Initial subjective load carriage injury data collected by interviews and questionnaires

This study aimed to identify the types, incidence, and causes of any potential load carriage injuries or discomfort as a result of a 2-hour, forced-speed, treadmill march carrying 20 kg. Subjective load carriage data were collected, through both interviews and questionnaires, from relatively inexperienced soldiers after a period of load carriage. Results from the study showed that the upper limb is very susceptible to short-term discomfort, whereas the lower limb is not. The shoulders were rated significantly more uncomfortable then any other region, and blisters were experienced by ∼60% of participants. Shoulder discomfort commences almost as soon as the load is added and increases steadily with time; however, foot discomfort increases more rapidly once the discomfort materializes. In conclusion, early development of shoulder pain or blisters may be a risk factor for severe pain or noncompletion of a period of prolonged load carriage

A first order iteration process for simultaneous equations

First order iteration process for solutions of simultaneous equation

The effect of military load carriage on ground reaction forces

Load carriage is an inevitable part of military life both during training and operations. Loads carried are frequently as high as 60% bodyweight, and this increases injury risk. In the military, load is carried in a backpack (also referred to as a Bergen) and webbing, these combined form a load carriage system (LCS). A substantial body of literature exists recording the physiological effects of load carriage; less is available regarding the biomechanics. Previous biomechanical studies have generally been restricted to loads of 20% and 40% of bodyweight, usually carried in the backpack alone. The effect of rifle carriage on gait has also received little or no attention in the published literature. This is despite military personnel almost always carrying a rifle during load carriage. In this study, 15 male participants completed 8 conditions: military boot, rifle, webbing 8 and 16 kg, backpack 16 kg and LCS 24, 32 and 40 kg. Results showed that load added in 8 kg increments elicited a proportional increase in vertical and anteroposterior ground reaction force (GRF) parameters. Rifle carriage significantly increased the impact peak and mediolateral impulse compared to the boot condition. These effects may be the result of changes to the vertical and horizontal position of the body's centre of mass, caused by the restriction of natural arm swing patterns. Increased GRFs, particularly in the vertical axis, have been positively linked to overuse injuries. Therefore, the biomechanical analysis of load carriage is important in aiding our understanding of injuries associated with military load carriage

High temperature glass thermal control structure and coating

A high temperature stable and solar radiation stable thermal control coating is described which is useful either as such, applied directly to a member to be protected, or applied as a coating on a re-usable surface insulation (RSI). It has a base coat layer and an overlay glass layer. The base coat layer has a high emittance, and the overlay layer is formed from discrete, but sintered together glass particles to give the overlay layer a high scattering coefficient. The resulting two-layer space and thermal control coating has an absorptivity-to-emissivity ratio of less than or equal to 0.4 at room temperature, with an emittance of 0.8 at 1200 F. It is capable of exposure to either solar radiation or temperatures as high as 2000 F without significant degradation. When used as a coating on a silica substrate to give an RSI structure, the coatings of this invention show significantly less reduction in emittance after long term convective heating and less residual strain than prior art coatings for RSI structures

Ephedrine requirements are reduced during spinal anaesthesia for caesarean section in preeclampsia

Part of the Portfolio Thesis by Geoffrey H. Sharwood-Smith: The inferior vena caval compression theory of hypotension in obstetric spinal anaesthesia: studies in normal and preeclamptic pregnancy, a literature review and revision of fundamental concepts, available at http://hdl.handle.net/10023/1815Background: Despite controversy over the haemodynamically safest blockade for caesarean section in women with severe preeclampsia, an increasing number of anaesthetists now opt for spinal anaesthesia. In a previous study we found that spinal compared to epidural anaesthesia offered an equally safe but more effective option for these patients. The current study was designed to compare the hypotension induced by spinal anaesthesia, as measured by ephedrine requirement, between 20 normotensive and 20 severely preeclamptic but haemodynamically stabilised women. Method: Standardised spinal anaesthesia was instituted and ephedrine was given in boluses of 6 mg if the systolic pressure fell >20% from the baseline, or if the patient exhibited symptoms of hypotension. Results: The mean ephedrine requirement of the normotensive group (27.9 ± 11.6 mg) was significantly greater (P < 0.01) than that of the preeclamptic group (16.4 ± 15.0 mg). Conclusion: This suggests that the hypotension induced by spinal anaesthesia in women with severe but haemodynamically stabilised preeclampsia, is less than that of normotensive patients.Publisher PD

A Renormalization Group Improved Calculation of Top Quark Production near Threshold

The top quark cross section close to threshold in $e^+e^-$ annihilation is computed including the summation of logarithms of the velocity at next-to-next-to-leading-logarithmic order in QCD. The remaining theoretical uncertainty in the normalization of the total cross section is at the few percent level, an order of magnitude smaller than in previous next-to-next-to-leading order calculations. This uncertainty is smaller than the effects of a light standard model Higgs boson.Comment: changed figures, added reference

Automatic holographic droplet analysis for liquid fuel sprays

The basic scheme for automated holographic analysis involves an optical system for reconstruction of the three dimensional real image of the droplet field, a spatial scanning system to transport a digitizing X-y image sensor through the real image, and processing algorithms for droplet recognition which establish the droplet sizes and positions. The hardware for system demonstrated includes the expanded and collimated beam from a 5 mW helium-neon laser for hologram reconstruction, an imaging lens for magnification of the real image field, and a video camera and digitizer providing 512-by-512 pixel resolution with 8-bit digitization. A mechanical stage is used to scan the hologram in three dimensional space, maintaining constant image magnification. A test droplet hologram is used for development and testing of the image processing algorithms

Running-mass models of inflation, and their observational constraints

If the inflaton sector is described by softly broken supersymmetry, and the inflaton has unsuppressed couplings, the inflaton mass will run strongly with scale. Four types of model are possible. The prediction for the spectral index involves two parameters, while the COBE normalization involves a third, all of them calculable functions of the relevant masses and couplings. A crude estimate is made of the region of parameter space allowed by present observation.Comment: Latex file, 20 pages, 11 figures, uses epsf.sty. Comment on the observation of the spectral index scale dependence added; Fig. 3-6 improve

Adjustable high emittance gap filler

A flexible, adjustable refractory filler is disclosed for filling gaps between ceramic tiles forming the heat shield of a space shuttle vehicle, to protect its aluminum skin during atmospheric reentry. The easily installed and replaced filler consists essentially of a strip of ceramic cloth coated, at least along both its longitudinal edges with a room temperature vulcanizable silicone rubber compound with a high emittance colored pigment. The filler may have one or more layers as the gap width requires. Preferred materials are basket weave aluminoborosilicate cloth, and a rubber compounded with silicon tetraboride as the emittance agent and finely divided borosilicate glass containing about 7.5% B2O3 as high temperature binder. The filler cloth strip or tape is cut to proper width and length, inserted into the gap, and fastened with previously applied drops of silicone rubber adhesive

Natural Chaotic Inflation in Supergravity

We propose a chaotic inflation model in supergravity. In the model the K\"ahler potential has a Nambu-Goldstone-like shift symmetry of the inflaton chiral multiplet which ensures the flatness of the inflaton potential beyond the Planck scale. We show that the chaotic inflation naturally takes place by introducing a small breaking term of the shift symmetry in the superpotential. This may open a new branch of model building for inflationary universe in the framework of supergravity.Comment: Some typos are corrected. To appear in Phys. Rev. Let