Correlates of Injury-forced Work Reduction for Massage Therapists and Bodywork Practitioners†

Background: Injury-forced work reduction (IFWR) has been acknowledged as an all-toocommon occurrence for massage therapists and bodywork practitioners (M & Bs). However, little prior research has specifically investigated demographic, work attitude, and perceptual correlates of IFWR among M & Bs. Purpose: To test two hypotheses, H1 and H2. H1 is that the accumulated cost variables set ( e.g., accumulated costs, continuing education costs) will account for a significant amount of IFWR variance beyond control/demographic (e.g., social desirability response bias, gender, years in practice, highest education level) and work attitude/perception variables (e.g., job satisfaction, affective occupation commitment, occupation identification, limited occupation alternatives) sets. H2 is that the two exhaustion variables (i.e., physical exhaustion, work exhaustion) set will account for significant IFWR variance beyond control/demographic, work attitude/perception, and accumulated cost variables sets. Research Design and Participants: An online survey sample of 2,079 complete-data M & Bs was collected. Stepwise regression analysis was used to test the study hypotheses. The research design first controlled for control/demographic (Step1) and work attitude/perception variables sets (Step 2), before then testing for the successive incremental impact of two variable sets, accumulated costs (Step 3) and exhaustion variables (Step 4) for explaining IFWR. Results: Results supported both study hypotheses: accumulated cost variables set (H1) and exhaustion variables set (H2) each significantly explained IFWR after the control/demographic and work attitude/perception variables sets. The most important correlate for explaining IFWR was higher physical exhaustion, but work exhaustion was also significant. It is not just physical “wear and tear”, but also “mental fatigue”, that can lead to IFWR for M & Bs. Being female, having moreyears in practice, and having higher continuing education costs were also significant correlates of IFWR. Conclusions: Lower overall levels of work exhaustion, physical exhaustion, and IFWR were found in the present sample. However, since both types of exhaustion significantly and positively impact IFWR, taking sufficient time between massages and, if possible, varying one’s massage technique to replenish one’s physical and mental energy seem important. Failure to take required continuing education units, due to high costs, also increases risk for IFWR. Study limitations and future research issues are discussed

Does a competitive voucher program for adolescents improve the quality of reproductive health care? A simulated patient study in Nicaragua

BACKGROUND: Little is known about how sexual and reproductive (SRH) health can be made accessible and appropriate to adolescents. This study evaluates the impact and sustainability of a competitive voucher program on the quality of SRH care for poor and underserved female adolescents and the usefulness of the simulated patient (SP) method for such evaluation. METHODS: 28,711 vouchers were distributed to adolescents in disadvantaged areas of Managua that gave free-of-charge access to SRH care in 4 public, 10 non-governmental and 5 private clinics. Providers received training and guidelines, treatment protocols, and financial incentives for each adolescent attended. All clinics were visited by female adolescent SPs requesting contraception. SPs were sent one week before, during (with voucher) and one month after the intervention. After each consultation they were interviewed with a standardized questionnaire. Twenty-one criteria were scored and grouped into four categories. Clinics' scores were compared using non-parametric statistical methods (paired design: before-during and before-after). Also the influence of doctors' characteristics was tested using non-parametric statistical methods. RESULTS: Some aspects of service quality improved during the voucher program. Before the program started 8 of the 16 SPs returned 'empty handed', although all were eligible contraceptive users. During the program 16/17 left with a contraceptive method (p = 0.01). Furthermore, more SPs were involved in the contraceptive method choice (13/17 vs.5/16, p = 0.02). Shared decision-making on contraceptive method as well as condom promotion had significantly increased after the program ended. Female doctors had best scores before- during and after the intervention. The improvements were more pronounced among male doctors and doctors older than 40, though these improvements did not sustain after the program ended. CONCLUSION: This study illustrates provider-related obstacles adolescents often face when requesting contraception. The care provided during the voucher program improved for some important outcomes. The improvements were more pronounced among providers with the weakest initial performance. Shared decision-making and condom promotion were improvements that sustained after the program ended. The SP method is suitable and relatively easy to apply in monitoring clinics' performance, yielding important and relevant information. Objective assessment of change through the SP method is much more complex and expensive

Depth-Sensing Indentation on REBa2Cu3O(7-\delta) Single Crystals obtained from Xenotime Mineral

A natural mixture of heavy rare earths oxides extracted from xenotime mineral have been used to prepare large single crystals of high-temperature REBa2Cu3O(7-\delta) superconductor grown using the CuO-BaO self-flux method. Its mechanical properties along the ab-plane were characterized using instrumented indentation. Hardness and elastic modulus were obtained by the Oliver and Pharr method and corresponds to 7.4 \pm 0.2 GPa and in range 135-175 GPa at small depths, respectively. Increasing the load promotes the nucleation of lateral cracks that causes a decrease in hardness and the measured elastic modulus by instrumented indentation at higher loads. The indentation fracture toughness was estimated by measuring the radial crack length from cube-corner indentations at various loads and was 0.8 \pm 0.2 MPa.m1/2. The observed slip systems of REBa2Cu3O(7-\delta) single crystals were [100](001) and [010](001), the same as for YBa2Cu3O(7-\delta) single crystals. The initial stages of deformation and fracture in the indentation process were investigated. The hardness and elastic modulus were not strongly modified by the crystallographic orientation in the ab-plane. This was interpreted in terms of the resolved shear stresses in the active slip systems. Evidence of cracking along the {100} and {110} planes on the ab-plane was observed. As a conclusion, the mechanical properties of REBa2Cu3O(7-\delta) single crystals prepared from xenotime are equivalent to those of YBa2Cu3O(7-\delta) single crystals produced by conventional rare earths oxides.Comment: The paper will appear in Volume 42 (2012) of the Brazilian Journal of Physic

