Ophthalmic drug delivery system based on the complex of gellan and ofloxacin

Complex formation between a natural polysaccharide – gellan and an antimicrobial drug – ofloxacin was studied in aqueous solution. Conductimetric and potentiometric titration curves revealed that gellan and ofloxacin forms a water-soluble complex of composition 2:1 mol/mol stabilized by ionic and hydrogen bonds. The formation of the gellan-ofloxacin complex was confirmed by FTIR spectroscopy, dynamic light scattering, zeta-potential and thermogravimetric analysis. The average hydrodynamic size of the complex was found 307±5 nm and its zetapotential was negative and equal to -15 mV. Thin films of the gellan-ofloxacin complex, gelled in 0.3 wt.% of CaCl2, were used to study the release kinetics of ofloxacin in distilled water and phosphate buffer. The drug release kinetics evaluated by UV-Vis spectroscopy at λmax = 289 nm and calculated by the Ritger-Peppas model correspond to non-Fickian diffusion in distilled water and Case II transport (zero-order kinetics) in phosphate buffer. The cumulative release of ofloxacin from the gellan-ofloxacin films was equal to 96±2% and 36±2% in phosphate buffer and distilled water, respectively. It is expected that the gellan-ofloxacin complex is able to form in situ gel on the surface of the eye and to prolong the drug residence time in the tear fluid.Peer reviewe

Poly(2-ethyl-2-oxazoline) grafted gellan gum for potential application in transmucosal drug delivery

Gellan gum (GG) has been used to prepare polymeric carriers with prolonged retention on the eye surface for topical ocular drug delivery. In this work, GG was chemically modified with short poly(2-ethyl-2-oxazoline) (PEtOx) chains that were expected to have minimal adhesion to mucosal tissues (mucoadhesion). The choice of synthetic procedure, solvents, and reagents has been dictated by biocompatibility of the materials and possible application in drug delivery. The grafts were synthesized via cationic ring-opening polymerization and their living chains were attached onto deprotonated gellan backbone. The derivatives with three degrees of grafting were prepared by varying the in-feed mass ratio of PEtOx grafts over GG. NMR and FT-IR spectroscopies, thermogravimetric analysis, and SEC evidenced that the grafting had actually taken place. However, a greater diffusion coefficient determined for the copolymer, using diffusion-ordered spectroscopy (NMR), in relation to the diffusion of the unmodified GG, suggested either partial degradation of the backbone or a more compact structure of the copolymer. GG and its graft copolymers (GG-g-PEtOx) were found to be highly biocompatible with cells cultured under their induction at concentration of 1, 0.1 and 0.01 mg/mL demonstrated a physiological morphology, as well as an increase in viability and proliferation.Peer reviewe

Hydrophobically Modified Sulfobetaine Copolymers with Tunable Aqueous UCST through Postpolymerization Modification of Poly(pentafluorophenyl acrylate)

Polysulfobetaines, polymers carrying highly polar zwitterionic side chains, present a promising research field by virtue of their antifouling properties, hemocompatibility, and stimulus-responsive behavior. However, limited synthetic approaches exist to produce sulfobetaine copolymers comprising hydrophobic components. Postpolymerization modification of an activated ester precursor, poly(pentafluorophenyl acrylate), employing a zwitterionic amine, 3-((3-aminopropyl)dimethylammonio)propane-1-sulfonate, ADPS, is presented as a novel, one-step synthetic concept toward sulfobetaine (co)polymers. Modifications were performed in homogeneous solution using propylene carbonate as solvent with mixtures of ADPS and pentylamine, benzylamine, and dodecylamine producing a series of well-defined statistical acrylamido sulfobetaine copolymers containing hydrophobic pentyl, benzyl, or dodecylacrylamide comonomers with well-controllable molar composition as evidenced by NMR and FT-IR spectroscopy and size exclusion chromatography.This synthetic strategy was exploited to investigate, for the first time, the influence of hydrophobic modification on the upper critical solution temperature (UCST) of sulfobetaine copolymers in aqueous solution. Surprisingly, incorporation of pentyl groups was found to increase solubility over a wide composition range, whereas benzyl groups decreased solubility—an effect attributed to different entropic and enthalpic contributions of both functional groups. While UCST transitions of polysulfobetaines are typically limited to higher molar mass samples, incorporation of 0–65 mol % of benzyl groups into copolymers with molar masses of 25.5–34.5 kg/mol enabled sharp, reversible transitions from 6 to 82 °C in solutions containing up to 76 mM NaCl, as observed by optical transmittance and dynamic light scattering. Both synthesis and systematic UCST increase of sulfobetaine copolymers presented here are expected to expand the scope and applicability of these smart materials

