639 research outputs found
Temperature effects on the 15-85 mu m spectra of olivines and pyroxenes
Far-infrared spectra of laboratory silicates are normally obtained at room temperature even though the grains responsible for astronomical silicate emission bands seen at wavelengths >20 μm are likely to be at temperatures below ∼150 K. In order to investigate the effect of temperature on silicate spectra, we have obtained absorption spectra of powdered forsterite and olivine, along with two orthoenstatites and diopside clinopyroxene, at 3.5±0.5 K and at room temperature (295±2 K). To determine the changes in the spectra the resolution must be increased from ∼1 to 0.25 cm−1 at both temperatures, because a reduction in temperature reduces the phonon density, thereby reducing the width of the infrared peaks. Several bands observed at 295 K split at 3.5 K. At 3.5 K the widths of isolated single bands in olivine, enstatites and diopside are ∼90 per cent of their 295-K widths. However, in forsterite the 3.5-K widths of the 31-, 49- and 69-μm bands are, respectively, 90, 45 and 31 per cent of their 295-K widths. Owing to an increase in phonon energy as the lattice contracts, 3.5-K singlet peaks occur at shorter wavelengths than do the corresponding 295-K peaks; the magnitude of the wavelength shift increases from ∼0–0.2 μm at 25 μm to ∼0.9 μm at 80 μm. In olivines and enstatites the wavelength shifts can be approximated by polynomials of the form ax+bx2 where x=λpk(295 K) and the coefficients a and b differ between minerals; for diopside this formula gives a lower limit to the shift. Changes in the relative absorbances of spectral peaks are also observed. The temperature dependence of λpk and bandwidth shows promise as a means to deduce characteristic temperatures of mineralogically distinct grain populations. In addition, the observed changes in band strength with temperature will affect estimates of grain masses and relative mineral abundances inferred using room-temperature laboratory data. Spectral measurements of a variety of minerals at a range of temperatures are required to quantify these effects fully
Performance of horn-coupled transition edge sensors for L- and S-band optical detection on the SAFARI instrument
We describe the geometry, architecture, dark- and optical performance of ultra-low-noise transition edge sensors as THz detectors for the SAFARI instrument. The TESs are fabricated from superconducting Mo/Au bilayers coupled to impedance-matched superconducting ß-phase Ta thin-film absorbers. The detectors have phonon-limited dark noise equivalent powers of order 0.5 - 1.0 aW/ and saturation powers of order 20 - 40 fW. The low temperature test configuration incorporating micro-machined backshorts is also described, and construction and typical performance characteristics for the optical load are shown. We report preliminary measurements of the optical performance of these TESs for two SAFARI bands; L-band at 110 - 210 µm and S-band 34 - 60 µm .European Space AgencyThis is the final version of the article. It first appeared from SPIE via http://dx.doi.org/10.1117/12.223274
The 69-mu m forsterite band as a dust temperature indicator
A band of pure crystalline forsterite (100 per cent Mg2SiO4) occurs at 69.67 μm at room temperature (295 K); for olivines with ≳10 per cent Fe the corresponding feature is at ≳73 μm. The Mg-rich forsterite feature is observed in a variety of ISO LWS spectra, but the corresponding Fe-rich olivine feature is not. For the 10 astronomical sources in our sample, the forsterite band peaks in the 68.9–69.3 μm range and narrows with decreasing peak wavelength. This is consistent with the shortwards shifting of the peak observed when laboratory samples are cooled to 77 K (69.07 μm) and 3.5 K (68.84 μm). The shifted peak is produced by lattice contraction and the sharpening is due to a decrease in phonon density at lower temperatures. However, the astronomical bands are narrower than those of the laboratory samples. By comparing the laboratory and astronomical peak wavelengths, we deduce characteristic forsterite 69-μm band temperatures that are in the 27–84 K range for the eight post-main-sequence objects in our sample. These values are shown to be consistent with the local continuum temperatures derived using a β=1.5 dust emissivity index, similar to derived interstellar values of the opacity index. For the pre-main sequence-objects HD 100546 and MWC 922, the characteristic 69-μm forsterite band temperatures (127±18 and 139±10 K, respectively) are significantly higher than those of the post-main-sequence objects and are more than twice as high as their local continuum temperatures deduced using β=1.5. The assumption of large grains (β=0) can produce agreement between the derived 69-μm and continuum temperatures for one of these objects but not for the other — a spatial separation between the forsterite and continuum-emitting grains may therefore be implied for it. We conclude that observations of the peak wavelength and FWHM of the 69-μm forsterite band show great promise as a new diagnostic of characteristic grain temperatures
Broadband coated lens solutions for FIR-mm-wave instruments
