2,214 research outputs found
Preliminary results of the MIDTAL project: a microarray chip to monitor toxic dinoflagellates in the Orkney Islands, U.K.
Harmful algae can cause economic damage to fisheries and tourism. Additionally, toxins produced by harmful algae and ingested via contaminated shellfish can be potentially fatal to humans. Monitoring these harmful algae can be difficult as determining cell morphology by light microscopy may be insufficient to give definitive species attribution. The goal of the EU FP7 project MIDTAL (microarrays for the detection of toxic algae) was to achieve rapid species identification using species specific probes for rRNA genes in a microarray chip format. Field samples from the Orkney Islands, an area of the U.K. that has a number of nuisance and toxic species were tested with the second generation of the microarray chip. Species specific probes were looked at for the toxin producing dinoflagellates Alexandrium tamarense Group III (North American clade) and Dinophysis acuta and also general class probes for Dinophyta, Heterokontaphyta and Prymnesiophyta over the course of a year. These were compared with light microscopy cell counts. A good agreement in determining presence and absence between the methods was found. The second generation microarray is potentially more sensitive than cell counts. However, further work is needed to ensure that the microarray signal for each species provides an accurate quantitative assessment
CMS endcap RPC gas gap production for upgrade
The CMS experiment will install a RE4 layer of 144 new Resistive Plate Chambers (RPCs) on the existing york YE3 at both endcap regions to trigger high momentum muons from the proton-proton interaction. In this paper, we present the detailed procedures used in the production of new RPC gas gaps adopted in the CMS upgrade. Quality assurance is enforced as ways to maintain the same quality of RPC gas gaps as the existing 432 endcap RPC chambers that have been operational since the beginning of the LHC operation
Performance of the Gas Gain Monitoring system of the CMS RPC muon detector and effective working point fine tuning
The Gas Gain Monitoring (GGM) system of the Resistive Plate Chamber (RPC)
muon detector in the Compact Muon Solenoid (CMS) experiment provides fast and
accurate determination of the stability in the working point conditions due to
gas mixture changes in the closed loop recirculation system. In 2011 the GGM
began to operate using a feedback algorithm to control the applied voltage, in
order to keep the GGM response insensitive to environmental temperature and
atmospheric pressure variations. Recent results are presented on the feedback
method used and on alternative algorithms
The Upgrade of the CMS RPC System during the First LHC Long Shutdown
The CMS muon system includes in both the barrel and endcap region Resistive
Plate Chambers (RPC). They mainly serve as trigger detectors and also improve
the reconstruction of muon parameters. Over the years, the instantaneous
luminosity of the Large Hadron Collider gradually increases. During the LHC
Phase 1 (~first 10 years of operation) an ultimate luminosity is expected above
its design value of 10^34/cm^2/s at 14 TeV. To prepare the machine and also the
experiments for this, two long shutdown periods are scheduled for 2013-2014 and
2018-2019. The CMS Collaboration is planning several detector upgrades during
these long shutdowns. In particular, the muon detection system should be able
to maintain a low-pT threshold for an efficient Level-1 Muon Trigger at high
particle rates. One of the measures to ensure this, is to extend the present
RPC system with the addition of a 4th layer in both endcap regions. During the
first long shutdown, these two new stations will be equipped in the region
|eta|<1.6 with 144 High Pressure Laminate (HPL) double-gap RPCs operating in
avalanche mode, with a similar design as the existing CMS endcap chambers.
Here, we present the upgrade plans for the CMS RPC system for the fist long
shutdown, including trigger simulation studies for the extended system, and
details on the new HPL production, the chamber assembly and the quality control
procedures.Comment: 9 pages, 6 figures, presented by M.Tytgat at the XI workshop on
Resistive Plate Chambers and Related Detectors (RPC2012), INFN - Laboratori
Nazionali di Frascati, February 5-10, 201
Construction and Performance of Large-Area Triple-GEM Prototypes for Future Upgrades of the CMS Forward Muon System
At present, part of the forward RPC muon system of the CMS detector at the
CERN LHC remains uninstrumented in the high-\eta region. An international
collaboration is investigating the possibility of covering the 1.6 < |\eta| <
2.4 region of the muon endcaps with large-area triple-GEM detectors. Given
their good spatial resolution, high rate capability, and radiation hardness,
these micro-pattern gas detectors are an appealing option for simultaneously
enhancing muon tracking and triggering capabilities in a future upgrade of the
CMS detector. A general overview of this feasibility study will be presented.
The design and construction of small (10\times10 cm2) and full-size trapezoidal
(1\times0.5 m2) triple-GEM prototypes will be described. During detector
assembly, different techniques for stretching the GEM foils were tested.
