1,039 research outputs found
How mycorrhizal fungal bio-fertilizer impact on seed yield of field pea and wheat across Saskatchewan prairies
Non-Peer Reviewe
Recommended from our members
Temperature and strain rate effects on the mechanical properties of a polymer-bonded explosive
Abstract: The aim of the research reported here was to investigate the strain rate and temperature sensitivity of Rowanex 1100 Type 1A, a polymer-bonded explosive (PBX). The stress supported by this PBX at high rates of deformation (1750 ± 225 s−1) was found to be about an order of magnitude greater than that supported at low rates (0.015 s−1). Temperature was also found to have a large effect, with the strength of the material decreasing exponentially with temperature over the range studied (–60 to +60 °C). The exponents for the decay of the PBX’s strength with temperature at both low and high strain rates were the same within experimental error. So a temperature/strain rate shift factor could be determined and was found to be 31.2 ± 2.4 K/decade of strain rate
Cómo evitar pérdidas en el secado y en la cocción
Not availableUna vez concluido el proceso de cocción, cada ladrillo desechado representa una pérdida financiera equivalente al costo de un ladrillo de primera calidad. El término "desechado" debe abarcar también a los ladrillos defectuosos y a los de calidad inferior, en mayor o menor grado. Por ejemplo dos ladrillos de baja calidad vendidos a mitad de precio puede considerarse como un ladrillo de pérdida
Impact of in-crop and soil residual herbicides on effective nitrogen fixation in field pea (Pisum sativum L.) and chickpea (Cicer arietinum L.)
Non-Peer ReviewedA three-year project was initiated in 2004 to examine the effects of residual herbicides
and registered “in-crop” herbicides, both soil and foliar applied, on N fixation and
consequent yield of field peas and chickpeas. Inoculation strategies were examined to
determine if inoculant formulation (i.e., peat powder versus granular inoculant)
influences the degree to which herbicides can affect N fixation. This research is ongoing and thus all results are considered preliminary. Preliminary results in field pea,
suggest that where herbicides had a negative effect on N fixation, the effects occurred at relatively early growth stages (i.e., soon after herbicide application) and were typically overcome at later growth stages. In addition, granular inoculants were associated with increased N fixation as compared to peat powder inoculants, and may have mitigated any negative herbicide effects. Chickpea incurred damage from the herbicides and all treatments had significantly less N fixation than the control. In general, results suggest that N fixation may be compromised if herbicides cause significant plant damage; however, improved weed control associated with herbicide application may counter the negative impact on early N fixation
Robust Inference of Trees
This paper is concerned with the reliable inference of optimal
tree-approximations to the dependency structure of an unknown distribution
generating data. The traditional approach to the problem measures the
dependency strength between random variables by the index called mutual
information. In this paper reliability is achieved by Walley's imprecise
Dirichlet model, which generalizes Bayesian learning with Dirichlet priors.
Adopting the imprecise Dirichlet model results in posterior interval
expectation for mutual information, and in a set of plausible trees consistent
with the data. Reliable inference about the actual tree is achieved by focusing
on the substructure common to all the plausible trees. We develop an exact
algorithm that infers the substructure in time O(m^4), m being the number of
random variables. The new algorithm is applied to a set of data sampled from a
known distribution. The method is shown to reliably infer edges of the actual
tree even when the data are very scarce, unlike the traditional approach.
