516 research outputs found
Half-filled Hubbard Model on a Bethe lattice with next-nearest neighbor hopping
We study the interplay between N\'eel-antiferromagnetism and the paramagnetic
metal-insulator-transition (PMIT) on a Bethe lattice with nearest and
next-nearest eighbor hopping and . We concentrate in this paper on
the situation at half-filling. For the PMIT outgrows the
antiferromagnetic phase and shows a scenario similar to VO. In this
parameter regime we also observe a novel magnetic phase.Comment: 8 pages, 10 figure
Photonic currents in driven and dissipative resonator lattices
Arrays of coupled photonic cavities driven by external lasers represent a
highly controllable setup to explore photonic transport. In this paper we
address (quasi)-steady states of this system that exhibit photonic currents
introduced by engineering driving and dissipation. We investigate two
approaches: in the first one, photonic currents arise as a consequence of a
phase difference of applied lasers and in the second one, photons are injected
locally and currents develop as they redistribute over the lattice. Effects of
interactions are taken into account within a mean-field framework. In the first
approach, we find that the current exhibits a resonant behavior with respect to
the driving frequency. Weak interactions shift the resonant frequency toward
higher values, while in the strongly interacting regime in our mean-field
treatment the effect stems from multiphotonic resonances of a single driven
cavity. For the second approach, we show that the overall lattice current can
be controlled by incorporating few cavities with stronger dissipation rates
into the system. These cavities serve as sinks for photonic currents and their
effect is maximal at the onset of quantum Zeno dynamics.Comment: 12 pages, 11 figure
Discounting and the environment should current impacts be weighted differently than impacts harming future generations?
Background: In Life-Cycle Assessment (LCA), decision makers are often faced with tradeoffs between current and future impacts. One typical example is waste incineration, where immediate emissions to the air from the incineration process have to be weighted against future emissions of slag landfills. Long-term impacts are either completely taken into account or they are entirely disregarded in case of a temporal cut-off. Temporal cutoffs are a special case of discounting. Objective: In this paper, discounting is defined as valuing damages differently at different points of time using a positive or negative discount rate. Apart from temporal cut-offs, discounting has rarely been applied in LCA so far. It is the goal of this paper to discuss the concept of discounting and its applicability in the context of LCA. Methods: For this purpose, we first review the arguments for discounting and its principles in economic sciences. Discounting in economics can be motivated by pure time preference, productivity of capital, diminishing marginal utility of consumption, and uncertainties. The nominal discount rate additionally includes changes in the price level. These arguments and their justification are discussed in the context of environmental impacts harming future generations. Results and Discussion: It is concluded that discounting across generations because of pure time preference contradicts fundamental ethical values and should therefore not be applied in LCA. However, it has to be acknowledged that in practice decision makers often use positive discount rates because of pure time preference — either because they might profit from imposing environmental damage on others instead of themselves or because people in the far future are not of immediate concern to them. Discounting because of the productivity of capital assumes a relationship between monetary values and environmental impact. If such a relationship is accepted, discounting could be applied. However, future generations should be compensated for the environmental damage. It is likely that they would demand a higher compensation if the real per capita income increases. As both the compensation and the discount rate are related to economic growth, the overall discount rate might be close to zero. It is shown that the overall discount rate might even be negative considering that the required compensation could increase (even to infinite) if natural assets remain scarce, whereas the utility of consumption diminishes with increasing income. Uncertainties could justify both positive and negative discount rates. Since the relationship between uncertainties and the magnitude of damage is generally not exponential, we recommend to model changes in the magnitude of damage in scenario analysis instead of considering it in discounting (which requires an exponential function of time in the case of a constant discount rate). We investigated the influence of discounting in a case study of heavy metal emissions from slag landfills. It could be shown that even small discount rates of less than 1 % lead to a significant reduction of the impact score, whereas negative discount rates inflate the results. Conclusions and Recommendations: Discounting is only applicable when temporally differentiated data is available. In some cases, such a temporal differentiation is necessary to take sound decisions, especially when long emission periods are involved. An example is the disposal of nuclear or heavy metal-containing waste. In these cases, the results might completely depend on the discount rate. This paper helps to structure arguments and thus to support the decision about whether or not discounting should be applied in an LC
Production of fine and speciality chemicals: procedure for the estimation of LCIs
Goal, Scope, Background: To improve the environmental performance of chemical products or services, especially via comparisons of chemical products, LCA is a suitable evaluation method. However, no procedure to obtain comprehensive LCI-data on the production of fine and speciality chemicals is available to date, and information on such production processes is scarce. Thus, a procedure was developed for the estimation of LCIs of chemical production process-steps, which relies on only a small amount of input data. Methods: A generic input-output scheme of chemical production process-steps was set up, and equations to calculate inputs and outputs were established. For most parameters in the resulting estimation procedure, default values were derived from on-site data on chemical production processes and from heuristics. Uncertainties in the estimated default values were reflected as best-case and worst-case scenarios. The procedure was applied to a case study comparing the production of two active ingredients