15 research outputs found
Issues with fracturing ice during an ice drilling project in Greenland (EastGRIP)
Drilling an ice core through an ice sheet (typically 2000 to 3000 m thick) is a technical challenge that nonetheless generates valuable and unique information on palaeo-climate and ice dynamics. As technically the drilling cannot be done in one run, the core has to be fractured approximately every 3 m to retrieve core sections from the bore hole. This fracture process is initiated by breaking the core with core-catchers which also clamp the engaged core in the drill head while the whole drill is then pulled up with the winch motor.
This standard procedure is known to become difficult and requires extremely high pulling forces (Wilhelms et al. 2007), in the very deep part of the drill procedure, close to the bedrock of the ice sheet, especially when the ice material becomes warm (approximately -2°C) due to the geothermal heat released from the bedrock. Recently, during the EastGRIP (East Greenland Ice coring Project) drilling we observed a similar issue with breaking off cored sections only with extremely high pulling forces, but started from approximately 1800 m of depth, where the temperature is still very cold (approximately -20°C). This has not been observed at other ice drilling sites. As dependencies of fracture behaviour on crystal orientation and grain size are known (Schulson & Duval 2009) for ice, we thus examined the microstructure in the ice samples close to and at the core breaks.
First preliminary results suggest that these so far unexperienced difficulties are due to the profoundly different c-axes orientation distribution (CPO) in the EastGRIP ice core. In contrast to other deep ice cores which have been drilled on ice domes or ice divides, EastGRIP is located in an ice stream. This location means that the deformation geometry (kinematics) is completely different, resulting in a different CPO (girdle pattern instead of single maximum pattern). Evidence regarding additional grain-size dependence will hopefully help to refine the fracturing procedure, which is possible due to a rather strong grain size layering observed in natural ice formed by snow precipitation.
---------------------
Wilhelms, F.; Sheldon, S. G.; Hamann, I. & Kipfstuhl, S. Implications for and findings from deep ice core drillings - An example: The ultimate tensile strength of ice at high strain rates. Physics and Chemistry of Ice (The proceedings of the International Conference on the Physics and Chemistry of Ice held at Bremerhaven, Germany on 23-28 July 2006), 2007, 635-639
Schulson, E. M. & Duval, P. Creep and Fracture of Ice. Cambridge University Press, 2009, 40
Corrigendum to “Palaeohydrogeology and Transport Parameters Derived from 4He and Cl Profiles in Aquitard Pore Waters in a Large Multilayer Aquifer System, Central Australia”
This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.In the article titled “Palaeohydrogeology and Transport
Parameters Derived from 4
He and Cl Profiles in Aquitard
Pore Waters in a Large Multilayer Aquifer System, Central
Australia” [1], Mr. Stanley D. Smith was missing from the
authors’ list. Mr. Stanley made a significant contribution in
helping with the core sampling protocol, canister leak testing,
and discussing modelling methods. The corrected authors’
list is shown above
Modelo de transporte hidrogeoquĂmico da infiltração de águas residuais com tratamento terciário numa área de dunas, BĂ©lgica
Hydrogeochemical transport modeling of the infiltration of tertiary treated wastewater in a dune area, Belgium
Managed artificial recharge (MAR) is a well-established practice for augmentation of depleted groundwater resources or for environmental benefit. At the St-Andr, MAR site in the Belgian dune area, groundwater resources are optimised through re-use of highly treated wastewater by means of infiltration ponds. The very high quality of the infiltration water sets this system apart from other MAR systems. The low total dissolved solid (TDS) content in the infiltration water (less than 50 mg/L) compared to the dune aquifer (500 mg/L) triggers a number of reactions, increasing the TDS through soil-aquifer passage. Multi-component reactive transport modelling was applied to analyse the geochemical processes that occur. Carbonate dissolution is the main process increasing the TDS of the infiltration water. Oxic aquifer conditions prevail between the infiltration ponds and the extraction wells. This is driven by the high flow velocities, leaving no time to consume O-2 between the ponds and extraction wells. Cation exchange is important when infiltration water is replaced by native dune water or when significant changes in infiltration-water quality occur. The seasonal variation of O-2 and temperature in the infiltration water are the main drivers for seasonal changes in the concentration of all major ions
C-axis distribution (68m of depth) directly measured in SE Shear Margin of NEGIS - Shallow core
Observational fabric (c-axis distribution) data was retrieved from a shallow firn core on the southeast shear margin of NEGIS called S5. The preparation and measurement of the samples follow the principles as described by Weikusat rt al. (2017). All analysed samples are vertical to the ice core axis and have dimensions of about 90 x 70 x 0.3 mm. The sample surfaces were carefully polished with a microtome in the EGRIP trench at -18 °C. After one hour of controlled sublimation, c-axes were measured with an automated fabric analyser by Russel-Head Instruments (FA G50). The data was background corrected before processing, and the Crystal preferred orientation CPO was derived via digital image processing. We here show data of three S5 shallow core samples from a depth of 68 m
