942 research outputs found

    SnRK1 Kinase and the NAC Transcription Factor SOG1 Are Components of a Novel Signaling Pathway Mediating the Low Energy Response Triggered by ATP Depletion

    Get PDF
    Plant growth is strictly controlled by cell division, elongation, and differentiation for which adequate supplies of intracellular ATP are required. However, it is unclear how changes in the amount of intracellular ATP affect cell division and growth. To reveal the specific pathway dependent on ATP concentration, we performed analyses on the Arabidopsis mitochondria mutation sd3. The mutant is tiny, a result of a low amount of ATP caused by the disruption of Tim21, a subunit of the TIM23 protein complex localized in the inner membrane of the mitochondria. Loss of function of suppressor of gamma response 1 (SOG1) also restored the dwarf phenotype of wild type treated with antimycin A, a blocker of ATP synthesis in mitochondria. The sd3 phenotype is partially restored by the introduction of sog1, suppressor of gamma response 1, and kin10/kin11, subunits of Snf1-related kinase 1 (SnRK1). Additionally, SOG1 interacted with SnRK1, and was modified by phosphorylation in planta only after treatment with antimycin A. Transcripts of several negative regulators of the endocycle were up-regulated in the sd3 mutant, and this high expression was not observed in sd3sog1 and sd3kin11. We suggest that there is a novel regulatory mechanism for the control of plant cell cycle involving SnRK1 and SOG1, which is induced by low amounts of intracellular ATP, and controls plant development

    ARSENIC REMOVAL FROM GROUNDWATER USING INDIGENOUS IRON AND MANGANESE OXDIZING BACTERIA

    Full text link
    Joint Research on Environmental Science and Technology for the Eart

    Coronary lumen at six-month follow-up of a new radiopaque Cordis tantalum stent using quantitative angiography and intracoronary ultrasound.

    Get PDF
    To determine the reliability of geometric (edge-detection) quantitative coronary angiographic analysis (QCA) of restenosis within a new Cordis tantalum stent, QCA and intracoronary ultrasound (ICUS) measurements were compared in both an experimental restenosis model and in the clinical follow-up of patients. In the experimental series, Plexiglas phantom vessels with concentric stenosis channels ranging from 0.75 to 3.0 mm in diameter and with a reference diameter of 3.0 mm were imaged both before and after their insertion in tantalum stents. In the clinical series, the agreement of QCA and ICUS measurements were studied in 23 patients who had undergone coronary implantation of the new tantalum stent and in 23 patients who had undergone balloon angioplasty 6 months previously. The reliability of QCA declined in the presence of the radiopaque stent (accuracy of QCA decreased from -0.07 to -0.12 mm), whereas the reliability of lumen measurements by ICUS was independent of the presence of the radiopaque stent (-0.12 and -0.13 mm). Without the stent, the average minimal luminal diameter (MLD) obtained by QCA of the 1.00 mm Plexiglas vessel was 1.00 +/- 0.01 mm, and the 3.00 mm reference vessel diameter was 2.81 +/- 0.05 mm, providing a 64 +/- 1% diameter stenosis. After introduction of the stent, the average MLD and reference vessel diameter were 0.99 +/- 0.06 and 3.36 +/- 0.17 mm, respectively, providing a diameter stenosis of 71 +/- 2%. ICUS measurements (2.77 mm) of the reference vessel diameter (3.00 mm) were unaffected by the presence of the stent. (ABSTRACT TRUNCATED AT 250 WORDS

    Neutral B Flavor Tagging for the Measurement of Mixing-induced CP Violation at Belle

    Full text link
    We describe a flavor tagging algorithm used in measurements of the CP violation parameter sin2phi_1 at the Belle experiment. Efficiencies and wrong tag fractions are evaluated using flavor-specific B meson decays into hadronic and semileptonic modes. We achieve a total effective efficiency of $ 28.8 +- 0.6 %.Comment: 28 pages, 9 figure

    Mass-Enhanced Fermi Liquid Ground State in Na1.5_{1.5}Co2_2O4_4

    Full text link
    Magnetic, transport, and specific heat measurements have been performed on layered metallic oxide Na1.5_{1.5}Co2_2O4_4 as a function of temperature TT. Below a characteristic temperature T∗T^*=30−-40 K, electrical resistivity shows a metallic conductivity with a T2T^2 behavior and magnetic susceptibility deviates from the Curie-Weiss behavior showing a broad peak at ∼\sim14 K. The electronic specific heat coefficient γ\gamma is ∼\sim60 mJ/molK2^2 at 2 K. No evidence for magnetic ordering is found. These behaviors suggest the formation of mass-enhanced Fermi liquid ground state analogous to that in dd-electron heavy fermion compound LiV2_2O4_4.Comment: 4 pages, 4 figures, to be published in Phys. Rev. B 69 (2004

    A new simplified sensorless speed control of induction motor using D-axis voltage

    Get PDF
    This paper presents a new simplified sensorless speed control method of induction motors (IM). The output voltage of d-axis PI current controller is used to compute the flux angle and to control the speed in correspondence with its reference. The effectiveness of the proposed method has been demonstrated by simulations considered PWM and experiments.15th International Conference on Electrical Machines and Systems, ICEMS 2012; Sapporo; Japan; 21 October 2012 ~ 24 October 201

    Low-energy excitations in the three-dimensional random-field Ising model

    Get PDF
    The random-field Ising model (RFIM), one of the basic models for quenched disorder, can be studied numerically with the help of efficient ground-state algorithms. In this study, we extend these algorithm by various methods in order to analyze low-energy excitations for the three-dimensional RFIM with Gaussian distributed disorder that appear in the form of clusters of connected spins. We analyze several properties of these clusters. Our results support the validity of the droplet-model description for the RFIM.Comment: 10 pages, 9 figure

    Physicians' explanatory behaviours and legal liability in decided medical malpractice litigation cases in Japan

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>A physician's duty to provide an adequate explanation to the patient is derived from the doctrine of informed consent and the physician's duty of disclosure. However, findings are extremely limited with respect to physicians' specific explanatory behaviours and what might be regarded as a breach of the physicians' duty to explain in an actual medical setting. This study sought to identify physicians' explanatory behaviours that may be related to the physicians' legal liability.</p> <p>Methods</p> <p>We analysed legal decisions of medical malpractice cases between 1990 and 2009 in which the pivotal issue was the physician's duty to explain (366 cases). To identify factors related to the breach of the physician's duty to explain, an analysis was undertaken based on acknowledged breaches with regard to the physician's duty to explain to the patient according to court decisions. Additionally, to identify predictors of physicians' behaviours in breach of the duty to explain, logistic regression analysis was performed.</p> <p>Results</p> <p>When the physician's explanation was given before treatment or surgery (<it>p </it>= 0.006), when it was relevant or specific (<it>p </it>= 0.000), and when the patient's consent was obtained (<it>p </it>= 0.002), the explanation was less likely to be deemed inadequate or a breach of the physician's duty to explain. Patient factors related to physicians' legally problematic explanations were patient age and gender. One physician factor was related to legally problematic physician explanations, namely the number of physicians involved in the patient's treatment.</p> <p>Conclusion</p> <p>These findings may be useful in improving physician-patient communication in the medical setting.</p
    • …
    corecore