Decoders for MST radars

Decoding techniques and equipment used by MST radars are described and some recommendations for new systems are presented. Decoding can be done either by software in special-purpose (array processors, etc.) or general-purpose computers or in specially designed digital decoders. Both software and hardware decoders are discussed and the special case of decoding for bistatic radars is examined

Spectral moment estimation in MST radars

Signal processing techniques used in Mesosphere-Stratosphere-Troposphere (MST) radars are reviewed. Techniques which produce good estimates of the total power, frequency shift, and spectral width of the radar power spectra are considered. Non-linear curve fitting, autocovariance, autocorrelation, covariance, and maximum likelihood estimators are discussed

The Arecibo Observatory as an MST radar

The radars and other systems at the Arecibo Observatory were designed and built, originally, for incoherent-scatter and radio-astronomy research. More recently, important additions have been made for planetary radar and artificial RF heating of the ionosphere. Although designed and built for a different application, these systems have shown to be very powerful tools for tropospheric, stratospheric and mesospheric research. The Observatory at present has two main radars: one at 430 and the other at 2380 MHz. In addition, 50-MHz MST radar work has been done using portable transmitters brought to the Observatory for this purpose. This capability will become permanent with the recent acquisition of a transmitter at this frequency. Furthermore, control and data processing systems have been developed to use the powerful HF transmitter and antennas of the HF-heating facility as an HF bistatic radar. A brief description of the four radars available at the Observatory is presented

Optimum coding techniques for MST radars

The optimum coding technique for MST (mesosphere stratosphere troposphere) radars is that which gives the lowest possible sidelobes in practice and can be implemented without too much computing power. Coding techniques are described in Farley (1985). A technique mentioned briefly there but not fully developed and not in general use is discussed here. This is decoding by means of a filter which is not matched to the transmitted waveform, in order to reduce sidelobes below the level obtained with a matched filter. This is the first part of the technique discussed here; the second part consists of measuring the transmitted waveform and using it as the basis for the decoding filter, thus reducing errors due to imperfections in the transmitter. There are two limitations to this technique. The first is a small loss in signal to noise ratio (SNR), which usually is not significant. The second problem is related to incomplete information received at the lowest ranges. An appendix shows a technique for handling this problem. Finally, it is shown that the use of complementary codes on transmission and nonmatched decoding gives the lowest possible sidelobe level and the minimum loss in SNR due to mismatch

Capabilities and limitations of the Jicamarca radar as an MST radar

The Jicamarca radar (Long. 76.52W, Lat. 11.56S), located at 20 km from Lima at approximately 500 meters over sea level, is surrounded by mountains which provide a good shield from man-made interference. The radio horizon goes from a few hundred meters, across the dry valley where it is located, to 15 km, along the valley in the direction of the continental divide. This limits the clutter to 15 km, except for one high peak at 21 km. It is the most equatorial of all existing MST radars. Its proximity to the Andes, makes its location unique for the study of lee waves and orographic-induced turbulence. Vertical as well as horizontal projections of MST velocities are obtained by simultaneously pointing with different sections of the antenna into three or four different directions. The transmitters, receivers, and systems for data acquisition, processing, and control are included

Decoding: Codes and hardware implementation

The MST radars vary considerably from one installation to the next in the type of hardware, operating schedule and associated personnel. Most such systems do not have the computing power to decode in software when the decoding must be performed for each received pulse, as is required for certain sets of phase codes. These sets provide the best signal to sidelobe ratio when operating at the minimum band length allowed by the bandwidth of the transmitter. The development of the hardware phase decoder, and the applicability of each to decoding MST radar signals are discussed. A new design for a decoder which is very inexpensive to build, easy to add to an existing system and is capable of decoding on each received pulse using codes with a band length as short as one microsecond is presented

Map the distribution of glaciofluvial deposits and associated glacial landforms

There are no author-identified significant results in this report

Develop a land use-peak runoff classification system for highway engineering purposes

The author has identified the following significant results. Based on the detail study of the Sunkhaze Stream Watershed, it is believed that good detailed drainage studies can be derived from repetitive ERTS imagery. Land use maps tailored to hydrologic study can be prepared from ERTS imagery. Significant changes in the Sunkhaze Stream and Otter Stream Watersheds at spring flood conditions have given important information on the causes for flooding in the town of Bradley