Ophthalmic drug delivery system based on the complex of gellan and ofloxacin

Complex formation between a natural polysaccharide – gellan and an antimicrobial drug – ofloxacin was studied in aqueous solution. Conductimetric and potentiometric titration curves revealed that gellan and ofloxacin forms a water-soluble complex of composition 2:1 mol/mol stabilized by ionic and hydrogen bonds. The formation of the gellan-ofloxacin complex was confirmed by FTIR spectroscopy, dynamic light scattering, zeta-potential and thermogravimetric analysis. The average hydrodynamic size of the complex was found 307±5 nm and its zetapotential was negative and equal to -15 mV. Thin films of the gellan-ofloxacin complex, gelled in 0.3 wt.% of CaCl2, were used to study the release kinetics of ofloxacin in distilled water and phosphate buffer. The drug release kinetics evaluated by UV-Vis spectroscopy at λmax = 289 nm and calculated by the Ritger-Peppas model correspond to non-Fickian diffusion in distilled water and Case II transport (zero-order kinetics) in phosphate buffer. The cumulative release of ofloxacin from the gellan-ofloxacin films was equal to 96±2% and 36±2% in phosphate buffer and distilled water, respectively. It is expected that the gellan-ofloxacin complex is able to form in situ gel on the surface of the eye and to prolong the drug residence time in the tear fluid.Peer reviewe

Effect of partial quaternization on the aqueous solution properties of tertiary amine-based polymeric surfactants: Unexpected separation of surface activity and cloud point behavior

Low degrees of Me iodide quaternization eliminates the LCST behavior of 2-(Dimethylamino)ethyl methacrylate-2-(diethylamino)ethyl methacrylate diblock copolymers (DMA-DEA) and significantly extends the pH (and temp.) range for colloidally stable micelles. Similar results were previously reported for fully quaternized DMA-DEA diblock copolymers, but these latter materials are poor surfactants since unfavorable electrostatic interactions lead to poor packing efficiencies at the air-water interface. In contrast, in the present study lightly quaternized diblock copolymers exhibit similar surface activities to the un-quaternized diblock copolymer precursor; thus, judicious control of the degree of quaternization unexpectedly allows fine-tuning and optimization of the aq. soln. properties of these new cationic polymeric surfactants. on SciFinder (R

Mineralized self-assembled peptides on 3D laser-made scaffolds: a new route toward 'scaffold on scaffold' hard tissue engineering

In this study, we propose a new approach to hard tissue regeneration based on the mineralization of 3D scaffolds made using lasers. To this end, we report the rational design of aspartate-containing self-assembling peptides targeted for calcium binding. We further investigate the suitability of these peptides to support cell attachment and proliferation when coupled on a hybrid organic-inorganic structurable material, and evaluate the response of pre-osteoblastic cells on functionalized 3D scaffolds and material surfaces. Our results show that the mineralized peptide, when immobilized on a hybrid photo-structurable material strongly supports cell adhesion, a proliferation increase after three and seven days in culture, and exhibits a statistically significant increase of biomineralization. We propose this strategy as a 'scaffold on scaffold' approach for hard tissue regeneration