The environmental analysis of helicopter operations by Federal agencies: Current procedures and research needs

The technical, economic, and environmental problems restricting commercial helicopter passenger operations are reviewed. The key considerations for effective assessment procedures are outlined and a preliminary model for the environmental analysis of helicopters is developed. It is recommended that this model, or some similar approach, be used as a common base for the development of comprehensive environmental assessment methods for each of the federal agencies concerned with helicopters. A description of the critical environmental research issues applicable to helicopters is also presented

Carbon films grown from plasma on III-V semiconductors

Dielectric carbon films were grown on n- and p-type GaAs and InP substrates using plasmas generated at 30 KHz from gaseous hydrocarbons. The effect of gas source, flow rate, and power on film growth were investigated. Methane and n-butane gases were utilized. The flow rate and power ranged from 30 to 50 sccm and 25 to 300 W, respectively. AES measurements show only carbon to be present in the films. The relative Ar ion sputtering rate (3 KeV) of carbon depends on the ratio power/pressure. In addition, the degree of asymmetry associated with the carbon-semiconductor interface is approximately power-independent. SIMS spectra indicate different H-C bonding configurations to be present in the films. Band gaps as high as 3.05 eV are obtained from optical absorption studies

Analysis of combustion instability in liquid propellant engines with or without acoustic cavities

Analytical studies have been made of the relative combustion stability of various propellant combinations when used with hardware configurations representative of current design practices and with or without acoustic cavities. Two combustion instability models, a Priem-type model and a modification of the Northern Research and Engineering (NREC) instability model, were used to predict the variation in engine stability with changes in operating conditions, hardware characteristics or propellant combination, exclusive of acoustic cavity effects. The NREC model was developed for turbojet engines but is applicable to liquid propellant engines. A steady-state combustion model was used to predict the needed input for the instability models. In addition, preliminary development was completed on a new model to predict the influence of an acoustic cavity with specific allowance for the effects the nozzle, steady flow and combustion

Finite element solution of low bond number sloshing

The dynamics of liquid propellant in a low Bond number environment which are critical to the design of spacecraft systems with respect to orbital propellant transfer and attitude control system were investigated. Digital computer programs were developed for the determination of liquid free surface equilibrium shape, lateral slosh natural vibration mode shapes, and frequencies for a liquid in a container of arbitrary axisymmetric shape with surface tension forces the same order of magnitude as acceleration forces. A finite volume element representation of the liquid was used for the vibration analysis. The liquid free surface equilibrium shapes were computed for several tanks at various contact angles and ullage volumes. A configuration was selected for vibration analysis and lateral slosh mode shapes and natural frequencies were obtained. Results are documented

Ellipsometric and optical study of some uncommon insulator films on 3-5 semiconductors

Optical properties of three types of insulating films that show promise in potential applications in the 3-4 semiconductor technology were evaluated, namely a-C:H, BN and CaF2. The plasma deposited a-C:H shows an amorphous behavior with optical energy gaps of approximately 2 to 2.4 eV. These a-C:H films have higher density and/or hardness, higher refractive index and lower optical energy gaps with increasing energy of the particles in the plasma, while the density of states remains unchanged. These results are in agreement, and give a fine-tuned positive confirmation to an existing conjecture on the nature of a-C:H films (1). Ion beam deposited BN films show amorphous behavior with energy gap of 5 eV. These films are nonstoichiometric (B/N approximately 2) and have refractive index, density and/or hardness which are dependent on the deposition conditions. The epitaxially grown CaF2 on GaAs films have optical parameters equal to bulk, but evidence of damage was found in the GaAs at the interface

Growth and patterning of laser ablated superconducting YBa2Cu3O7 films on LaAlO3 substrates

A high quality superconducting film on a substrate with a low dielectric constant is desired for passive microwave circuit applications. In addition, it is essential that the patterning process does not effect the superconducting properties of the thin films to achieve the highest circuit operating temperatures. YBa2Cu3O7 superconducting films were grown on lanthanum aluminate substrates using laser ablation with resulting maximum transition temperature (T sub c) of 90 K. The films were grown on a LaAlO3 which was at 775 C and in 170 mtorr of oxygen and slowly cooled to room temperature in 1 atm of oxygen. These films were then processed using photolithography and a negative photoresist with an etch solution of bromine and ethanol. Results are presented on the effect of the processing on T(sub c) of the film and the microwave properties of the patterned films

INTIMATE PARTNER VIOLENCE RISK AMONG VICTIMS OF YOUTH VIOLENCE: ARE EARLY UNIONS BAD, BENEFICIAL, OR BENIGN?*

Youth violent victimization (YVV) is a risk factor for precocious exits from adolescence via early coresidential union formation. It remains unclear, however, whether these early unions 1) are associated with intimate partner violence (IPV) victimization, 2) interrupt victim continuity or victim–offender overlap through protective and prosocial bonds, or 3) are inconsequential. By using data from the National Longitudinal Study of Adolescent to Adult Health (N = 11,928; 18–34 years of age), we examine competing hypotheses for the effect of early union timing among victims of youth violence (n = 2,479)—differentiating across victimization only, perpetration only, and mutually combative relationships and considering variation by gender. The results from multinomial logistic regression models indicate that YVV increases the risk of IPV victimization in first unions, regardless of union timing; the null effect of timing indicates that delaying union formation would not reduce youth victims’ increased risk of continued victimization. Gender-stratified analyses reveal that earlier unions can protect women against IPV perpetration, but this is partly the result of an increased risk of IPV victimization. The findings suggest that YVV has significant transformative consequences, leading to subsequent victimization by coresidential partners, and this association might be exacerbated among female victims who form early unions. We conclude by discussing directions for future research

An experimental study of high Tc superconducting microstrip transmission lines at 35 GHz and the effect of film morphology

Microstrip transmission lines in the form of ring resonators were fabricated from a number of in-situ grown laser ablated films and post-annealed co-sputtered YBa2Cu3O(7-x) films. The properties of these resonators were measured at 35 GHz and the observed performance is examined in light of the critical temperature (Tc) and film thickness and also the film morphology which is different for the two deposition techniques. It is found that Tc is a major indicator of the film performance for each growth type with film thickness becoming important as it decreases towards 100 A. It is also found that the films with a mixed grain orientation (both a axis and c axis oriented grains) have poorer microwave properties as compared with the primarily c axis oriented material. This is probably due to the significant number of grain boundaries between the different crystallites, which may act as superconducting weak links and contribute to the surface resistance

Imprinted Networks as Chiral Pumps

We investigate the interaction between a chirally imprinted network and a solvent of chiral molecules. We find, a liquid crystalline polymer network is preferentially swollen by one component of a racemic solvent. This ability to separate is linked to the chiral order parameter of the network, and can be reversibly controlled via temperature or a mechanical deformation. It is maximal near the point at which the network loses its imprinted structure. One possible practical application of this effect would be a mechanical device for sorting mixed chiral molecules.Comment: 4 pages, 5 figure