305 research outputs found

    Role of MgO barriers for spin and charge transport in Co/MgO/graphene non-local spin-valve devices

    Full text link
    We investigate spin and charge transport in both single and bilayer graphene non-local spin-valve devices. Similar to previous studies on bilayer graphene, we observe an inverse dependence of the spin lifetime on the carrier mobility in our single layer devices. This general trend is only observed in devices with large contact resistances. Furthermore, we observe a second Dirac peak in devices with long spin lifetimes. This results from charge transport underneath the contacts. In contrast, all devices with low ohmic contact resistances only exhibit a single Dirac peak. Additionally, the spin lifetime is significantly reduced indicating that an additional spin dephasing occurs underneath the electrodes.Comment: 5 pages, 3 figure

    Fabrication of comb-drive actuators for straining nanostructured suspended graphene

    Full text link
    We report on the fabrication and characterization of an optimized comb-drive actuator design for strain-dependent transport measurements on suspended graphene. We fabricate devices from highly p-doped silicon using deep reactive ion etching with a chromium mask. Crucially, we implement a gold layer to reduce the device resistance from ≈51.6\approx51.6 kΩ\mathrm{\Omega} to ≈236\approx236 Ω\mathrm{\Omega} at room temperature in order to allow for strain-dependent transport measurements. The graphene is integrated by mechanically transferring it directly onto the actuator using a polymethylmethacrylate membrane. Importantly, the integrated graphene can be nanostructured afterwards to optimize device functionality. The minimum feature size of the structured suspended graphene is 30 nm, which allows for interesting device concepts such as mechanically-tunable nanoconstrictions. Finally, we characterize the fabricated devices by measuring the Raman spectrum as well as the a mechanical resonance frequency of an integrated graphene sheet for different strain values.Comment: 10 pages, 9 figure

    Tunable mechanical coupling between driven microelectromechanical resonators

    Full text link
    We present a microelectromechanical system, in which a silicon beam is attached to a comb-drive actuator, that is used to tune the tension in the silicon beam, and thus its resonance frequency. By measuring the resonance frequencies of the system, we show that the comb-drive actuator and the silicon beam behave as two strongly coupled resonators. Interestingly, the effective coupling rate (~ 1.5 MHz) is tunable with the comb-drive actuator (+10%) as well as with a side-gate (-10%) placed close to the silicon beam. In contrast, the effective spring constant of the system is insensitive to either of them and changes only by ±\pm 0.5%. Finally, we show that the comb-drive actuator can be used to switch between different coupling rates with a frequency of at least 10 kHz.Comment: 5 pages, 4 figures, 1 tabl

    Cavity-enhanced single photon emission from a single impurity-bound exciton

    Full text link
    Impurity-bound excitons in ZnSe quantum wells are bright single photon emitters--a crucial element in photonics-based quantum technology. But to achieve the efficiencies required for practical applications, these emitters must be integrated into optical cavities that enhance their radiative properties and far-field emission pattern. In this work, we demonstrate cavity-enhanced emission from a single impurity-bound exciton in a ZnSe quantum well. We utilize a bullseye cavity structure optimized to feature a small mode volume and a nearly Gaussian far-field transverse mode that can efficiently couple to an optical fiber. The fabricated device displays emission that is more than an order of magnitude brighter than bulk impurity-bound exciton emitters in the ZnSe quantum well, as-well-as clear anti-bunching, which verifies the single photon emission from the source. Time-resolved photoluminescence spectroscopy reveals a Purcell-enhanced radiative decay process with a Purcell factor of 1.43. This work paves the way towards high efficiency spin-photon interfaces using an impurity-doped II-VI semiconductor coupled to nanophotonics

    Interfacial mixing in heteroepitaxial growth

    Full text link
    We investigate the growth of a film of some element B on a substrate made of another substrance A in a model of molecular beam epitaxy. A vertical exchange mechanism allows the A-atoms to stay on the growing surface with a certain probability. Using kinetic Monte Carlo simulations as well as scaling arguments, the incorporation of the A's into the growing B-layer is investigated. Moreover we develop a rate equation theory for this process. In the limit of perfect layer-by-layer growth, the density of A-atoms decays in the B-film like the inverse squared distance from the interface. The power law is cut off exponentially at a characteristic thickness of the interdiffusion zone that depends on the rate of exchange of a B-adatom with an A-atom in the surface and on the system size. Kinetic roughening changes the exponents. Then the thickness of the interdiffusion zone is determined by the diffusion length.Comment: 11 pages, 11 figure