This paper presents recent results of ongoing European Space Agency funded program of work aimed at developing large dielectric lenses suitable for future satellite missions, with a particular focus on requirements for CMB polarimetry. Two lens solutions are being investigated: (i) polymer lenses with broadband multi-layer antireflection coatings; (ii) silicon lenses with surface-structured anti-reflection coating represented by directly machined pyramidal features. For each solution, base materials with and without coatings have been optically characterized over a range of temperatures down to ∼10 K. Full lens solutions are under manufacture and will be tested in a bespoke large cryo-optical facility
Development and application of metamaterial-based half-wave plates for the NIKA and NIKA2 polarimeters
Context. Large field-of-view imaging and polarimetry instruments operating at millimetre and sub-millimetre wavelengths are fundamental tools to understand the role of magnetic fields in channelling filament material into prestellar cores, providing unique insight in the physics of galactic star-forming regions. Among other topics, at extra-galactic scales, polarisation observations of Active Galactic Nuclei (AGNs) will allow us to constrain the possible physical conditions of the emitting plasma from the jets and/or explore the physics of dust inside supernova remnants. The kilo-pixel New IRAM KIDs Array 2 (NIKA2) camera, installed today at the Institut de Radioastronomie Millimétrique (IRAM) 30-m telescope, represents one of the best tools available to astronomers to produce simultaneous intensity and polarimetry maps over large fields at 260 GHz (1.15 mm). Aims. The polarisation measurement, in NIKA and NIKA2, is achieved by rapidly modulating the total incoming polarisation. In the end, this allows one to safely isolate the small science signal from the large, un-polarised, and strongly variable, atmospheric background. Methods. The polarisation modulation is achieved by inserting a fast rotating half-wave plate (HWP) in the optical beam. In order to allow wide field-of-view observations, the plate has to be large, with a diameter of 250 mm. The modulation of the polarised signal at 12 Hz also requires the waveplate to be sufficiently light. In addition, this key optical element has to exhibit optimal electromagnetic characteristics in terms of transmission and differential phase-shift. For this purpose, three metamaterial HWPs have been developed using the mesh-filter technology. The knowledge acquired in developing the first two single-band HWPs was used to achieve the more challenging performance requirements of the last dual-band HWP. The first and the third waveplates met the requirements for both the NIKA and NIKA2 instruments. Results. We first illustrate the design, the technical developments, the fabrication, and laboratory characterisation of the three mesh-HWPs. The deployment of two such elements in the NIKA and NIKA2 instruments at the 30-metre telescope is then described. We conclude with representative examples of astrophysical maps integrating polarimetry
D-brane potentials in the warped resolved conifold and natural inflation
In this paper we obtain a model of Natural Inflation from string theory with
a Planckian decay constant. We investigate D-brane dynamics in the background
of the warped resolved conifold (WRC) throat approximation of Type IIB string
compactifications on Calabi-Yau manifolds. When we glue the throat to a compact
bulk Calabi-Yau, we generate a D-brane potential which is a solution to the
Laplace equation on the resolved conifold. We can exactly solve this equation,
including dependence on the angular coordinates. The solutions are valid down
to the tip of the resolved conifold, which is not the case for the more
commonly used deformed conifold. This allows us to exploit the effect of the
warping, which is strongest at the tip. We inflate near the tip using an
angular coordinate of a D5-brane in the WRC which has a discrete shift
symmetry, and feels a cosine potential, giving us a model of Natural Inflation,
from which it is possible to get a Planckian decay constant whilst maintaining
control over the backreaction. This is because the decay constant for a wrapped
brane contains powers of the warp factor, and so can be made large, while the
wrapping parameter can be kept small enough so that backreaction is under
control.Comment: 41 pages, 3 appendices, 1 figure, PDFLaTex; various clarifications
added along with a new appendix on b-axions and wrapped D5 branes;version
matches the one published in JHE
The Thermal Design, Characterization, and Performance of the SPIDER Long-Duration Balloon Cryostat
We describe the SPIDER flight cryostat, which is designed to cool six
millimeter-wavelength telescopes during an Antarctic long-duration balloon
flight. The cryostat, one of the largest to have flown on a stratospheric
payload, uses liquid helium-4 to deliver cooling power to stages at 4.2 and 1.6
K. Stainless steel capillaries facilitate a high flow impedance connection
between the main liquid helium tank and a smaller superfluid tank, allowing the
latter to operate at 1.6 K as long as there is liquid in the 4.2 K main tank.
Each telescope houses a closed cycle helium-3 adsorption refrigerator that
further cools the focal planes down to 300 mK. Liquid helium vapor from the
main tank is routed through heat exchangers that cool radiation shields,
providing negative thermal feedback. The system performed successfully during a
17 day flight in the 2014-2015 Antarctic summer. The cryostat had a total hold
time of 16.8 days, with 15.9 days occurring during flight.Comment: 15 pgs, 17 fig
Probable or improbable universe? Correlating electroweak vacuum instability with the scale of inflation
- …