9,357 research outputs found
Little-Parks oscillations near a persistent current loop
We investigate the Little-Parks oscillations caused by a persistent current
loop set on the top edge of a mesoscopic superconducting thin-walled cylinder
with a finite height. For a short cylinder the Little-Parks oscillations are
approximately the same ones as the standard effect, as there is only one
magnetic flux piercing the cylinder. For a tall cylinder the inhomogeneity of
the magnetic field makes different magnetic fluxes pierce the cylinder at
distinct heights and we show here that this produces two distinct Little-Parks
oscillatory regimes according to the persistent current loop. We show that
these two regimes, and also the transition between them, are observable in
current measurements done in the superconducting cylinder. The two regimes stem
from different behavior along the height, as seen in the order parameter,
numerically obtained from the Ginzburg-Landau theory through the finite element
methodComment: 13 pages, 12 figure
Entanglement detection in hybrid optomechanical systems
We study a device formed by a Bose Einstein condensate (BEC) coupled to the
field of a cavity with a moving end-mirror and find a working point such that
the mirror-light entanglement is reproduced by the BEC-light quantum
correlations. This provides an experimentally viable tool for inferring
mirror-light entanglement with only a limited set of assumptions. We prove the
existence of tripartite entanglement in the hybrid device, persisting up to
temperatures of a few milli-Kelvin, and discuss a scheme to detect it.Comment: 6 pages, 7 figures, published versio
Optimization of graphene-based materials outperforming host epoxy matrices
The degree of graphite exfoliation and edge-carboxylated layers can be controlled and balanced to design lightweight materials characterized by both low electrical percolation thresholds (EPT) and improved mechanical properties. So far, this challenging task has been undoubtedly very hard to achieve. The results presented in this paper highlight the effect of exfoliation degree and the role of edge-carboxylated graphite layers to give self-assembled structures embedded in the polymeric matrix. Graphene layers inside the matrix may serve as building blocks of complex systems that could outperform the host matrix. Improvements in electrical percolation and mechanical performance have been obtained by a synergic effect due to finely balancing the degree of exfoliation and the chemistry of graphene edges which favors the interfacial interaction between polymer and carbon layers. In particular, for epoxy-based resins including two partially exfoliated graphite samples, differing essentially in the content of carboxylated groups, the percolation threshold reduces from 3 wt% down to 0.3 wt%, as the carboxylated group content increases up to 10 wt%. Edge-carboxylated nanosheets also increase the nanofiller/epoxy matrix interaction, determining a relevant reinforcement in the elastic modulus
The Average Kinetic Energy of the Superconducting State
Isothermal magnetization curves are plotted as the magnetization times the
magnetic induction, , versus the applied field, H. We show
here that this new curve is the average kinetic energy of the superconducting
state versus the applied field, for type-II superconductors with a high
Ginzburg-Landau parameter . The maximum of occurs at
a field, , directly related to the upper critical field, ,
suggesting that may be extracted from such plots even in cases when
it is too high for direct measurement. We obtain these plots both
theoretically, from the Ginzburg-Landau theory, and experimentally, using a
Niobium sample with , and compare them.Comment: 11 pages, 9 postscript figure
Closed form micro-macro relationships for periodic masonry
The use of theoretical models for providing a constitutive identification of masonry, starting from the individual properties of the phases (i.e. mortar and bricks), constitutes an attractive alternative to costly experimental investigations. In the case of brickwork with periodic texture, the latter issue is tackled resorting to the homogenization theory by Anthoine [1] and solved by means of the finite element method. In order to obtain closed form formulations many authors in literature made simplifying assumptions regarding either the masonry bond, Pande et al. [2], or the joints thickness, Cecchi & Sab [3]. The simplifications adopted turn out to introduce significant errors in the results when either a large difference in stiffness between the phases or a non negligible thickness of the joint are encountered.