    Electrical resistance of individual defects at a topological insulator surface

    Full text link
    Three-dimensional topological insulators host surface states with linear dispersion, which manifest as a Dirac cone. Nanoscale transport measurements provide direct access to the transport properties of the Dirac cone in real space and allow the detailed investigation of charge carrier scattering. Here, we use scanning tunnelling potentiometry to analyse the resistance of different kinds of defects at the surface of a (Bi0.53Sb0.47)2Te3 topological insulator thin film. The largest localized voltage drop we find to be located at domain boundaries in the topological insulator film, with a resistivity about four times higher than that of a step edge. Furthermore, we resolve resistivity dipoles located around nanoscale voids in the sample surface. The influence of such defects on the resistance of the topological surface state is analysed by means of a resistor network model. The effect resulting from the voids is found to be small compared to the other defects

    Two-dimensional photonic crystal cavities in ZnSe quantum well structures

    Full text link
    ZnSe and related materials like ZnMgSe and ZnCdSe are promising II-VI host materials for optically mediated quantum information technology such as single photon sources or spin qubits. Integrating these heterostructures into photonic crystal (PC) cavities enables further improvements, for example realizing Purcell-enhanced single photon sources with increased quantum efficiency. Here we report on the successful implementation of two-dimensional (2D) PC cavities in strained ZnSe quantum wells (QW) on top of a novel AlAs supporting layer. This approach overcomes typical obstacles associated with PC membrane fabrication in strained materials, such as cracks and strain relaxation in the corresponding devices. We demonstrate the attainment of the required mechanical stability in our PC devices, complete strain retainment and effective vertical optical confinement. Structural analysis of our PC cavities reveals excellent etching anisotropy. Additionally, elemental mapping in a scanning transmission electron microscope confirms the transformation of AlAs into AlOx by post-growth wet oxidation and reveals partial oxidation of ZnMgSe at the etched sidewalls in the PC. This knowledge is utilized to tailor FDTD simulations and to extract the ZnMgSe dispersion relation with small oxygen content. Optical characterization of the PC cavities with cross-polarized resonance scattering spectroscopy verifies the presence of cavity modes. The excellent agreement between simulation and measured cavity mode energies demonstrates wide tunability of the PC cavity and proves the pertinence of our model. This implementation of 2D PC cavities in the ZnSe material system establishes a solid foundation for future developments of ZnSe quantum devices

    (Si)GeSn nanostructures for light emitters

    Get PDF
    Energy-efficient integrated circuits for on-chip or chip-to-chip data transfer via photons could be tackled by monolithically grown group IV photonic devices. The major goal here is the realization of fully integrated group IV room temperature electrically driven lasers. An approach beyond the already demonstrated optically-pumped lasers would be the introduction of GeSn/(Si)Ge(Sn) heterostructures and exploitation of quantum mechanical effects by reducing the dimensionality, which affects the density of states. In this contribution we present epitaxial growth, processing and characterization of GeSn/(Si)Ge(Sn) heterostructures, ranging from GeSn/Ge multi quantum wells (MQWs) to GeSn quantum dots (QDs) embedded in a Ge matrix. Light emitting diodes (LEDs) were fabricated based on the MQW structure and structurally analyzed via TEM, XRD and RBS. Moreover, EL measurements were performed to investigate quantum confinement effects in the wells. The GeSn QDs were formed via Sn diffusion /segregation upon thermal annealing of GeSn single quantum wells (SQW) embedded in Ge layers. The evaluation of the experimental results is supported by band structure calculations of GeSn/(Si)Ge(Sn) heterostructures to investigate their applicability for photonic devices

    Integrated impedance bridge for absolute capacitance measurements at cryogenic temperatures and finite magnetic fields

    Full text link
    We developed an impedance bridge that operates at cryogenic temperatures (down to 60 mK) and in perpendicular magnetic fields up to at least 12 T. This is achieved by mounting a GaAs HEMT amplifier perpendicular to a printed circuit board containing the device under test and thereby parallel to the magnetic field. The measured amplitude and phase of the output signal allows for the separation of the total impedance into an absolute capacitance and a resistance. Through a detailed noise characterization, we find that the best resolution is obtained when operating the HEMT amplifier at the highest gain. We obtained a resolution in the absolute capacitance of 6.4~aF/Hz/\sqrt{\textrm{Hz}} at 77 K on a comb-drive actuator, while maintaining a small excitation amplitude of 15~kBT/ek_\text{B} T/e. We show the magnetic field functionality of our impedance bridge by measuring the quantum Hall plateaus of a top-gated hBN/graphene/hBN heterostructure at 60~mK with a probe signal of 12.8~kBT/ek_\text{B} T/e.Comment: 7 pages, 5 figure
    • …
    corecore