106 research outputs found
Identification of single nucleotides in MoS2 nanopores
Ultrathin membranes have drawn much attention due to their unprecedented
spatial resolution for DNA nanopore sequencing. However, the high translocation
velocity (3000-50000 nt/ms) of DNA molecules moving across such membranes
limits their usability. To this end, we have introduced a viscosity gradient
system based on room-temperature ionic liquids (RTILs) to control the dynamics
of DNA translocation through a nanometer-size pore fabricated in an atomically
thin MoS2 membrane. This allows us for the first time to statistically identify
all four types of nucleotides with solid state nanopores. Nucleotides are
identified according to the current signatures recorded during their transient
residence in the narrow orifice of the atomically thin MoS2 nanopore. In this
novel architecture that exploits high viscosity of RTIL, we demonstrate
single-nucleotide translocation velocity that is an optimal speed (1-50 nt/ms)
for DNA sequencing, while keeping the signal to noise ratio (SNR) higher than
10. Our findings pave the way for future low-cost and rapid DNA sequencing
using solid-state nanopores.Comment: Manuscript 24 pages, 4 Figures Supporting Information 24 pages, 12
Figures, 2 Tables Manuscript in review Nature Nanotechnology since May 27th
201
Probing the inter-layer exciton physics in a MoS/MoSe/MoS van der Waals heterostructure
Stacking atomic monolayers of semiconducting transition metal dichalcogenides
(TMDs) has emerged as an effective way to engineer their properties. In
principle, the staggered band alignment of TMD heterostructures should result
in the formation of inter-layer excitons with long lifetimes and robust valley
polarization. However, these features have been observed simultaneously only in
MoSe/WSe heterostructures. Here we report on the observation of long
lived inter-layer exciton emission in a MoS/MoSe/MoS trilayer van
der Waals heterostructure. The inter-layer nature of the observed transition is
confirmed by photoluminescence spectroscopy, as well as by analyzing the
temporal, excitation power and temperature dependence of the inter-layer
emission peak. The observed complex photoluminescence dynamics suggests the
presence of quasi-degenerate momentum-direct and momentum-indirect bandgaps. We
show that circularly polarized optical pumping results in long lived valley
polarization of inter-layer exciton. Intriguingly, the inter-layer exciton
photoluminescence has helicity opposite to the excitation. Our results show
that through a careful choice of the TMDs forming the van der Waals
heterostructure it is possible to control the circular polarization of the
inter-layer exciton emission.Comment: 19 pages, 3 figures. Just accepted for publication in Nano Letters
(http://pubs.acs.org/doi/10.1021/acs.nanolett.7b03184
Electrochemical reaction in single layer MoS2: nanopores opened atom by atom
Ultrathin nanopore membranes based on 2D materials have demonstrated ultimate
resolution toward DNA sequencing. Among them, molybdenum disulphide (MoS2)
shows long-term stability as well as superior sensitivity enabling high
throughput performance. The traditional method of fabricating nanopores with
nanometer precision is based on the use of focused electron beams in
transmission electron microscope (TEM). This nanopore fabrication process is
time-consuming, expensive, not scalable and hard to control below 1 nm. Here,
we exploited the electrochemical activity of MoS2 and developed a convenient
and scalable method to controllably make nanopores in single-layer MoS2 with
sub-nanometer precision using electrochemical reaction (ECR). The
electrochemical reaction on the surface of single-layer MoS2 is initiated at
the location of defects or single atom vacancy, followed by the successive
removals of individual atoms or unit cells from single-layer MoS2 lattice and
finally formation of a nanopore. Step-like features in the ionic current
through the growing nanopore provide direct feedback on the nanopore size
inferred from a widely used conductance vs. pore size model. Furthermore, DNA
translocations can be detected in-situ when as-fabricated MoS2 nanopores are
used. The atomic resolution and accessibility of this approach paves the way
for mass production of nanopores in 2D membranes for potential solid-state
nanopore sequencing.Comment: 13 pages, 4 figure
High throughput characterization of epitaxially grown single-layer MoS2
The growth of single-layer MoS2 with chemical vapor deposition is an established method that can produce large-area and high quality samples. In this article, we investigate the geometrical and optical properties of hundreds of individual single-layer MoS2 crystallites grown on a highly-polished sapphire substrate. Most of the crystallites are oriented along the terraces of the sapphire substrate and have an area comprised between 10 µm2 and 60 µm2. Differential reflectance measurements performed on these crystallites show that the area of the MoS2 crystallites has an influence on the position and broadening of the B exciton while the orientation does not influence the A and B excitons of MoS2. These measurements demonstrate that differential reflectance measurements have the potential to be used to characterize the homogeneity of large-area chemical vapor deposition (CVD)-grown samples
Large-area epitaxial monolayer MoS2