Simulating MODFLOW-based reactive transport under radially symmetric flow conditions
Radially symmetric flow and solute transport around point sources and sinks is an important specialized topic of groundwater hydraulics. Analysis of radial flow fields is routinely used to determine heads and flows in the vicinity of point sources or sinks. Increasingly, studies also consider solute transport, biogeochemical processes, and thermal changes that occur in the vicinity of point sources/sinks. Commonly, the analysis of hydraulic processes involves numerical or (semi-) analytical modeling methods. For the description of solute transport, analytical solutions are only available for the most basic transport phenomena. Solving advanced transport problems numerically is often associated with a significant computational burden. However, where axis-symmetry applies, computational cost can be decreased substantially in comparison with full three-dimensional (3D) solutions. In this study, we explore several techniques of simulating conservative and reactive transport within radial flow fields using MODFLOW as the flow simulator, based on its widespread use and ability to be coupled with multiple solute and reactive transport codes of different complexity. The selected transport simulators are MT3DMS and PHT3D. Computational efficiency and accuracy of the approaches are evaluated through comparisons with full 2D/3D model simulations, analytical solutions, and benchmark problems. We demonstrate that radial transport models are capable of accurately reproducing a wide variety of conservative and reactive transport problems provided that an adequate spatial discretization and advection scheme is selected. For the investigated test problems, the computational load was substantially reduced, with the improvement varying, depending on the complexity of the considered reaction network
Investigation into the Cause of Iron-Related Clogging of Groundwater Bores Used for Viticulture in the Limestone Coast, South Australia
Iron-related clogging of boreholes, pumps and dripper lines is a significant and costly problem for irrigators worldwide. The primary cause of iron-related clogging is still debated. Previous studies have described complex interactions between biological clogging and inorganic iron/manganese oxide precipitation. This case study examined groundwater bores used for viticulture irrigation in the Limestone Coast region, a highly productive wine growing area in the SE of South Australia. Iron clogging of bore screens, pumps and dripper systems has been a persistent problem in the region and the issue is perceived to be growing, with irrigators suggesting the widespread introduction of iron-related bacteria (IRB) through drilling equipment to be the root cause of the problem. Analysis of the groundwater microbiology and inorganic chemistry found no apparent correlation between the presence of IRB and the clogging status of wells. In fact, IRB proved to be widespread throughout the limestone aquifer. However, a clear correlation could be found between clogging affected bores and the redox potential of the groundwater with the most severely affected bores strongly oversaturated in respect to iron oxide minerals. Elevated dissolved concentrations of Fe(II) thereby tended to be found in deeper bores, which also were generally more recently drilled. Following decades of less than average rainfall, a tendency to deepen bores in response to widespread declines in water levels has been documented for the SE of South Australia. The gradually widening clogging problem in the region is postulated to be related to the changes in climate in the region, with irrigators increasingly driven to rely on deeper, anoxic iron-rich groundwater resources
Palaeohydrogeology and Transport Parameters Derived from 4He and Cl Profiles in Aquitard Pore Waters in a Large Multilayer Aquifer System, Central Australia
A study of chloride and 4He profiles through an aquitard that separates the Great Artesian Basin from the underlying Arckaringa Basin in central Australia is presented. The aquitard separates two aquifers with long water residence times, due to low recharge rates in the arid climate. One-dimensional solute transport models were used to determine the advective flux of groundwater across the aquitard as well as establish any major changes in past hydrological conditions recorded by variations of the pore water composition. This in situ study showed that both diffusion and slow downward advection (vz=0.7 mm/yr) control solute transport. Numerical simulations show that an increase in chloride concentration in the upper part of the profile is due to a reduction in recharge in the upper aquifer for at least 3000 years. Groundwater extraction since 2008 has likely increased chloride and 4He concentrations in the lower aquifer by pulling up water from deeper layers; however, there has been insufficient time for upward solute transport into the pore water profile by diffusion against downward advection. The transport model of 4He and chloride provides insight into how the two aquifers interact through the aquitard and how climate change is being recorded in the aquitard profile