Laser-Plasma Interactions Enabled by Emerging Technologies

An overview from the past and an outlook for the future of fundamental laser-plasma interactions research enabled by emerging laser systems

Demonstration of Fuel Hot-Spot Pressure in Excess of 50 Gbar for Direct-Drive, Layered Deuterium-Tritium Implosions on OMEGA

A record fuel hot-spot pressure P[subscript hs] = 56±7  Gbar was inferred from x-ray and nuclear diagnostics for direct-drive inertial confinement fusion cryogenic, layered deuterium–tritium implosions on the 60-beam, 30-kJ, 351-nm OMEGA Laser System. When hydrodynamically scaled to the energy of the National Ignition Facility, these implosions achieved a Lawson parameter ∼60% of the value required for ignition [A. Bose et al., Phys. Rev. E 93, LM15119ER (2016)], similar to indirect-drive implosions [R. Betti et al., Phys. Rev. Lett. 114, 255003 (2015)], and nearly half of the direct-drive ignition-threshold pressure. Relative to symmetric, one-dimensional simulations, the inferred hot-spot pressure is approximately 40% lower. Three-dimensional simulations suggest that low-mode distortion of the hot spot seeded by laser-drive nonuniformity and target-positioning error reduces target performance.United States. Department of Energy (DE-NA0001944

Lawson criterion for ignition exceeded in an inertial fusion experiment

For more than half a century, researchers around the world have been engaged in attempts to achieve fusion ignition as a proof of principle of various fusion concepts. Following the Lawson criterion, an ignited plasma is one where the fusion heating power is high enough to overcome all the physical processes that cool the fusion plasma, creating a positive thermodynamic feedback loop with rapidly increasing temperature. In inertially confined fusion, ignition is a state where the fusion plasma can begin "burn propagation" into surrounding cold fuel, enabling the possibility of high energy gain. While "scientific breakeven" (i.e., unity target gain) has not yet been achieved (here target gain is 0.72, 1.37 MJ of fusion for 1.92 MJ of laser energy), this Letter reports the first controlled fusion experiment, using laser indirect drive, on the National Ignition Facility to produce capsule gain (here 5.8) and reach ignition by nine different formulations of the Lawson criterion

Upconversion-induced heat generation and thermal lensing in Nd:YLF and Nd:YAG

We investigate the influence of interionic upconversion between neighboring ions in the upper laser level of Nd:YLF and Nd:YAG on population dynamics, heat generation, and thermal lensing under lasing and non-lasing conditions. It is shown that cascaded multiphonon relaxations following each upconversion process generate significant extra heat dissipation in the crystal under non-lasing compared to lasing conditions. Owing to the unfavorable temperature dependence of thermal and thermo-optical parameters, this leads, firstly, to a significant temperature increase in the rod, secondly, to strong thermal lensing with pronounced spherical aberrations and, ultimately, to rod fracture in a high-power end-pumped system. In a three-dimensional finite-element calculation, excitation densities, upconversion rates, heat generation temperature profiles, and thermal lensing are calculated. Differences in thermal lens power between non-lasing and lasing conditions up to a factor of six in Nd:YLF and up to a factor of two in Nd:YAG are experimentally observed and explained by the calculation. This results in a strong deterioration in performance when operating these systems in a Q-switched regime, as an amplifier, or on a low-gain transition. Methods to decrease the influence of interionic upconversion are discussed. It is shown that tuning of the pump wavelength can significantly alter the rod temperature