Two-dimensional semiconductors such as MoS2 are an emerging material family with wide-ranging potential applications in electronics, optoelectronics, and energy harvesting. Large-area growth methods are needed to open the way to applications. Control over lattice orientation during growth remains a challenge. This is needed to minimize or even avoid the formation of grain boundaries, detrimental to electrical, optical, and mechanical properties of MoS2 and other 2D semiconductors. Here, we report on the growth of high-quality monolayer MoS2 with control over lattice orientation. We show that the monolayer film is composed of coalescing single islands with limited numbers of lattice orientation due to an epitaxial growth mechanism. Optical absorbance spectra acquired over large areas show significant absorbance in the high-energy part of the spectrum, indicating that MoS2 could also be interesting for harvesting this region of the solar spectrum and fabrication of UV-sensitive photodetectors. Even though the interaction between the growth substrate and MoS2 is strong enough to induce lattice alignment via van der Waals interaction, we can easily transfer the grown material and fabricate devices. Local potential mapping along channels in field-effect transistors shows that the single-crystal MoS2 grains in our film are well connected, with interfaces that do not degrade the electrical conductivity. This is also confirmed by the relatively large and length-independent mobility in devices with a channel length reaching 80um
Magnetoexcitons in large area CVD-grown monolayer MoS2 and MoSe2 on sapphire
Magnetotransmission spectroscopy was employed to study the valley Zeeman effect in large area monolayer MoS2 and MoSe2. The extracted values of the valley g factors for both A and B excitons were found to be similar with g(v) similar or equal to -4.5. The samples are expected to be strained due to the CVD growth on sapphire at high temperature (700 degrees C). However, the estimated strain, which is maximum at low temperature, is only similar or equal to 0.2%. Theoretical considerations suggest that the strain is too small to significantly influence the electronic properties. This is confirmed by the measured value of the valley g factor, and the measured temperature dependence of the band gap, which are almost identical for CVD and mechanically exfoliated MoS2
Recommended from our members
High Responsivity, Large-Area Graphene/MoS Flexible Photodetectors.
We present flexible photodetectors (PDs) for visible wavelengths fabricated by stacking centimeter-scale chemical vapor deposited (CVD) single layer graphene (SLG) and single layer CVD MoS, both wet transferred onto a flexible polyethylene terephthalate substrate. The operation mechanism relies on injection of photoexcited electrons from MoS to the SLG channel. The external responsivity is 45.5A/W and the internal 570A/W at 642 nm. This is at least 2 orders of magnitude higher than bulk-semiconductor flexible membranes. The photoconductive gain is up to 4 Ă— 10. The photocurrent is in the 0.1-100 ÎĽA range. The devices are semitransparent, with 8% absorptance at 642 nm, and are stable upon bending to a curvature of 1.4 cm. These capabilities and the low-voltage operation (<1 V) make them attractive for wearable applications.European Union Graphene Flagship, European Research Council (Grant ID: Hetero2D), Engineering and Physical Sciences Research Council (Grant IDs: EP/509 K01711X/1, EP/K017144/1, EP/N010345/1, EP/M507799/5101, EP/L016087/1), Swiss SNF Sinergia (Grant ID: 147607), Marie Curie ITN network MoWSeS (Grant ID: 317451
Geometrical Effect in 2D Nanopores
A long-standing problem in the application of solid-state nanopores is the lack of the precise control over the geometry of artificially formed pores compared to the well-defined geometry in their biological counterpart, that is, protein nanopores. To date, experimentally investigated solid-state nanopores have been shown to adopt an approximately circular shape. In this Letter, we investigate the geometrical effect of the nanopore shape on ionic blockage induced by DNA translocation using triangular h-BN nanopores and approximately circular molybdenum disulfide (MoS2) nanopores. We observe a striking geometry-dependent ion scattering effect, which is further corroborated by a modified ionic blockage model. The well-acknowledged ionic blockage model is derived from uniform ion permeability through the 2D nanopore plane and hemisphere like access region in the nanopore vicinity. On the basis of our experimental results, we propose a modified ionic blockage model, which is highly related to the ionic profile caused by geometrical variations. Our findings shed light on the rational design of 2D nanopores and should be applicable to arbitrary nanopore shapes.This work was financially supported by the European Research Council (grant 259398, PorABEL), by a Swiss National Science Foundation (SNSF) Consolidator grant (BIONIC BSCGI0_157802), by SNSF Sinergia grant 147607 ... The work performed in Cambridge was supported by the EPSRC Cambridge NanoDTC, EP/L015978/1. The work performed in UIUC was supported by grants from Oxford Nanopore Technology and the Seeding Novel Interdisciplinary Research Program of the Beckman Institute. The UIUC authors gratefully acknowledge also supercomputer time provided through the Extreme Science and Engineering Discovery Environment (XSEDE) grant MCA93S028 and by the University of Illinois at Urbana-Champaign on the TAUB cluster
- …