Finally, we provide lower and upper credibility limits for mutual information
under the imprecise Dirichlet model. These enable the previous developments to
be extended to a full inferential method for trees.Comment: 26 pages, 7 figure
Recommended from our members
The Hall–Petch and inverse Hall–Petch relations and the hardness of nanocrystalline metals
Abstract: We review some of the factors that influence the hardness of polycrystalline materials with grain sizes less than 1 µm. The fundamental physical mechanisms that govern the hardness of nanocrystalline materials are discussed. The recently proposed dislocation curvature model for grain size-dependent strengthening and the 60-year-old Hall–Petch relationship are compared. For grains less than 30 nm in size, there is evidence for a transition from dislocation-based plasticity to grain boundary sliding, rotation, or diffusion as the main mechanism responsible for hardness. The evidence surrounding the inverse Hall–Petch phenomenon is found to be inconclusive due to processing artefacts, grain growth effects, and errors associated with the conversion of hardness to yield strength in nanocrystalline materials
Recommended from our members
The Hall–Petch and inverse Hall–Petch relations and the hardness of nanocrystalline metals
Abstract: We review some of the factors that influence the hardness of polycrystalline materials with grain sizes less than 1 µm. The fundamental physical mechanisms that govern the hardness of nanocrystalline materials are discussed. The recently proposed dislocation curvature model for grain size-dependent strengthening and the 60-year-old Hall–Petch relationship are compared. For grains less than 30 nm in size, there is evidence for a transition from dislocation-based plasticity to grain boundary sliding, rotation, or diffusion as the main mechanism responsible for hardness. The evidence surrounding the inverse Hall–Petch phenomenon is found to be inconclusive due to processing artefacts, grain growth effects, and errors associated with the conversion of hardness to yield strength in nanocrystalline materials
Recommended from our members
No Association between Single-Nucleotide Polymorphisms of The S1PR1 Gene or Interleukin-17 Levels with Fingolimod Response in A Small Group of Iranian Relapsing-Remitting Multiple Sclerosis Patients: A Case-Control Study
Objective: Multiple sclerosis (MS) has a multi-factorial etiology involving genetic factors. Fingolimod (Gilenya ®, FTY720) modulates the G-protein-coupled sphingosine 1-phosphate (S1P) receptors, S1PR1, 2, 3, 4 and 5. Variation in the human S1PR1 coding sequence results in heterogeneity in the function of the receptor. Interleukin-17, producing CD4+ T cells, tends to be increased after treatment with Fingolimod. The aim of the study was to investigate single-nucleotide polymorphisms (SNPs) in the S1PR1 gene or interleukin-17 (IL-17) levels in a small group of Iranian relapsing-remitting MS patients treated with Fingolimod.
Materials and Methods: In this case-control study, the genomic DNA of 94 MS patients treated with Fingolimod was extracted and Sanger sequencing was performed on polymerase chain reaction (PCR) products to detect variants in the S1PR1 gene. Quantification of IL-17 from the serum of the patients was performed using a commercially available enzyme-linked immunosorbent assay (ELISA).
Results: Among 94 relapsing-remitting MS patients treated with Fingolimod, 69 (73.4%) were responders and 25 (26.6%) were non-responders. There were four novel and five common SNPs in the S1PR1 gene and no significant association between SNP genotype and drug response was detected. In a subset of 34 patients, there was no significant difference in IL-17 serum concentrations before or after treatment and no association with S1PR1 polymorphisms was determined.
Conclusion: This study is the first in Iran to investigate association between SNPs of the S1PR1 gene or IL-17 levels with fingolimod response in a small group of Iranian relapsing remitting MS patients. There was no association with S1PR1 gene SNPs or IL-17 levels before or after treatment
Process evaluation of integrated diabetes management at primary healthcare facilities in Pakistan: a mixed-methods study
Background: Integrated care for diabetes and associated conditions at primary level health facilities can make care available to a much larger population, especially in rural areas.
Aim: This process evaluation was to understand how the authors' integrated care was implemented and experienced by the care providers and patients, and to inform modifications prior to province-wide scale-up.
Design & setting: The mixed-method study was conducted as part of a cluster randomised trial on integrated diabetes care at 14 public health facilities.
Method: The care practices were assessed by analysing the routine clinical records of 495 registered patients with diabetes. Then semi-structured interviews with service providers and patients were used to understand their respective care experiences. A framework approach was applied to analyse and interpret the qualitative data.
Results: The intervention and the study were implemented as intended under routine conditions in rural health centres. Key service processes effectively delivered included: skill-based training; screening and diagnostic tests; treatment card records; and the additional case management as per desk guide, including monitoring progress in glucose and weight at follow-up consultations, and mobile phone calls to help adherence. However, social and cultural factors affected clients' ability to change lifestyles, especially for women. The intervention effect was limited by the short study follow-up of only 9 months.
Conclusion: Integrated diabetes care was feasible, both for providers and patients, and potentially scalable at primary care facilities under routine conditions in Pakistan. Additional operational interventions are required for sustained drug supplies, supervision, in-service training, and to address the social challenges to healthy activity and eating, especially for women
- …