumptions of the dark matter
density profile; however, uncertainties in the dark matter content of the Smith
Cloud may significantly weaken these constraints.Comment: 7 pages, 5 figures. Published in Ap
Aminoglycoside effects on voltage-sensitive calcium channels and neurotoxicity
Journal ArticleTo the Editor: Since ototoxicity and neuromuscular toxicity of aminoglycoside antibiotics are reversed by calcium, 1,2 and presynaptic events appear to be involved in aminoglycoside-induced neuromuscular blockade, 3,4 we suspected a role for voltage-sensitive calcium channels in aminoglycoside neurotoxicity
Myosin V and the endoplasmic reticulum: the connection grows
In this issue, Estrada et al. (2003) provide new and important insights into how the endoplasmic reticulum (ER) of budding yeast cells is inherited. Together with other studies in plant and animal cells, the results of Estrada et al. (2003) support the idea that myosin V acts as a universal motor for the transport of ER membranes
- …