Experimental Microbial Evolution of Extremophiles

Experimental microbial evolutions (EME) involves studying closely a microbial population after it has been through a large number of generations under controlled conditions (Kussell 2013). Adaptive laboratory evolution (ALE) selects for fitness under experimentally imposed conditions (Bennett and Hughes 2009; Dragosits and Mattanovich 2013). However, experimental evolution studies focusing on the contributions of genetic drift and natural mutation rates to evolution are conducted under non-selective conditions to avoid changes imposed by selection (Hindré et al. 2012). To understand the application of experimental evolutionary methods to extremophiles it is essential to consider the recent growth in this field over the last decade using model non-extremophilic microorganisms. This growth reflects both a greater appreciation of the power of experimental evolution for testing evolutionary hypotheses and, especially recently, the new power of genomic methods for analyzing changes in experimentally evolved lineages. Since many crucial processes are driven by microorganisms in nature, it is essential to understand and appreciate how microbial communities function, particularly with relevance to selection. However, many theories developed to understand microbial ecological patterns focus on the distribution and the structure of diversity within a microbial population comprised of single species (Prosser et al. 2007). Therefore an understanding of the concept of species is needed. A common definition of species using a genetic concept is a group of interbreeding individuals that is isolated from other such groups by barriers of recombination (Prosser et al. 2007). An alternative ecological species concept defines a species as set of individuals that can be considered identical in all relevant ecological traits (Cohan 2001). This is particularly important because of the abundance and deep phylogenetic complexity of microbial communities. Cohan postulated that “bacteria occupy discrete niches and that periodic selection will purge genetic variation within each niche without preventing divergence between the inhabitants of different niches”. The importance of gene exchange mechanisms likely in bacteria and archaea and therefore extremophiles, arises from the fact that their genomes are divided into two distinct parts, the core genome and the accessory genome (Cohan 2001). The core genome consists of genes that are crucial for the functioning of an organism and the accessory genome consists of genes that are capable of adapting to the changing ecosystem through gain and loss of function. Strains that belong to the same species can differ in the composition of accessory genes and therefore their capability to adapt to changing ecosystems (Cohan 2001; Tettelin et al. 2005; Gill et al. 2005). Additional ecological diversity exists in plasmids, transposons and pathogenicity islands as they can be easily shared in a favorable environment but still be absent in the same species found elsewhere (Wertz et al. 2003). This poses a major challenge for studying ALE and community microbial ecology indicating a continued need to develop a fitting theory that connects the fluid nature of microbial communities to their ecology (Wertz et al. 2003; Coleman et al. 2006). Understanding the nature and contribution of different processes that determine the frequencies of genes in any population is the biggest concern in population and evolutionary genetics (Prosser et al. 2007) and it is critical for an understanding of experimental evolution

Bridging conventional and molecular genetics of sorghum insect resistance

Sustainable production of sorghum, Sorghum bicolor (L.) Moench, depends on effective control of insect pests as they continue to compete with humans for the sorghum crop. Insect pests are a major constraint in sorghum production, and nearly 150 insect species are serious pests of this crop worldwide and cause more than 9% loss annually. Annual losses due to insect pests in sorghum have been estimated to be $1,089 million in the semiarid tropics (ICRISAT Annual report 1991. International Crop Research Institute for Semi-arid Tropics. Patancheru, Andhra Pradesh, India, 1992), but differing in magnitude on a regional basis. Key insect pests in the USA include the greenbug, Schizaphis graminum (Rondani); sorghum midge, Stenodiplosis sorghicola (Coquillett); and various caterpillars in the Southern areas. For example, damage by greenbug to sorghum is estimated to cost US producers$248 million annually. The major insect pests of sorghum on a global basis are the greenbug, sorghum midge, sorghum shoot fly (Atherigona soccata Rond.), stem borers (Chilo partellus Swin. and Busseola fusca Fuller), and armyworms (Mythimna separata Walk and Spodoptera frugiperda J.E. Smith). Recent advances in sorghum genetics, genomics, and breeding have led to development of some cutting-edge molecular technologies that are complementary to genetic improvement of this crop for insect pest management. Genome sequencing and genome mapping have accelerated the pace of gene discovery in sorghum..

North American Wild Relatives of Grain Crops

The wild-growing relatives of the grain crops are useful for long-term worldwide crop improvement research. There are neglected examples that should be accessioned as living seeds in gene banks. Some of the grain crops, amaranth, barnyard millet, proso millet, quinoa, and foxtail millet, have understudied unique and potentially useful crop wild relatives in North America. Other grain crops, barley, buckwheat, and oats, have fewer relatives in North America that are mostly weeds from other continents with more diverse crop wild relatives. The expanding abilities of genomic science are a reason to accession the wild species since there are improved ways to study evolution within genera and make use of wide gene pools. Rare wild species, especially quinoa relatives in North American, should be acquired by gene banks in cooperation with biologists that already study and conserve at-risk plant populations. Many of the grain crop wild relatives are weeds that have evolved herbicide resistance that could be used in breeding new herbicide-resistant cultivars, so well-documented examples should be accessioned and also vouchered in gene banks