6,833 research outputs found
Environmental effects on the tensile strength of chemically vapor deposited silicon carbide fibers
The room temperature and elevated temperature tensile strengths of commercially available chemically vapor-deposited (CVD) silicon carbide fibers were measured after 15 min heat treatment to 1600 C in various environments. These environments included oxygen, air, argon and nitrogen at one atmosphere and vacuum at 10/9 atmosphere. Two types of fibers were examined which differed in the SiC content of their carbon-rich coatings. Threshold temperature for fiber strength degradation was observed to be dependent on the as-received fiber-flaw structure, on the environment and on the coating. Fractographic analyses and flexural strength measurements indicate that tensile strength losses were caused by surface degradation. Oxidation of the surface coating is suggested as one possible degradation mechanism. The SiC fibers containing the higher percentage of SiC near the surface of the carbon-rich coating show better strength retention and higher elevated temperature strength
Geometry of flux attachment in anisotropic fractional quantum Hall states
Fractional quantum Hall (FQH) states are known to possess an internal metric
degree of freedom that allows them to minimize their energy when contrasting
geometries are present in the problem (e.g., electron band mass and dielectric
tensor). We investigate the internal metric of several incompressible FQH
states by probing its response to band mass anisotropy using infinite DMRG
simulations on a cylinder geometry. We test and apply a method to extract the
internal metric of a FQH state from its guiding center structure factor. We
find that the response to band mass anisotropy is approximately the same for
states in the same Jain sequence, but changes substantially between different
sequences. We provide a theoretical explanation of the observed behavior of
primary states at filling in terms of a minimal microscopic model
of flux attachment.Comment: 12 pages including references, 14 figure
Hopping Conduction in Uniaxially Stressed Si:B near the Insulator-Metal Transition
Using uniaxial stress to tune the critical density near that of the sample,
we have studied in detail the low-temperature conductivity of p-type Si:B in
the insulating phase very near the metal-insulator transition. For all values
of temperature and stress, the conductivity collapses onto a single universal
scaling curve. For large values of the argument, the scaling function is well
fit by the exponentially activated form associated with variable range hopping
when electron-electron interactions cause a soft Coulomb gap in the density of
states at the Fermi energy. The temperature dependence of the prefactor,
corresponding to the T-dependence of the critical curve, has been determined
reliably for this system, and is proportional to the square-root of T. We show
explicitly that nevlecting the prefactor leads to substantial errors in the
determination of the scaling parameters and the critical exponents derived from
them. The conductivity is not consistent with Mott variable-range hopping in
the critical region nor does it obey this form for any range of the parameters.
Instead, for smaller argument of the scaling function, the conductivity of Si:B
is well fit by an exponential form with exponent 0.31 related to the critical
exponents of the system at the metal- insulator transition.Comment: 13 pages, 6 figure
Narasimham Committee Report - Some Further Ramifications and Suggestions
This paper while agreeing with the general thrust of the Narasimham Committee Report. Calls attention to some logical corollaries of the Report and analyses some possible fallout from implementing the Report. We agree with the view that control of banking system should be under an autonomous body supervised by the RBI. However at the level of individual banks, closer scrutiny of lending procedures may be called for than is envisaged in the Report. In a freely functioning capital market the potential of government bonds is enormous, but this necessitates restructuring of the government bond market. The government bonds may then also be used as suitable hedging mechanisms by introducing options and futures trading. We recommend freeing up the operation of pension and provident fund to enable at least partial investment of such funds in risky securities. In the corporate sector, we believe that the current 2:1 debt equity norm is too high and not sustainable in the long term. We envisage that high debt levels and higher interest rates, combined with higher business risk may result in greater incidence of corporate sickness. This may call for various schemes for retrenched workers and amendment to land laws for easy exit of companies. On account of interdependencies across different policies, any sequencing of their implementation may be highly problematic. We therefore suggest a near simultaneity in the implementation of various reforms in order to build up a momentum which would be irreversible if people are to have confidence that the reforms will endure, and if we are to retain our credibility with international financial institutions.
Quantum and Classical Glass Transitions in
When performed in the proper low field, low frequency limits, measurements of
the dynamics and the nonlinear susceptibility in the model Ising magnet in
transverse field, , prove the existence
of a spin glass transition for = 0.167 and 0.198. The classical behavior
tracks for the two concentrations, but the behavior in the quantum regime at
large transverse fields differs because of the competing effects of quantum
entanglement and random fields.Comment: 5 pages, 5 figures. Updated figure 3 with corrected calibration
information for thermometr
Bound Magnetic Polaron Interactions in Insulating Doped Diluted Magnetic Semiconductors
The magnetic behavior of insulating doped diluted magnetic semiconductors
(DMS) is characterized by the interaction of large collective spins known as
bound magnetic polarons. Experimental measurements of the susceptibility of
these materials have suggested that the polaron-polaron interaction is
ferromagnetic, in contrast to the antiferromagnetic carrier-carrier
interactions that are characteristic of nonmagnetic semiconductors. To explain
this behavior, a model has been developed in which polarons interact via both
the standard direct carrier-carrier exchange interaction (due to virtual
carrier hopping) and an indirect carrier-ion-carrier exchange interaction (due
to the interactions of polarons with magnetic ions in an interstitial region).
