Coupling of the lattice and superlattice deformations and hysteresis in thermal expansion for the quasi one-dimensional conductor TaS3_3

An original interferometer-based setup for measurements of length of needle-like samples is developed, and thermal expansion of o-TaS$_3$ crystals is studied. Below the Peierls transition the temperature hysteresis of length $L$ is observed, the width of the hysteresis loop $\delta L/L$ being up to $5 \cdot 10^{-5}$. The behavior of the loop is anomalous: the length changes so that it is in front of its equilibrium value. The hysteresis loop couples with that of conductivity. The sign and the value of the length hysteresis are consistent with the strain dependence of the charge-density waves (CDW) wave vector. With lowering temperature down to 100 K the CDW elastic modulus grows achieving a value comparable with the lattice Young modulus. Our results could be helpful in consideration of different systems with intrinsic superstructures.Comment: 4 pages, 3 figures. Phys. Rev. Lett., accepted for publicatio

A millimeter-wave inflatable frequency-agile elastomeric antenna

This letter reports a millimeter-wave frequency agile microstrip antenna printed on an ultrasoft elastomeric PDMS substrate. The microstrip patch antenna is supported by a PDMS membrane suspended over an air cavity. The distance H between the patch and the ground plane, and thus the resonant frequency of the antenna, are tuned using pneumatic actuation, taking advantage of the extreme softness of the PDMS membrane. A continuous frequency shift varying from 55.35 to 51 GHz ( ≈8%) has been obtained for a tuning range of H between 200µm and 575µm. In all configurations, the antenna remains matched and its radiation characteristics are very satisfactory

A millimeter-wave microstrip antenna array on ultra-flexible micromachined polydimethylsiloxane (PDMS) polymer

The use of Polydimethylsiloxane (PDMS), an ultra flexible polymer, as a substrate for the realization of reconfigurable microwave devices in the 60-GHz band is presented. As bulk PDMS is demonstrated to be lossy at millimeter waves, membrane-supported devices are considered. A new reliable and robust technological process has been developped to micromachine membrane-supported transmission lines and microstrip antenna arrays. It is shown that transmission lines printed on 20-µm thick membranes exhibit similar performances as bulk substrates commonly used at millimeter-wave frequencies. A microstrip antenna array has been also designed and fabricated to demonstrate the feasibility of directive antennas supported by large membranes. Promising applications for mechanical beam-steering, beam forming and frequency tunable antennas are expected

Elaboration of a Novel Design Pirani Pressure Sensor for High Dynamic Range Operation and Fast Response Time

AbstractWe report a novel design for realizing Pirani sensor with a working range from a 1kPa up to pressure over than atmospheric one. The sensor is specifically designed to achieve high sensitivity, fast response time and high robustness. The proof of concept is composed of four metallic resistors interconnected to form a Wheatstone bridge. Two of them act simultaneously as the heating and sensing elements and the two others are used as a temperature reference. The heating element consists of a metallic wire of platinum Pt (3μm width, 1mm length) maintained on each lateral side by periodic silicon oxide SiO2 micro-bridges. The sensor design, fabrication technologies, electrical characterizations and voltage-pressure responses are described and shown. A future perspective is given, which describe the extension of this concept to elastic wave transduction of pressure using a combination of heater element and thin plate elastic waveguide

Current State of Knee Arthroplasty in Russia: Analysis of 36,350 Сases from the Register of the Vreden National Medical Research Center of Traumatology and Orthopedics

