GaAs-GaAlAs distributed-feedback diode lasers with separate optical and carrier confinement

Remarkable reduction of the threshold current density is achieved in GaAs-GaAlAs distributed-feedback diode lasers by adopting a separate-confinement heterostructure. The diodes are lased successfully at temperatures up to 340 °K under pulsed operation. The lowest threshold current density is 3 kA/cm^2 at 300 °K

Liquid phase epitaxy of GaAlAs on GaAs substrates with fine surface corrugations

Liquid phase epitaxy of GaAlAs was performed on GaAs fine surface corrugations. By optimizing the growth conditions, GaAlAs layers were grown successfully with only minimal meltback

Second Cluster Integral and Excluded Volume Effects for the Pion Gas

The quantum mechanical formula for Mayer's second cluster integral for the gas of relativistic particles with hard-core interaction is derived. The proper pion volume calculated with quantum mechanical formula is found to be an order of magnitude larger than its classical evaluation. The second cluster integral for the pion gas is calculated in quantum mechanical approach with account for both attractive and hard-core repulsive interactions. It is shown that, in the second cluster approximation, the repulsive pion-pion-interactions as well as the finite width of resonances give important but almost canceling contributions. In contrast, an appreciable deviation from the ideal gas of pions and pion resonances is observed beyond the second cluster approximation in the framework of the Van der Waals excluded-volume model.Comment: 29 pages, Latex, 9 PS-figure

Optimizing tuning masses for helicopter rotor blade vibration reduction including computed airloads and comparison with test data

The development and validation of an optimization procedure to systematically place tuning masses along a rotor blade span to minimize vibratory loads are described. The masses and their corresponding locations are the design variables that are manipulated to reduce the harmonics of hub shear for a four-bladed rotor system without adding a large mass penalty. The procedure incorporates a comprehensive helicopter analysis to calculate the airloads. Predicting changes in airloads due to changes in design variables is an important feature of this research. The procedure was applied to a one-sixth, Mach-scaled rotor blade model to place three masses and then again to place six masses. In both cases the added mass was able to achieve significant reductions in the hub shear. In addition, the procedure was applied to place a single mass of fixed value on a blade model to reduce the hub shear for three flight conditions. The analytical results were compared to experimental data from a wind tunnel test performed in the Langley Transonic Dynamics Tunnel. The correlation of the mass location was good and the trend of the mass location with respect to flight speed was predicted fairly well. However, it was noted that the analysis was not entirely successful at predicting the absolute magnitudes of the fixed system loads

Searching for Z′Z' bosons decaying to gluons

The production and decay of a new heavy vector boson, a chromophilic $Z'$ vector boson, is described. The chromophilic $Z'$ couples only to two gluons, but its two-body decays are absent, leading to a dominant decay mode of $Z'\rightarrow q\bar{q}g$. The unusual nature of the interaction predicts a cross-section which grows with $m_{Z'}$ for a fixed coupling and an accompanying gluon with a coupling that rises with its energy. We study the $t\bar{t}g$ decay mode, proposing distinct reconstruction techniques for the observation of an excess and for the measurement of $m_{Z'}$. We estimate the sensitivity of current experimental datasets.Comment: For submission to PR

An imaging time-of-propagation system for charged particle identification at a super B factory

Super B factories that will further probe the flavor sector of the Standard Model and physics beyond will demand excellent charged particle identification (PID), particularly K/pi separation, for momenta up to 4 GeV/c, as well as the ability to operate under beam backgrounds significantly higher than current B factory experiments. We describe an Imaging Time-of-Propagation (iTOP) detector which shows significant potential to meet these requirements. Photons emitted from charged particle interactions in a Cerenkov radiator bar are internally reflected to the end of the bar, where they are collected on a compact image plane using photodetectors with fine spatial segmentation in two dimensions. Precision measurements of photon arrival time are used to enhance the two dimensional imaging, allowing the system to provide excellent PID capabilities within a reduced detector envelope. Results of the ongoing optimization of the geometric and physical properties of such a detector are presented, as well as simulated PID performance. Validation of simulations is being performed using a prototype in a cosmic ray test stand at the University of Hawaii.Comment: 3 pages, 5 figures, submitted to TIPP09 proceeding

pH effect on the formation of THM and HAA disinfection byproducts and potential control strategies for food processing

Chlorine-based sanitizers have seen wide spread use in food sanitation. The reaction of chlorine species with organic matter is a concern for two reasons. Available chlorine can be “used up” by organic compounds resulting in a lower amount of chlorine available for disinfection. Another concern is that some forms of chlorine can react with some organic compounds to form toxic halogenated disinfection byproducts (DBPs). Many studies have been conducted to evaluate the role of hypochlorous acid (HOCl) and hypochlorite ion (OCl−) in the production of DBPs with a particular interest in the production of trihalomethanes (THMs) and haloacetic acids (HAAs). Since most of the chlorine reactions are pH dependent, pH is found to have a significant effect on the formation of chlorine DBPs. In many cases, the concentration of THMs decreases and HAAs increases as pH decreases. pH also plays an important role in the determination of the type and amount of DBPs formed, with lower, more acidic, pHs resulting in the formation of less chloroform. This review summarizes the information from the literature on the role of chlorine-based sanitizers as affected by pH in the formation of different types of DBPs. Alternative novel strategies to minimize the formation of DBPs are also discussed

Artifacts with uneven sampling of red noise

The vast majority of sampling systems operate in a standard way: at each tick of a fixed-frequency master clock a digitizer reads out a voltage that corresponds to the value of some physical quantity and translates it into a bit pattern that is either transmitted, stored, or processed right away. Thus signal sampling at evenly spaced time intervals is the rule: however this is not always the case, and uneven sampling is sometimes unavoidable. While periodic or quasi-periodic uneven sampling of a deterministic signal can reasonably be expected to produce artifacts, it is much less obvious that the same happens with noise: here I show that this is indeed the case only for long-memory noise processes, i.e., power-law noises $1/f^\alpha$ with $\alpha > 2$. The resulting artifacts are usually a nuisance although they can be eliminated with a proper processing of the signal samples, but they could also be turned to advantage and used to encode information.Comment: 5 figure