used for crop protection. Verification and a sensitivity analysis were carried out. Results and Discussion: It was found that the impacts from the mass and energy flows estimated by the procedure represent a significant share of the impacts assessed in the case study. In a verification, LCI-data from existing processes yielded results within the range of the estimated best-case and worst-case scenarios. Note that verification data could not be obtained for all process steps. From the verification results, it was inferred that mass and energy flows of existing processes for the production of fine and speciality chemicals correspond more frequently to the estimated best-case than to the worst-case scenario. In the sensitivity analysis, solvent demand was found to be the most crucial parameter in the environmental performance of the chemical production processes assessed. Conclusion: Mass and energy flows in LCIs of production processes for fine and speciality chemicals should not be neglected, even if only little information on a process is available. The estimation procedure described here helps to overcome lacking information in a transparent, consistent way. Recommendations and Outlook: Additional verifications and a more detailed estimation of the default parameters are desirable to learn more about the accuracy of the estimation procedure. The procedure should also be applied to case studies to gain insight into the usefulness of the estimation results in different decision-making context
Sustainable ICT equals not ICT for sustainability
In this opinion paper we promote the idea of an open dialogue to take place from within the Sustainable Futures journal that will offer the opportunity to a wide range of actors and stakeholders to present their ideas, concerns and worries on a variety of issues relevant and related to aspects of sustainability. Such an open-ended approach will help overcome opposing dynamics that currently cater for polarization and as a result to the segregation within the scientific community and the society at large. On the positive side, there is a wide spectrum of ambitious, game-changing and disruptive initiatives that can be taken from academia, from the industry, from the activists’ movements and the citizens at large, which will aim to increase our freedoms and not reduce them
Modelling the valuesphere and the ecosphere: Integrating the decision makers' perspectives into LCA
Methods for Life Cycle Impact Assessment have to cope with two critical aspects, the uncertainty in values and the (unknown) system behaviour. LCA methodology should cope explicitly with these subjective elements. A structured aggregation procedure is proposed that differentiates between the technosphere and the ecosphere and embeds them in the valuesphere. LCA thus becomes a decision support system that models and combines these three spheres. We introduce three structurally identical types of LCA, each based on one coherent but different set of values. These sets of values can be derived from the Cultural Theory and are labeled as ‘egalitarian', ‘individualistic', and ‘hierarchic'. Within Life Cycle Impact Assessment, a damage oriented assessment model is complemented with both a newly developed precautionary indicator designed to address unknown damage and an indicator for the manageability of environmental damages. The indicators for unknown damage and for manageability complete the set of indicators judged to be relevant by decision makers. The weights given to these indicators are also value-dependent. The framework proposed here answers the criticisms that present LCA methodology does not strictly enough separate subjective from objective elements and that it fails to accurately model environmental impact
Reciprocal interactions between the bark beetle-associated yeast Ogataea pini and host plant phytochemistry
Here we report the first experiments testing reciprocal effects between the bark beetle-associated yeast, Ogataea pini, and phytochemicals present in tree tissues (Pinus ponderosa). We tested two hypotheses: (i) tree phytochemicals mediate O. pin,i growth and (ii) O. pini affects chemical composition of plant tissues. We tested six monoterpenes on O. pins biomass growth in vitro and found that most monoterpenes inhibited O. pini growth; however mean O. pini biomass increased 21.5% when treated with myrcene and 75.5% when treated with terpinolene, relative to control. Ogataea pini was grown on phloem tissue ex vivo to determine whether O. pini affected phloem chemistry. Monoterpene concentrations declined in phloem over time, but phloem colonized by O. pini had significantly different concentrations of monoterpenes at two periods than phloem with no yeast. After 7 d, when O. pini was present, concentrations of the monoterpene Delta-3-carene was 42.9% lower than uncolonized phloem and concentrations of the monoterpene terpinolene was 345.0% higher than uncolonized phloem. After 15 d phloem colonized by O. pini had 505.4% higher concentrations of a-pinene than uncolonized phloem. These experiments suggest that O. pini responds to phytochemicals present in host tissues and the presence of O. pini might alter the chemical environment of phloem tissues during the early stages of beetle development. The interactions between O. pini and phytochemicals in pine vascular tissues might have consequences for the bark beetle that vectors O. pini, Dendroctonus brevicomis
Advances in Oxygen Isotope Analysis of Phosphate by Electrospray Orbitrap Mass Spectrometry for Studying the Microbial Metabolism of Microorganisms
Understanding the impact of human activities on the metabolic state of soil and aquatic environments is of paramount importance to implement measures for maintaining ecosystem services. Variations of natural abundance 18O/16O ratios in phosphate have been proposed as proxies for the holistic assessment of metabolic activity given the crucial importance of phosphoryl transfer reactions in fundamental biological processes. However, instrumental and procedural limitations inherent to oxygen isotope analysis in phosphate and organophosphorus compounds have so far limited the stable isotope-based evaluation of metabolic processes. Here, we discuss how recent developments in Orbitrap high resolution mass spectrometry enable measurements of 18O/16O ratios in phosphate and outline the critical mass spectrometry parameters for accurate and precise analysis. Subsequently, we evaluate the types of 18O kinetic isotope effects of phosphoryl transfer reactions and illustrate how novel analytical approaches will give rise to an improved understanding of 18O/16O ratio variations from biochemical processes affecting the microbial phosphorus metabolism
- …