Background.Nowadays the knee arthroplasty register of the Vreden National Medical Research Center of Traumatology and Orthopedics (hereinafter referred to as the Vreden Center) contains clinical and statistical data on more than 39,000 primary and revision knee replacements, that mimics current state of this kind of surgery in Russia. Aimofthestudy to analyze the last decade trends in primary knee arthroplasty in largest Russian arthroplasty center. Methods.Data were obtained from the register of the Vreden Center for the period from 2011 to 2022. Information on knee arthroplasty included epidemiologic and numerous peri-operative data including type of surgery and implant, degree of constrain, primary patella resurfacing etc. Resultsanddiscussion.From 2011 to 2022, 36,350 (92.3%) primary arthroplasties performed at the Vreden Center. The number of interventions increased more than twice: from 1,678 in 2011 to 3,924 in 2022. Similar trends observed in Australia and Sweden, where the number of knee arthroplasties increased by 8.2% and 8% in 2021 compared to 2020, respectively. The frequency of primary patellar resurfacing at the Vreden Center was 2.2% over the entire period of observation. On the contrary, the rate of patella replacement increased from 41% in 2005 to 76.1% in 2021 in Australia and from 24.4% in 2015 to 31.9% in 2020 in Switzerland. The partial knee arthroplasty showed enormous growth more than 14 times: from 0.3% in 2011 to 4.3% in 2022 at the Vreden Center. Worldwide unicompartmental knee replacement is still less popular than total and its number widely varies: 4.2% in the USA, 6.9% in Australia, 9.2% in Canada, 11.9% in Norway, 12.8% in Sweden, and 18.4% in Switzerland. Posterior cruciate ligament (PCL) retaining total knee arthroplasties (TKA) prevailed at the Vreden Center: 68.3%, while in other countries it utilize even more widely: 70.5% in Norway, 75% in New Zealand and 93.5% in Sweden. The total length of hospital stay (LOS) decreased dramatically from 19.6 in 2011 to 8.6 in 2022 at the Vreden Center. Nevertheless, there are still opportunities to improve it: by the way in Canada the average LOS for TKA is 2.3 and the USA 0.8 and 1.7 for partial and total arthroplasty, respectively. Conclusion.The main current trends of knee arthroplasty in Russia are the following: increase the number of surgeries, reduced LOS, TKA without patella resurfacing and with PCL retention, finally the growth of partial knee arthroplasties

ЗАВИСИМОСТЬ ДЕФОРМАЦИОННОГО СОСТОЯНИЯ ПЛЕНОК GaAs НА ВИЦИНАЛЬНЫХ ПОДЛОЖКАХ Si(001) ОТ СПОСОБА ФОРМИРОВАНИЯ ПЕРВЫХ МОНОСЛОЕВ ПРОСЛОЙКИ GaP

A significant dependence of the strain state of GaAs film lattice grown by molecular−beam epitaxy (MBE) on the nucleation method of early GaP buffer layers (50 nm) on the vicinal substrate Si(001) 4° around the <011> axis was discovered. GaP growth started layer−by−layer with a gallium or a phosphorus sublayer. If GaP nucleated with a gallium sublayer, the GaAs film has a significant lattice rotation around the <011> axis. If the buffer starts forming with a phosphorus layer the GaAs film evidently rotates around the <001> axis. The film relaxation degree ex- ceeds 100%, and the film is in a laterally strained state. Analysis was carried out using the triclinic distortion model. A reciprocal space scattering map was obtained using X−ray diffraction in a three−axis low resolution setup. The map clearly shows that the GaAs film lattice is rotated.Выявлена существенная зависимость деформационного состояния кристаллической решетки пленок GaAs, выращенных методом молекулярнолучевой эпитаксии от способа зарождения первых слоев прослойки GaP (50 нм) на вицинальной подложке Si(001) 4° вокруг оси <011>. Рост GaP начинался послойно с галлиевого или фосфорного подслоя. Установлено, что в случае зарождения GaP с галлия, пленка GaAs имеет значительный поворот кристаллической решетки вокруг направления <011>. При фор- мировании прослойки с фосфорного подслоя заметен поворот пленки GaAs вокруг <001>. Степень релаксации пленки составляет более 100 %, она находится в латерально растянутом состоянии. Анализ проведен с использованием модели триклинных искажений. Представлена карта рассеяния в обратном пространстве, полученная с помощью рентгеновской дифрактометрии в трехосевой схеме малого разрешения. На карте явно виден факт поворота кристаллической решетки пленки GaAs.

Measurements and Instrumentation in Heat Engineering : vol. II

342 tr. ; 22 cm

Measurements and Instrumentation in Heat Engineering : vol. I

352 tr. ; 22 cm

Explosive Instability of Gravity-Capillary Waves under Ultrasound Radiation Pressure

International audienc