Results from measurements with x-rays and from test beam campaigns at the CERN
SPS will be shown for the small and large prototypes. Preliminary simulation
studies on the expected muon reconstruction and trigger performances of this
proposed upgraded muon system will be reported.Comment: 7 pages, 25 figures, submitted for publication in conference record
of the 2011 IEEE Nuclear Science Symposium, Valencia, Spai
Simulation of the CMS Resistive Plate Chambers
The Resistive Plate Chamber (RPC) muon subsystem contributes significantly to
the formation of the trigger decision and reconstruction of the muon trajectory
parameters. Simulation of the RPC response is a crucial part of the entire CMS
Monte Carlo software and directly influences the final physical results. An
algorithm based on the parametrization of RPC efficiency, noise, cluster size
and timing for every strip has been developed. Experimental data obtained from
cosmic and proton-proton collisions at TeV have been used for
determination of the parameters. A dedicated validation procedure has been
developed. A good agreement between the simulated and experimental data has
been achieved.Comment: to be published in JINS
An overview of the design, construction and performance of large area triple-GEM prototypes for future upgrades of the CMS forward muon system
GEM detectors are used in high energy physics experiments given their good spatial resolution, high rate capability and radiation hardness. An international collaboration is investigating the possibility of covering the 1.6 < vertical bar eta vertical bar < 2.4 region of the CMS muon endcaps with large-area triple-GEM detectors. The CMS high-eta area is actually not fully instrumented, only Cathode Strip Chamber (CSC) are installed. The vacant area presents an opportunity for a detector technology able to to cope with the harsh radiation environment; these micropattern gas detectors are an appealing option to simultaneously enhance muon tracking and triggering capabilities in a future upgrade of the CMS detector. A general overview of this feasibility study is presented. Design and construction of small (10cm x 10cm) and full-size trapezoidal (1m x 0.5m) triple-GEM prototypes is described. Results from measurements with x-rays and from test beam campaigns at the CERN SPS is shown for the small and large prototypes. Preliminary simulation studies on the expected muon reconstruction and trigger performances of this proposed upgraded muon system are reported
Tests of multigap RPCs for high-eta triggers in CMS
In this paper, we report a systematic study of multigap Resistive Plate Chambers (RPCs) for high-eta triggers in CMS. Prototype RPC modules with four- and six-gap structures have been constructed with phenolic high-pressure-laminated (HPL) plates and tested with cosmic muons and gamma rays irradiated from a 200-mCi Cs-137 source. The detector characteristics of the prototype multigap RPCs were compared with those of the double-gap RPCs currently used in the CMS experiment at LHC. The mean values for detector charges of cosmic-muon signals drawn in the four- and six-gap RPCs for the efficiency values in the middle of the plateau were about 1.5 and 0.9 pC, respectively, when digitized with charge thresholds of 150 and 100 fC, respectively. They were respectively about one third and one fifth of that drawn in the current CMS double-gap RPC with a charge threshold of 200 fC. We concluded from the current R&D that use of the current phenolic-HPL multigap RPCs is advantageous to the high-eta triggers in CMS in virtue of the smaller detector pulses
Recommended from our members
Inclusive J/Ï production at mid-rapidity in pp collisions at âs = 5.02 TeV
Inclusive J/Ï production is studied in minimum-bias proton-proton collisions at a centre-of-mass energy of s = 5.02 TeV by ALICE at the CERN LHC. The measurement is performed at mid-rapidity (|y| < 0.9) in the dielectron decay channel down to zero transverse momentum pT, using a data sample corresponding to an integrated luminosity of Lint = 19.4 ± 0.4 nbâ1. The measured pT-integrated inclusive J/Ï production cross sec- tion is dÏ/dy = 5.64 ± 0.22(stat.) ± 0.33(syst.) ± 0.12(lumi.) ÎŒb. The pT-differential cross section d2Ï/dpTdy is measured in the pT range 0â10 GeV/c and compared with state-of- the-art QCD calculations. The J/Ï ăpTă and ăpT2ă are extracted and compared with results obtained at other collision energies. [Figure not available: see fulltext.]
Recommended from our members
Measurement of Î (1520) production in pp collisions at âs=7TeV and pâPb collisions at âsNN=5.02TeV
The production of the Î (1520) baryonic resonance has been measured at midrapidity in inelastic pp collisions at s=7TeV and in pâPb collisions at sNN=5.02TeV for non-single diffractive events and in multiplicity classes. The resonance is reconstructed through its hadronic decay channel Î (1520) â pK - and the charge conjugate with the ALICE detector. The integrated yields and mean transverse momenta are calculated from the measured transverse momentum distributions in pp and pâPb collisions. The mean transverse momenta follow mass ordering as previously observed for other hyperons in the same collision systems. A Blast-Wave function constrained by other light hadrons (Ï, K, KS0, p, Î) describes the shape of the Î (1520) transverse momentum distribution up to 3.5GeV/c in pâPb collisions. In the framework of this model, this observation suggests that the Î (1520) resonance participates in the same collective radial flow as other light hadrons. The ratio of the yield of Î (1520) to the yield of the ground state particle Î remains constant as a function of charged-particle multiplicity, suggesting that there is no net effect of the hadronic phase in pâPb collisions on the Î (1520) yield
- âŠ