Observation of asymmetric solitons in waveguide arrays with refractive index gradient

We study light propagation in waveguide arrays made in Kerr nonlinear media with a transverse refractive index gradient, and we find that the presence of the refractive index gradient leads to the appearance of a number of new soliton families. The effective coupling between the solitons and the localized linear eigenmodes of the lattice induces a drastic asymmetry in the soliton shapes and the appearance of long tails at the soliton wings. Such unusual solitons are found to be completely stable under propagation, and we report their experimental observation in fs-laser written waveguide arrays with focusing Kerr nonlinearity.Comment: 4 pages, 5 figures, to appear in Optics Letter

Superconducting Electrometer Based on the Resistively Shunted Bloch Transistor

We have fabricated the Bloch transistor shunted on-chip by a small-sized Cr resistor with Rs about 1 kOhm. The Bloch transistor normally consists of two small Josephson junctions connected in series, which in our case have been replaced by two superconducting interferometer loops, each with two junctions in parallel. A capacitively coupled gate is supplied to control the induced charge of the small intermediate electrode (island) of the transistor. The measured I-V curves show no hysteresis and correspond to the operation of a effective Josephson junction at the high-damping and strong-noise limits. The critical current of the system was found to be close to its nominal value, that is in accordance with the electromagnetic environment theory. The I-V curves were modulated by the gate with a period of e and a maximum swing of about 2 /mu_V. Such rather moderate modulation results from the Josephson-to- charging energies ratio, Ej/Ec about 9, in our sample being far from its optimum value of 0.3 up to 1.Comment: To be published in IEEE Transactions on Applied Superconductivity, June 199

Synchronized single electron emission from dynamical quantum dots

We study synchronized quantized charge pumping through several dynamical quantum dots (QDs) driven by a single time modulated gate signal. We show that the main obstacle for synchronization being the lack of uniformity can be overcome by operating the QDs in the decay cascade regime. We discuss the mechanism responsible for lifting the stringent uniformity requirements. This enhanced functionality of dynamical QDs might find applications in nanoelectronics and quantum metrology.Comment: 4 pages, 3 figures, submitted to AP

Impact of loss on the wave dynamics in photonic waveguide lattices

We analyze the impact of loss in lattices of coupled optical waveguides and find that in such case, the hopping between adjacent waveguides is necessarily complex. This results not only in a transition of the light spreading from ballistic to diffusive, but also in a new kind of diffraction that is caused by loss dispersion. We prove our theoretical results with experimental observations.Comment: Accepted for publication in PRL, 5+8 pages (Paper + Supplemental material), 4 figure

Characterization of All-Chromium Tunnel Junctions and Single Electron Tunneling Devices Fabricated by Direct-Writing Multilayer Technique

We report about the fabrication and analysis of the properties of Cr/CrO_x/Cr tunnel junctions and SET transistors, prepared by different variants of direct-writing multilayer technique. In all cases, the CrO_x tunnel barriers were formed in air under ambient conditions. From the experiments on single junctions, values for the effective barrier height and thickness were derived. For the Cr/CrO_x/Cr SET transistors we achieved minimal junction areas of 17 x 60 nm^2 using a scanning transmission electron microscope for the e-beam exposure on Si_3N_4 membrane substrate. We discuss the electrical performance of the transistor samples as well as their noise behavior.Comment: 19 pages, 9 figure

The effect of thermal annealing on the properties of Al-AlOx-Al single electron tunneling transistors

The effect of thermal annealing on the properties of Al-AlOx-Al single electron tunneling transistors is reported. After treatment of the devices by annealing processes in forming gas atmosphere at different temperatures and for different times, distinct and reproducible changes of their resistance and capacitance values were found. According to the temperature regime, we observed different behaviors as regards the resistance changes, namely the tendency to decrease the resistance by annealing at T = 200 degree C, but to increase the resistance by annealing at T = 400 degree C. We attribute this behavior to changes in the aluminum oxide barriers of the tunnel junctions. The good reproducibility of these effects with respect to the changes observed allows the proper annealing treatment to be used for post-process tuning of tunnel junction parameters. Also, the influence of the annealing treatment on the noise properties of the transistors at low frequency was investigated. In no case did the noise figures in the 1/f-regime show significant changes.Comment: 6 pages, 7 eps-figure

A stringent yeast two-hybrid matrix screening approach for protein-protein interaction discovery

The yeast two-hybrid (Y2H) system is currently one of the most important techniques for protein-protein interaction (PPI) discovery. Here, we describe a stringent three-step Y2H matrix interaction approach that is suitable for systematic PPI screening on a proteome scale. We start with the identification and elimination of autoactivating strains that would lead to false-positive signals and prevent the identification of interactions. Nonautoactivating strains are used for the primary PPI screen that is carried out in quadruplicate with arrayed preys. Interacting pairs of baits and preys are identified in a pairwise retest step. Only PPI pairs that pass the retest step are regarded as potentially biologically relevant interactions and are considered for further analysis

Magnetization reversal of an individual exchange biased permalloy nanotube

We investigate the magnetization reversal mechanism in an individual permalloy (Py) nanotube (NT) using a hybrid magnetometer consisting of a nanometer-scale SQUID (nanoSQUID) and a cantilever torque sensor. The Py NT is affixed to the tip of a Si cantilever and positioned in order to optimally couple its stray flux into a Nb nanoSQUID. We are thus able to measure both the NT's volume magnetization by dynamic cantilever magnetometry and its stray flux using the nanoSQUID. We observe a training effect and temperature dependence in the magnetic hysteresis, suggesting an exchange bias. We find a low blocking temperature $T_B = 18 \pm 2$ K, indicating the presence of a thin antiferromagnetic native oxide, as confirmed by X-ray absorption spectroscopy on similar samples. Furthermore, we measure changes in the shape of the magnetic hysteresis as a function of temperature and increased training. These observations show that the presence of a thin exchange-coupled native oxide modifies the magnetization reversal process at low temperatures. Complementary information obtained via cantilever and nanoSQUID magnetometry allows us to conclude that, in the absence of exchange coupling, this reversal process is nucleated at the NT's ends and propagates along its length as predicted by theory.Comment: 8 pages, 4 figure