Using a variational procedure, the optimal values of the model parameters were
determined as a function of temperature. At temperatures of interest, the
parameters describing polaron-polaron interactions were found to be nearly
temperature-independent. For reasonable values of these constant parameters, we
find that indirect ferromagnetic interactions can dominate the direct
antiferromagnetic interactions and cause the polarons to align. This result
supports the experimental evidence for ferromagnetism in insulating doped DMS.Comment: 11 pages, 7 figure
Absence of Conventional Spin-Glass Transition in the Ising Dipolar System LiHo_xY_{1-x}F_4
The magnetic properties of single crystals of LiHo_xY_{1-x}F_4 with x=16.5%
and x=4.5% were recorded down to 35 mK using a micro-SQUID magnetometer. While
this system is considered as the archetypal quantum spin glass, the detailed
analysis of our magnetization data indicates the absence of a phase transition,
not only in a transverse applied magnetic field, but also without field. A
zero-Kelvin phase transition is also unlikely, as the magnetization seems to
follow a non-critical exponential dependence on the temperature. Our analysis
thus unmasks the true, short-ranged nature of the magnetic properties of the
LiHo_xY_{1-x}F_4 system, validating recent theoretical investigations
suggesting the lack of phase transition in this system.Comment: 5 pages, 4 figure
Steady-state simulations using weighted ensemble path sampling
We extend the weighted ensemble (WE) path sampling method to perform rigorous
statistical sampling for systems at steady state. The straightforward
steady-state implementation of WE is directly practical for simple landscapes,
but not when significant metastable intermediates states are present. We
therefore develop an enhanced WE scheme, building on existing ideas, which
accelerates attainment of steady state in complex systems. We apply both WE
approaches to several model systems confirming their correctness and efficiency
by comparison with brute-force results. The enhanced version is significantly
faster than the brute force and straightforward WE for systems with WE bins
that accurately reflect the reaction coordinate(s). The new WE methods can also
be applied to equilibrium sampling, since equilibrium is a steady state
On Line Chemical Cleaning of Critical Heat Exchangers for Cooling Water Deposit and their Control to Sustain High Production Level of Methanol - An Experience and Case Study at GNFC
Deposit control is the most critical aspect of cooling water treatment because it is directly related to very purpose for a cooling system heat removal. Any deposit present in heat transfer surfaces impairs heat removal and there for reduces the efficiency of entire system.
Cooling water deposits are of two types - scales and fouling. Scales are hard dense, crystalline deposits for-med by the precipitation of dissolved materials when their solubility have been exceeded due to change in conditions. Foulants form softer non crystalline deposits because suspended materials settle out or adhere to metal surfaces
Recommended from our members
Dosimetric Analysis of Neural and Vascular Structures in Skull Base Tumors Treated with Stereotactic Radiosurgery.
Objective To examine the relationship between the prescribed target dose and the dose to healthy neurovascular structures in patients with vestibular schwannomas treated with stereotactic radiosurgery (SRS). Study Design Case series with chart review. Setting SRS center from 2011 to 2013. Subjects Twenty patients with vestibular schwannomas treated at the center from 2011 to 2013. Methods Twenty patients with vestibular schwannomas were included. The average radiation dose delivered to healthy neurovascular structures (eg, carotid artery, basilar artery, facial nerve, trigeminal nerve, and cochlea) was analyzed. Results Twenty patients with vestibular schwannomas who were treated with fused computed tomography/magnetic resonance imaging-guided SRS were included in the study. The prescribed dose ranged from 10.58 to 17.40 Gy over 1 to 3 hypofractions to cover 95% of the target tumor volume. The mean dose to the carotid artery was 5.66 Gy (95% confidence interval [CI], 4.53-6.80 Gy), anterior inferior cerebellar artery was 8.70 Gy (95% CI, 4.54-12.86 Gy), intratemporal facial nerve was 3.76 Gy (95% CI, 3.04-4.08 Gy), trigeminal nerve was 5.21 Gy (95% CI, 3.31-7.11 Gy), and the cochlea was 8.70 Gy (95% CI, 7.81-9.59 Gy). Conclusions SRS for certain vestibular schwannomas can expose the anterior inferior cerebellar artery (AICA) and carotid artery to radiation doses that can potentially initiate atherosclerotic processes. The higher doses to the AICA and carotid artery correlated with increasing tumor volume. The dose delivered to other structures such as the cochlea and intratemporal facial nerve appears to be lower and much less likely to cause immediate complications when shielded
- …