2,314 research outputs found
Time-resolved photoluminescence of the size-controlled ZnO nanorods
Size dependence of the time-resolved photoluminescence (TRPL) has been investigated for the ZnO nanorods fabricated by catalyst-free metalorganic chemical vapor deposition. The nanorods have a diameter of 35 nm and lengths in the range of 150 nm to 1.1 mum. The TRPL decay rate decreases monotonically as the length of the nanorods increases in the range of 150 to 600 nm. Decrease of the radiative decay rate of the exciton-polariton has been invoked to account for the results. (C) 2003 American Institute of Physics.X11100sciescopu
Excitonic emissions observed in ZnO single crystal nanorods
We report on the photoluminescent characteristics of ZnO single crystal nanorods grown by catalyst-free metalorganic vapor phase epitaxy. From photoluminescence (PL) spectra of the nanorods at 10 K, several PL peaks were observed at 3.376, 3.364, 3.360, and 3.359 eV. The PL peak at 3.376 eV is attributed to a free exciton peak while the other peaks are ascribed to neutral donor bound exciton peaks. The observation of the free exciton peak at 10 K indicates that ZnO nanorods prepared by the catalyst-free method are of high optical quality. (C) 2003 American Institute of Physics.open11374393sciescopu
Computational investigation of particle penetration and deposition pattern in a realistic respiratory tract model from different types of dry powder inhalers
The aim of this study was to evaluate the device performance of a new design by comparing with a typical commercial DPI. Computational fluid dynamics (CFD) coupled with the discrete element method (DEM) collision has been utilized in this study to characterize and examine the flow field and particle transportation, respectively. A typical commercial DPI and an in-house designed novel DPI with distinct design features were compared to explore their dispersion capabilities and suitability for delivery to the respiratory tract. For this exploration, realistic oral to larynx and tracheobronchial airway models consisting of bio-relevant features were adopted to enhance practical feasibility. Distinct aerosol performances were observed between the two DPIs in the respiratory tract, where the in-house DPI, in comparison with the commercial DPI, has shown approximately 30% lower deposition fraction in the mouth-throat region with approximately 7% higher escape rate in the tracheobronchial region under the identical inhalation condition. This observation demonstrates that a novel in-house designed DPI provides higher device efficiency over the selected typical commercial DPI
Significant factors of aviation insurance and risk management strategy: An empirical study of Taiwanese airline carriers
[[abstract]]Aviation insurance premiums have become a heavy burden for the airline industry since September 11, 2001. Although the industry must constantly balance its operations between profitability and safety, the reality is that airlines are in the business of making money. Therefore, their ability to reduce cost and manage risk is a key factor for success. Unlike past research, which used subjective judgment methods, this study applied quantitative historical data (1999–2000) and gray relation analysis to identify the primary factors influencing ratemaking for aviation insurance premiums. An empirical study of six airlines in Taiwan was conducted to determine these factors and to analyze the management strategies used to deal with them. Results showed that the loss experience and performance of individual airlines were the key elements associated with aviation insurance premiums paid by each airline. By identifying and understanding the primary factors influencing ratemaking for aviation insurance, airlines will better understand their relative operational strengths and weaknesses, and further help top management identify areas for further improvement. Knowledge of these factors combined with effective risk management strategies, may result in lower premiums and operating costs for airline companies
Mismatch Repair–Independent Increase in Spontaneous Mutagenesis in Yeast Lacking Non-Essential Subunits of DNA Polymerase ε
Yeast DNA polymerase ε (Pol ε) is a highly accurate and processive enzyme that participates in nuclear DNA replication of the leading strand template. In addition to a large subunit (Pol2) harboring the polymerase and proofreading exonuclease active sites, Pol ε also has one essential subunit (Dpb2) and two smaller, non-essential subunits (Dpb3 and Dpb4) whose functions are not fully understood. To probe the functions of Dpb3 and Dpb4, here we investigate the consequences of their absence on the biochemical properties of Pol ε in vitro and on genome stability in vivo. The fidelity of DNA synthesis in vitro by purified Pol2/Dpb2, i.e. lacking Dpb3 and Dpb4, is comparable to the four-subunit Pol ε holoenzyme. Nonetheless, deletion of DPB3 and DPB4 elevates spontaneous frameshift and base substitution rates in vivo, to the same extent as the loss of Pol ε proofreading activity in a pol2-4 strain. In contrast to pol2-4, however, the dpb3Δdpb4Δ does not lead to a synergistic increase of mutation rates with defects in DNA mismatch repair. The increased mutation rate in dpb3Δdpb4Δ strains is partly dependent on REV3, as well as the proofreading capacity of Pol δ. Finally, biochemical studies demonstrate that the absence of Dpb3 and Dpb4 destabilizes the interaction between Pol ε and the template DNA during processive DNA synthesis and during processive 3′ to 5′exonucleolytic degradation of DNA. Collectively, these data suggest a model wherein Dpb3 and Dpb4 do not directly influence replication fidelity per se, but rather contribute to normal replication fork progression. In their absence, a defective replisome may more frequently leave gaps on the leading strand that are eventually filled by Pol ζ or Pol δ, in a post-replication process that generates errors not corrected by the DNA mismatch repair system