In the present paper a homogenization procedure is presented, which takes into account the effect of the bond and the Poisson-type interaction between mortar and brick. Assuming a simplified kinematics for the phases belonging to the R.V.E., the so-called localization problem is solved by imposing the minimization of the average internal strain energy. Closed form formulations are then derived for the equivalent in-plane elastic constants of masonry. The expressions found are consistent with those obtained in literature in the limit cases in which masonry is tackled as a stratified medium or where the joints are treated as interfaces. The accuracy of the results is investigated by means of a comparison with finite element analysis. A parametric study, conducted varying the geometries and the mechanical properties of the phases, shows that the error introduced over a very wide range of values for the elastic properties is lower than 8%, meaning that the procedure is ready to be used for non-linear analysis
Effect of the boundary condition on the vortex patterns in mesoscopic three-dimensional superconductors - disk and sphere
The vortex state of mesoscopic three-dimensional superconductors is
determined using a minimization procedure of the Ginzburg-Landau free energy.
We obtain the vortex pattern for a mesoscopic superconducting sphere and find
that vortex lines are naturally bent and are closest to each other at the
equatorial plane. For a superconducting disk with finite height, and under an
applied magnetic field perpendicular to its major surface, we find that our
method gives results consistent with previous calculations. The matching
fields, the magnetization and , are obtained for models that differ
according to their boundary properties. A change of the Ginzburg-Landau
parameters near the surface can substantially enhance as shown here.Comment: 7 pages, 4 figures (low resolution
The current progress of the ALICE Ring Imaging Cherenkov Detector
Recently, the last two modules (out of seven) of the ALICE High Momentum
Particle Identification detector (HMPID) were assembled and tested. The full
detector, after a pre-commissioning phase, has been installed in the
experimental area, inside the ALICE solenoid, at the end of September 2006. In
this paper we review the status of the ALICE/HMPID project and we present a
summary of the series production of the CsI photo-cathodes. We describe the key
features of the production procedure which ensures high quality photo-cathodes
as well as the results of the quality assessment performed by means of a
specially developed 2D scanner system able to produce a detailed map of the CsI
photo-current over the entire photo-cathode surface.
Finally we present our recent R&D efforts toward the development of a novel
generation of imaging Cherenkov detectors with the aim to identify, in heavy
ions collisions, hadrons up to 30 GeV/c.Comment: Presented at the Imaging-2006 Conference, Stockholm, Sweden, June
200
The Internal Ultraviolet-to-Optical Color Dispersion: Quantifying the Morphological K-Correction
We present a quantitative measure of the internal color dispersion within
galaxies, which quantifies differences in morphology as a function of
wavelength. We apply this statistic to a local galaxy sample with archival
images at 1500 and 2500 Angstroms from the Ultraviolet Imaging Telescope, and
ground-based B-band observations to investigate how the color dispersion
relates to global galaxy properties. The intenal color dispersion generally
correlates with transformations in galaxy morphology as a function of
wavelength, i.e., it quantifies the morphological K-correction. Mid-type spiral
galaxies exhibit the highest dispersion in their internal colors, which stems
from differences in the bulge, disk, and spiral-arm components. Irregulars and
late-type spirals show moderate internal color dispersion, which implies that
young stars generally dominate the colors. Ellipticals, lenticulars, and
early-type spirals generally have low or negligible internal color dispersion,
which indicates that the stars contributing to the UV-to-optical emission have
a very homogeneous distribution. We discuss the application of the internal
color dispersion to high-redshift galaxies in deep, Hubble Space Telescope
images. By simulating local galaxies at cosmological distances, many of the
galaxies have luminosities that are sufficiently bright at rest--frame optical
wavelengths to be detected within the limits of the currently deepest
near-infrared surveys even with no evolution. Under assumptions that the
luminosity and color evolution of the local galaxies conform with the measured
values of high-redshift objects, we show that galaxies' intrinsic internal
color dispersion remains measurable out to z ~ 3.Comment: Accepted for publication in the Astrophysical Journal. 41 pages, 13
figures (3 color). Full resolution version (~8 Mb) available at
http://mips.as.arizona.edu/~papovich/papovich_astroph.p
- …