5,754 research outputs found
Signal Characteristics from Electromagnetic Cascades in Ice
We investigate the development of electromagnetic cascades in ice using a
GEANT Monte Carlo simulation. We examine the Cherenkov pulse that is generated
by the charge excess that develops and propagates with the shower. This study
is important for the RICE experiment at the South Pole, as well as any test
beam experiment which seeks to measure coherent Cherenkov radiation from an
electromagnetic shower.Comment: 8 pages, 6 figure
Addendum to "Coherent radio pulses from GEANT generated electromagnetic showers in ice"
We reevaluate our published calculations of electromagnetic showers generated
by GEANT 3.21 and the radio frequency pulses they produce in ice. We are
prompted by a recent report showing that GEANT 3.21-modeled showers are
sensitive to internal settings in the electron tracking subroutine. We report
the shower and pulse characteristics obtained with different settings of GEANT
3.21 and with GEANT 4. The default setting of electron tracking in GEANT 3.21
we used in previous work speeds up the shower simulation at the cost of
information near the end of the tracks. We find that settings tracking electron
and positron to lower energy yield a more accurate calculation, a more intense
shower, and proportionately stronger radio pulses at low frequencies. At high
frequencies the relation between shower tracking algorithm and pulse spectrum
is more complex. We obtain radial distributions of shower particles and phase
distributions of pulses from 100 GeV showers that are consistent with our
published results.Comment: 4 pages, 3 figure
Nonlinear Competition Between Small and Large Hexagonal Patterns
Recent experiments by Kudrolli, Pier and Gollub on surface waves,
parametrically excited by two-frequency forcing, show a transition from a small
hexagonal standing wave pattern to a triangular ``superlattice'' pattern. We
show that generically the hexagons and the superlattice wave patterns bifurcate
simultaneously from the flat surface state as the forcing amplitude is
increased, and that the experimentally-observed transition can be described by
considering a low-dimensional bifurcation problem. A number of predictions come
out of this general analysis.Comment: 4 pages, RevTex, revised, to appear in Phys. Rev. Let
Interface Engineering to Create a Strong Spin Filter Contact to Silicon
Integrating epitaxial and ferromagnetic Europium Oxide (EuO) directly on
silicon is a perfect route to enrich silicon nanotechnology with spin filter
functionality.
To date, the inherent chemical reactivity between EuO and Si has prevented a
heteroepitaxial integration without significant contaminations of the interface
with Eu silicides and Si oxides.
We present a solution to this long-standing problem by applying two
complementary passivation techniques for the reactive EuO/Si interface:
() an hydrogen-Si passivation and () the
application of oxygen-protective Eu monolayers --- without using any additional
buffer layers.
By careful chemical depth profiling of the oxide-semiconductor interface via
hard x-ray photoemission spectroscopy, we show how to systematically minimize
both Eu silicide and Si oxide formation to the sub-monolayer regime --- and how
to ultimately interface-engineer chemically clean, heteroepitaxial and
ferromagnetic EuO/Si in order to create a strong spin filter contact to
silicon.Comment: 11 pages of scientific paper, 10 high-resolution color figures.
Supplemental information on the thermodynamic problem available (PDF).
High-resolution abstract graphic available (PNG). Original research (2016
Long term aging effect on the creep strength of the T92 steel
International audienceCreep strength loss of T92 steel after long-term creep exposure at 600°C and 650°C is partially due to a thermal aging of the steel during the first part of the test. In order to quantify the effect of long-term aging on the creep strength loss, creep tests were conducted at 600 and 650°C on T92 steel thermally aged for 10,000h at the same temperature and on as-received T92 steel. Laves phases precipitates were found after thermal aging at 600°C and 650°C with an average equivalent diameter of about 200nm and of about 350nm, respectively. No significant change in hardness and in the matrix substructure as revealed by electron backscatter diffraction occurred during aging. For stresses higher than 170MPa at 600°C and higher than 110MPa at 650°C the time to rupture is four times lower in the aged steels compared to the as-received steel, this is correlated to a secondary creep rate four times higher for the aged specimens compared to that of the as-received steel. Creep tests conducted at 650°C under lower stresses revealed a creep lifetime only twice lower after aging
Charm as a domain wall fermion in quenched lattice QCD
We report a study describing the charm quark by a domain-wall fermion (DWF)
in lattice quantum chromodynamics (QCD). Our study uses a quenched gauge
ensemble with the DBW2 rectangle-improved gauge action at a lattice cutoff of
GeV. We calculate masses of heavy-light (charmed) and
heavy-heavy (charmonium) mesons with spin-parity and ,
leptonic decay constants of the charmed pseudoscalar mesons ( and ),
and the - mixing parameter. The charm quark mass is found to be
GeV. The mass splittings in
charmed-meson parity partners and are
degenerate within statistical errors, in accord with experiment, and they
satisfy a relation , also consistent with
experiment. A C-odd axial vector charmonium state, \chi_{c1}m_{h_{c}} = 3533(11)_{\rm stat.}\chi_{c1}) mass. However, in this regard, we emphasize
significant discrepancies in the calculation of hyperfine splittings on the
lattice. The leptonic decay constants of and mesons are found to be
MeV and
,
where the first error is statistical, the second a systematic due to chiral
extrapolation and the third error combination of other known systematics. The
- mixing bag parameter, which enters the
transition amplitude, is found to be .Comment: 49 pages, 15 figure
- …