Signal transducer and activator of transcription 3-mediated CD133 up-regulation contributes to promotion of hepatocellular carcinoma
published_or_final_versio
Iron content in forage sorghum (Sorghum bicolor (L.) Moench) measured on different slit widths with atomic absorption spectrometry
Our objective was to know the right slit width for iron (Fe) concentration of forage sorghum, sorghum hybrid (Sorghum bicolor (L.) Moench), and also to discern which water treatment sludge (WTS) were good for ruminant's health with the feeding sorghum on the present study. The present experiment was carried out on a randomized block design with four treatments; Control, alum sludge compost, alum sludge + NPK (nitrogen, phosphorus, potassium fertilizers), alum sludge compost + NPK (nitrogen, phosphorus, potassium fertilizers). Sorghum hybrid was harvested, and iron content of it was analyzed with an atomic absorption spectrophotometer on background correction (BGC) mode. In order to analyze the iron (Fe) content of the sorghum with the spectrophotometer, three different slit widths conditions were used; 0.15, 0.20 and 0.25 nm. Absorbance and background values were obtained during the Fe analyses with the apparatus. When the background value is small, it is preferred for some trace metals’ analyses. Both (AM/BS) ratio (mean of the absorbance values<AM> to the standard deviation of back ground values<BS>) and (AS<standard deviation of the absorbance values>/BS) ratio, were larger on 0.25 nm slit than those on 0.15 and 0.20 nm slit, and, from our experiment, the condition seemed better on the 0.25 nm slit for the iron analysis with the spectrophotometer. Therefore, the sorghum hybrid grown on (Alum+NPK) and on (Compost only) might be dangerous for ruminants because of their higher values than 200 mg Fe/kg DM (dry matter).Key words: Absorbance, alum sludge, atomic absorption spectrophotometer, background, forage sorghum hybrid, iron, slit
Direct exfoliation and dispersion of two-dimensional materials in pure water via temperature control
The high-volume synthesis of two-dimensional (2D) materials in the form of platelets is desirable for various applications. While water is considered an ideal dispersion medium, due to its abundance and low cost, the hydrophobicity of platelet surfaces has prohibited its widespread use. Here we exfoliate 2D materials directly in pure water without using any chemicals or surfactants. In order to exfoliate and disperse the materials in water, we elevate the temperature of the sonication bath, and introduce energy via the dissipation of sonic waves. Storage stability greater than one month is achieved through the maintenance of high temperatures, and through atomic and molecular level simulations, we further discover that good solubility in water is maintained due to the presence of platelet surface charges as a result of edge functionalization or intrinsic polarity. Finally, we demonstrate inkjet printing on hard and flexible substrates as a potential application of water-dispersed 2D materials.close1
Comparing factors affecting commencement and cessation of betel quid chewing behavior in Taiwanese adults
<p>Abstract</p> <p>Background</p> <p>Betel quid is the fourth most common used substance in the world after tobacco, alcohol and caffeine. Although factors related to betel quid chewing or cessation of behaviors were reported previously, few studies simultaneously compared both behaviors in the same population. In addition, it is essential to consider time-to-event concept, since the chance of developing or stopping habit may vary over time. The purpose of this study was to compare the risk factors for commencement and cessation of betel quid chewing behaviors in a time-to-event setting.</p> <p>Methods</p> <p>A stratified multi-stage cluster sampling with selection probabilities proportional to size (PPS) was designed for Taiwanese adults with aged 18 years old and above. Kaplan-Meier estimates and Cox proportional hazard regression models were used to compare and calculate the hazard rate ratios for related factors to commencement or cessation of chewing habits.</p> <p>Results</p> <p>In Taiwan, men had a higher betel quid chewing rate (M: 20.9%, W: 1.2%), but woman chewers had a lower cessation rate (M: 27.5%, W: 12.7%). The hazard rate ratio (HRR) of having chewing habit changed from 4.22 (men vs women) univariately to 1.38 multivariablely, which indicated gender differences were confounded by other factors. In multivariable analysis, the risk factors of gender, education and ethnicity were significantly associated with both starting and cessation of betel quid chewing behavior. The factors of occupation, cigarette smoking and alcohol drinking were only associated with starting habit.</p> <p>Conclusion</p> <p>Commencement or cessation of chewing behavior involves a scenario of time, hence it is preferable to use a time-to-event approach for the comparison. The cessation rates of betel quid chewing were decreasingly associated with the daily consumption of betel quid. Hence, reducing of daily amount in betel quid cessation program may be associated with future stopping habit.</p
- …